Hotpoint OFNAA305 Instructions For Use Manual

GB

CHEST FREEZER

FZ 102 P.1/HA
FZ 102 P.1 IX/HA
FZ 1022 P.1/HA
FZ 1022 P.1 IX/HA
FZ 1022 P.1 F/HA
FZ 1022 P.1 IX F/HA
FZ 102 P.1 F/HA
FZ 102 P.1 IX F/HA

Contents

Before using the appliance, 2

Product description, 3

Installation, 4

Freezing Food, 5

Food storage, 6

Precautions and general
recommendations, 7

Defrosting the appliance, 8

Care and Maintenance, 9

Troubleshooting guide, 10

Safeguarding the environment, 11

Assistance, 12

English,1

GB

Instrucions for use

2

GB

Your new appliance is designed exclusively for
domestic use and for storing frozen food, freezing
fresh food and making ice cubes.

Regulations require that the appliance is earthed.
The manufacturer declines all liability for injury to
persons or animals and for damage to property
resulting from failure to observe the above
procedures and reminders.

1. After unpacking, make sure that the appliance is
undamaged and that the lid closes perfectly tight.
Any damage must be reported to your dealer
within 24 hours after delivery of the appliance.

2. Wait at least two hours before switching the
appliance on in order to ensure the refrigerant
circuit is fully efficient.

3. Installation of the appliance and electrical
connections must be carried out by a qualified
electrician, in accordance with the manufacturer's
instructions and local safety regulations.

4. Clean the inside of the appliance before using it.

• Before connecting the appliance to the mains

supply, ensure that the voltage corresponds to
that given on the rating plate located on the
rear of the appliance.

• Electrical connections must be made in

accordance with local regulations.

Before using
the appliance

GB

3

1. Lid handle.

2. Lock (if provided).

3. Seal.

4. Defrost water drain plug (depending on model).

5. Control panel.

6. Basket (depending on model).

7. Condenser (located at the rear).

1. Thermostat: Temperature adjustment.

2. Red LED (if provided): indicates that the
appliance temperature is not sufficiently low.

3. Green LED (if provided): indicates that the
appliance is on.

4. Yellow LED (if provided): indicates that the fast
freeze function is active.

5. Fast freeze button (if provided): press to
activate the fast freeze function.

Climatic Classe Amb. T. (°C) Amb. T. (°F)

SN From 10 to 32 From 50 to 90

N From 16 to 32 From 61 to 90

ST From 16 to 38 From 61 to 100

T From 16 to 43 From 61 to 110

Product description

4

GB

Installation

• Refer to chapter "Before using the appliance".

• Unpack the appliance.

• Remove the 4 protection pieces inserted between

lid and appliance.

• Warning: two of the four protection pieces must
be fitted in the seat of the condenser plastic
supports, located at the rear of the product. This
is necessary to ensure the correct distance from
the wall.

• Ensure that the defrosting water drainage plug (if
provided) is correctly positioned (4).

• For best operation of the appliance and in order to
avoid damage when the lid is opened, leave a
space of at least 7 cm from the rear wall and 7 cm
at the sides.

• Fit the accessories (if provided).

Switching on the appliance

• The appliance is factory set for optimum operation
at a temperature of -18°C.

• Plug in the appliance.

• The green LED lights up (if provided).

• Also the red LED (if provided) will switch on

because the temperature inside the appliance is
not yet sufficiently low for food storage. The red
LED will normally switch off within the first six
hours after the appliance is switched on.

• After connecting the appliance to the mains
supply and when the optimal temperature has
been reached (this phase takes about 1 hour
during which the lid will not open), ensure that
the fast freeze button is not pressed (the yellow
LED, if provided, is off).

• Place food inside the product only when the red
LED (if provided) has switched off.

• Thanks to the efficient lid seal, the appliance lid
will not re-open easily immediately after closing.
Wait a few minutes before re-opening the lid of
the appliance.

Temperature Adjustment

Use the thermostat to select the ideal storage
temperature.
To adjust the internal temperature, proceed as
follows:

• Turn the thermostat knob to 1 for a storage
temperature that is less cold.

• Turn the thermostat knob to 6 /

for a colder

storage temperature.

• When the appliance is only partially full, it is
advisable to set the thermostat to lower positions
(towards "E", if indicated on the thermostat scale).