HOTPOINT DK 14 X UK User Manual
Operating Instructions
Contents
Installation, 2-4
GB
English,1
DK 14 X UK
Positioning
Electrical connection
Data plate
Description of the appliance, 5
Overall view
Start-up and use, 6
Precautions and tips, 7
General safety
Disposal
Care and maintenance, 8
Switching the appliance off
Cleaning the appliance
Troubleshooting, 9
OVEN
GB
After sales support, 10
Guarantee, 11
1
08448 24 24 24
Please phone us on
guarantee
to activate your
Installation
GB
Before operating your new appliance please read
this instruction booklet carefully. It contains
important information concerning the safe operation,
installation and maintenance of the appliance.
! Please keep these operating instructions for future
reference. Make sure that the instructions are kept
with the appliance if it is sold, given away or moved.
Positioning
! Keep all packaging material out of the reach of
children. It may present a choking or suffocation
hazard (see Precautions and tips).
! The appliance must be installed by a qualified
person in compliance with the instructions provided.
Incorrect installation may cause harm to people and
animals or may damage property.
! A set of spacers is included in the packaging; this
can be used to achieve optimal alignment between
the drawer and the appliances with which it can be
combined during installation.
For further information regarding installation, please
read the technical documentation supplied with the
appliance.
current electrical regulations (the earthing wire must not
be interrupted by the circuit-breaker). The supply cable
must be positioned so that it does not come into
contact with temperatures higher than 50°C at any point.
! The installer must ensure that the correct electrical
connection has been made and that it is fully
compliant with safety regulations.
Before connecting the appliance to the power
supply, make sure that:
• The appliance is earthed and the plug is compliant
with the law.
• The socket can withstand the maximum power of
the appliance, which is indicated on the data
plate (see below).
• The voltage is in the range between the values
indicated on the data plate (see below).
• The socket is compatible with the plug of the
appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it.
Do not use extension cords or multiple sockets.
! Once the appliance has been installed, the power
supply cable and the electrical socket must be
easily accessible.
! The cable must not be bent or compressed.
Oven above - drawer below (see figure)
* cupboard dimensions
1 - insert the drawer
2 - put the brackets on the drawer and secure to the
cupboard with the 3 screws
3 - open the drawer and place the oven on the
brackets
4 - align oven and drawer and secure the oven using
the screws provided
5 - secure the drawer to the cupboard
Electrical connection
! The compartment fitted with a three-pole power
supply cable is designed to operate with an
alternating current at the voltage and frequency
indicated on the data plate located on the appliance
(see below).
Connecting the supply cable to the mains
The appliance must be directly connected to the mains
using an omnipolar circuit-breaker with a minimum
contact opening of 3 mm installed between the
appliance and the mains. The circuit-breaker must be
suitable for the charge indicated and must comply with
TABLE OF CHARACTERISTICS
width 50.5 cm
Dimensions
height 7.29 cm
depth 45.5 cm
Volume 16.5 l
Maximum
capacity
Electrical
connections
20 kg
voltage at 230-240V~
50/60Hz maximum power
absorbed 85 W
This appliance conforms to
the following European
Economic Community
directives:
2006/95/EEC dated
12/12/06 ( Low Voltage) and
subsequent amendments;
2004/108/EEC dated
15/12/04 ( Electromagnetic
Compat ibil ity) and
subsequent amendments;
93/68/EEC dated 22/07/93
and subsequent
amendments.
2002/96/EEC and
subsequent amendments.
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
2
550
min.
580
45
560
min.
min.
min.
550
min.
580
45
560
GB
min.
min.
min.
1
2
4
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
3
5
3
GB
NOTICE
ONLY FOR INSTALLATION UNDER A MICROWAVE OVEN
USE THE TWO
SPACERS UNDER
THE DRAW ER FRAME
ONLY FOR INSTALLATION UNDER A COFFEE MAKER
FIX THE BLACK SPONGE-TAPE
BEHIND THE FRAME OF THE
COFFEE MAKER
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
4
Loading...