Hotpoint CTA13, CTA15 Use And Care Manual

/
Howtogetlour
the best from
Conknk
Appliance Registration
2
Problem Solver
Care and Cleaning
10
Repair Service
15
Defrost Water Pan
10
Safety Instructions
3
Defrosting
9
Shelves
7
Energy Saver Switch
5
Temperature Controls
5
Energy-Saving Tips
2
Vacation & Moving Tips
11
Food Storage Suggestions
6
Warranty
Back Cover
Storage Drawer
7
Storage Times
6
Ice Trays
8
Installation
3,4
Adapter Plug
4
Clearances
4
Electrical Requirements 3,4 Extension Cord
4
Grounding
3
Leveling Legs
4
Location
4
Light Bulb Replacement
11
Model
and
Serial Numbers
2
Jse
and Care of
models
~A13 ~A15
~— ~
m
‘-
~
me
GE Answer Center@
800.626.2000
Help us help you...
Ene~y-saving
tips
Read this book carefully.
It is intended to help you operate and maintain your new refrigerator properly.
Keep it handy for answers to your questions.
If you don’t understand something or need more help, write (include your phone number):
Consumer Affairs
Hotpoint
Appliance Park Louisville. KY 40225
Write down the model and serial numbers.
You’ll see them on a label inside
the fresh food compartment on the upper left side near the back.
These numbers are also on the Consumer Product Ownership
Registratioil
Card that came with
your refrigerator. Before sending in the registration
card,
please
write these numbers
here:
Model Number
Serial Number
Use these model and serial numbers in any correspondence service calls concerning your
refri~rator.
If you received a damaged refrigerator,
immediately contact the dealer (or builder) that sold you the refrigerator.
Save time and money. Before you request service,
check
the Problem Solver on pages 12 and
13. It lists causes of minor operating problems that you can correct yourself.
Location of your refrigerator is
important. Avoid locating it next to your range, a heating vent or where the sun will shine directly on it.
Don’t open the doors more often
than necessary.
. Close the doors as soon as possible, particularly in hot, humid weather.
Defrost the freezer compartment
whenever frost becomes 1/4” thick.
Keep Energy Saver Switch in the
left position unless moisture
fc~rms
on the outside of the refrigerator.
c
Be sure the doors are closed tightly. Before leaving the house or retiring for the night, check to be sure the doors haven’t been
left
open accidentally.
s
Store only those foods requiring
refrigeration in your refrigerator. . Wipe moisture from bottles
and
cartons before putting them in the
refrigerator.
Keep foods covered to reduce moisture buildup inside the refrigerator.
If you turn the temperature
control to the coldest position for quick chilling or freezing, be sure to turn it back to regular setting to
prevent freezing fresh
foods.
Don’t overcrowd your refrigerator. Overcrowding can require extra
electrical energy to keep everything
cool .
2
Important Safety Instructions
lead dl
instructions before using
tMs
appliance.
WMNING–When
using
this
appliance, always exercise
Fasic
safety precautions, including the following:
Use this appliance
ody
for its
intended purpose as described in
this Use and Care Book.
This
refrigerator must be properly
instaBed
in accordance with the Installation Instructions before it is used. See grounding instructions
below and on page 4.
Never unplug your refrigerator by
palling on the power cord. Nways
grip plug
fitiy
and pull straight
out from the outlet.
Repair or replace immediately
dl
electric service cords that have become frayed or otherwise dam­aged. Do not use a cord that shows
-racks or abrasion damage along
.s length or at either the plug or
connector end.
After your refrigerator is in operation, do not touch the cold surfaces, partictiarly when hands are damp or wet. Skin may adhere
to these extremely cold surfaces.
How to connect electricity
For personal safety,
tfis
appliance must be
properly grounded.
The power cord of this appliance is equipped with a three-prong (grounding) plug which mates with
hn’t
refreeze frozen foods which
have thawed completely.
The United States Department of Agriculture in Home and Garden Bulletin No. 69 says:
‘!. .You
may safely refreeze frozen foods that have thawed if they still contain ice crystals or if they are still cold—below
@°F.
‘!.
.Thawed ground meats, poultry,
or fish that have
any off-odor or
off-color should not be refrozen and should not be eaten. Thawed ice cream should be discarded. If the odor or color of any food is poor or questionable, get rid of it. The food may be dangerous to eat.
“Even partial thawing and refreez­ing reduce the eating quality of foods, particularly fruits, vegeta­bles, and prepared foods. The eating quality of red meats is affected less than that of many other foods. Use refrozen foods as soon as possible to save as much of their eating quality as you
can;’
Installation Requirements
–I~ORTANT...
Please Read Carefully
I
PREFERRED , METHOD
m
Q
Q
9
%
,0
7
.Y)
INSURE PROPER
Fig. 1
/y
GiOUND
EtiSTS
BEFORE USE
;tandard three-prong (grounding)
.tiall
outlet (Fig. 1) to minimize the
Have the
wall
outlet and circuit
possibility of electric shock hazard
checked by a qualified electrician
from this appliance.
to make sure the outlet is properly
grounded.
3
If your old refrigerator is
stfll
around the house but not in use, be sure to remove the doors. This will
reduce the possibility of danger to children.
Unplug your refrigerator:
A. Before making any repairs.
Note: We strongly recommend that any servicing be performed by a qualified individual.
B. Before cleaning.
C. Before replacing a burned-out light bulb, the refrigerator should be unplugged in order to avoid contact with a live wire filament. (A burned-out light bulb may break when being replaced.)
Note: Turning temperature control
to “O” position does not remove
power to the light circuit.
Do
not operate your refrigerator
in the presence of explosive fumes.
SAW
T~SE
~STRUCTIONS
Where a standard two-prong
wall
outlet is encountered, it is your per­sonal responsibility and obligation to have it replaced with a properly
grounded three-prong wall outlet.
DO NOT, UNDER N CIRCUM-
STANCES,
CUT
OR
WMOW
T~ ~RD
(GROUND) PRONG
PROM
T~ POWER
CORD.
(continued next page)
Installation Requirements
(continued)
–I~ORTANT.. .Please
Read Carefully
Use of adapter plug
Because of potential safety
hazards under certain conditions, we strongly recommend against use
of
an adapter plug. However, if you
still
elect to use an adapter, where
local codes permit, a
TE~ORARY
CONNECTION may be made to a properly grounded two-prong wall outlet by use of a
UL listed adapter
(Fig. 2) available
at most
]ocal
hardware stores.
TEMPORARY METHOD
(ADAPTER PLUGS NOT PERMITTED IN CANADA)
The larger slot in the adapter must be aligned with the larger slot in the wall outlet to provide proper polarity in the connection of the power cord.
CAUTfON: Attaching adapter
ground terminal to wall outlet cover screw does not ground the appliance unless cover screw is
metal, and not insulated, and wall outlet is grounded through house wiring. You should have the circuit checked by a qualified electrician to make sure the outlet is properly grounded.
When disconnecting the power cord from the adapter,
always hold the adapter with one hand. If this is not done, the adapter ground terminal is very likely to break with repeated use.
Shotid
the adapter ground terminal break, DO NOT USE the appliance
until
a proper ground has again been
established.
Use of extension cords
Because of potential safety hazards under certain conditions, we strongly recommend against the use of an extension cord. However, if you still elect to use an extension cord, it is absolutely necessary that it be a
UL listed 3-wire grounding
type appliance extension cord hav­ing a grounding type plug and outlet and that the electrical rating of the cord be 15 amperes (minimum) and 120 volts. Such extension cords
are obtainable through your local service organization.
The refrigerator should always be–plugged into its own individual electrical
outlet—
(115 volt, W Hertz, single phase AC). This is recommended for best performance and to prevent over­loading house wiring circuits, which could cause a possible fire hazard from overheating wires.
Refrigerator hstallation
Location
Do not install refrigerator where temperature will go below
@°F.
because it will not run often enough to maintain proper temperatures.
Do install it on a floor strong enough to support a ftily
loaded
refrigerator.
Also see Energy-Saving Tips regarding location.
Clearances
Mlow
the following clearances for ease of instigation and proper air circulation:
Wnged
side
__-1-l/2°
Other
side_____5/8°
Top-- __--
_---_-2°
Back----_---_--l”
Leveling Legs
Adjustable legs at the front corners
of the refrigerator should be set so the refrigerator is firmly positioned on floor and the front is raised just enough that the door closes easily when opened about halfway.
Turn leveling legs
clockwise to raise refrigerator, counterclockwise to lower
it.
When adjusting leveling legs
for proper door closure, the front leveling legs should be extended downward approximately
5/8!’
.
4
Operating Your Refrigerator
Temperature Control
Energy Saver Switch
Dial
The Energy Saver Switch is located
The temperature control dial has
on the temperature control panel.
nine
settings plus
“OJ’
To reduce the amount of electricity required to operate your refrigera­tor, be sure the stitch is pushed to the left position. This turns off
the heater in your refrigerator that prevents moisture from forming on the outside.
Use of the Energy Saver Switch can save you money. Estimated yearly
“l” is the warmest.
savings, depending on your local electric rates, are as follows:
“9” is the coldest.
~odel
Estimated
Yearly
saVln9S
Energy
~nitiallv
set the temperature control
E
Jial at
“5J’
Mter using refrigerator, adjust
temperature control to setting that is best suited to your needs.
Note: Turning temperature control
did
to “O” stops cooling in BOTH
compartments —fresh food
~
freezer.
If you turn your household
thermostat below
@“
at night
. . .
you may want to set the tem-
perature control one number colder,
as from “5” to
“6~’
Your refrigerator will perform acceptably when room temperature is as low as
55°F.,
although the freezer compartment may be a few degrees warmer than when room temperature is normal.
If the refrigerator is in a
W°F. or
>lder
room, it will not operate and
lood in the freezer compartment
will thaw and spoil.
I
I Electric Rate (Per
Kwh) lSavin~s I
I
I $.05 I $.08 I $.11
l(Appr~x)l
,
,
I
I
!
:J;]:
$3.00 $5.00 $6.00
7%
With the heater turned off, there is a chance that moisture may form on the outside of your refrigerator, especially when the weather is humid. The
hutidity
is most likely to be high in the summer, in the
early morning hours, and in homes
which are not air conditioned.
Over an extended period of time, moisture that forms on the outside may cause deterioration of the paint finish. It will be important to protect the finish by using appliance polish wax as described on page 10.
When the Energy Saver Stitch is pushed to the right,
electricity flows through the low wattage heater which warms the outside of the cab­inet and, under most conditions, prevent the forming of moisture or water droplets.
5
Loading...
+ 11 hidden pages