Operating Instructions
COOKER AND OVEN
|
|
|
|
|
|
|
|
|
Contents |
|
|
|
|
|
AU |
||
|
|
|
Warning, 2 |
|
|
|
AU |
|
|
||
|
|
|
|
|
|
|
|
|
Installation, 3 |
|
|
|
English, 1 |
|
|||
|
Positioning and levelling |
|
|||
|
|
|
|
||
|
|
|
Electrical connection |
|
|
|
|
|
Technical data |
|
|
|
|
|
Description of the appliance, 5 |
|
|
|
|
|
Overall view |
|
|
|
|
|
Control panel |
|
|
|
|
|
Start-up and use, 6 |
|
|
|
|
|
Starting the oven |
|
|
|
|
|
Using the cooking timer |
|
|
|
|
|
Cooking advice, 9 |
|
|
|
A6VMH60/ AUS |
Oven cooking advice table |
|
||
|
Using the glass ceramic hob, 10 |
|
|||
|
|
|
|
||
|
|
|
Switching the cooking zones on and off |
|
|
|
|
|
Cooking zones |
|
|
|
|
|
Precautions and tips, 11 |
|
|
|
|
|
General safety |
|
|
|
|
|
Disposal |
|
|
|
|
|
Respecting and conserving the environment |
|
|
|
|
|
Care and maintenance, 12 |
|
|
|
|
|
Switching the appliance off |
|
|
|
|
|
Cleaning the appliance |
|
|
|
|
|
Replacing the oven light bulb |
|
|
|
|
|
Cleaning the glass ceramic hob |
|
|
|
|
|
Assistance |
|
WARNING
AU WARNING: The appliance and its accessible parts become hot during use.
Care should be taken to avoid touching heating elements.
Children less than 8 years of age shall be kept away unless
continuously supervised. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
WARNING: Unattended cooking on a hob with fat or oil can be dangerous and may result in fire.
NEVER try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket.
WARNING: Danger of fire: do not store items on the cooking surfaces. WARNING: If the surface in glassceramic is cracked, switch off the appliance to avoid the possibility of electric shock.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they can scratch the surface, which may result in shattering of the glass.
The internal surfaces of the compartment (where present) may become hot.
Never use steam cleaners or pressure cleaners on the appliance.
Remove any liquid from the lid before opening it.
Do not close the glass cover (if present) when the gas burners or electric hotplates are still hot.
WARNING: Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electric shock.
! When you place the rack inside, make sure that the stop is directed upwards and in the back of the cavity .
2
Installation
!Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe installation and operation of the appliance.
!Please keep these operating instructions for future reference. Make sure that the instructions are kept with the appliance if it is sold, given away or moved.
!The appliance must be installed by a qualified professional according to the instructions provided.
!Any necessary adjustment or maintenance must be performed after the appliance has been disconnected from the electricity supply.
Positioning and levelling
!It is possible to install the appliance alongside cupboards whose height does not exceed that of the hob surface.
!This cooker should be installed directly on the floor. Do not install this cooker on an
artificial base of any kind.
!Make sure that the wall in contact with the back of the appliance is made from a non-flammable, heatresistant material (T 90°C).
!Important: Do not install this appliance adjacent to the door or other means of access to minimise the likelihood of persons using the door making contact with pans on the hob surface.
To install the appliance correctly:
•Place it in the kitchen, dining room or the bed-sit (not in the bathroom).
•If the top of the hob is higher than the cupboards, the appliance must be installed at least 200 mm away from them.
HOOD
|
Min. 600mm. |
min. 650 mm. with hood min. 700 mm. without hood |
Min. 420mm. |
Min. 420mm. |
• If the cooker is installed underneath a wall cabinet, there must be a minimum distance of 420 mm between this cabinet and the top of the hob.
This distance should be increased to 700 mm if the wall cabinets are flammable (see figure).
•Do not position blinds behind the cooker or less than 200 mm away from its sides.
•Any hoods must be installed according to the instructions listed in the relevant operating manual.
|
|
|
Levelling |
|
|
|
|
If it is necessary to level the |
AU |
|
|
|
|
|
|
|
|
appliance, screw the |
|
|
|
|
adjustable feet* into the places |
|
|
|
|
provided on each corner of the |
|
|
|
|
base of the cooker (see figure). |
|
|
|
|
The legs* provided with the |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
appliance fit into the slots on |
|
|
|
|
the underside of the base of |
|
|
|
|
the cooker. |
|
|
|
|
|
|
Electrical connection |
|
|||
Ovens with a three-pole power supply cable are |
|
|||
designed to operate with alternated current at the |
|
|||
supply frequency and voltage indicated on the data |
|
|||
plate (at the bottom of the oven dashboard). The |
|
|||
earthing conductor of the cable is the yellow-green |
|
|||
conductor. |
|
Opening the terminal board:
• Using a screwdriver, prise on the side tabs of the
terminal board cover;
• Pull open the cover of the terminal board.
To install the cable, proceed as follows:
|
• Remove the wire clamp |
|
screw and the three contact |
|
screws L-N- |
|
• Fasten the wires beneath |
|
the heads of the screws using |
|
the following color scheme : |
N L |
Blue (N) Brown (L) Yellow- |
|
Green |
•Fasten the supply cable in place with the clamp and close the cover of the terminal board.
Connecting the supply cable to the mains
WARNINGS: THIS APPLIANCE MUST BE EARTHED.
! The cooker must be connected to the mains by a switched (double pole) cooker outlet correctly fused with a capacity appropriate to that shown on the cooker Rating Plate. All electrical wiring from the consumer unit to the cooker, via the switched double
pole cooker outlet, must be of an acceptable type and current rating as above.
! the supply cable must be positioned so that it
3
never reaches at any point a temperature 50°C AU higher than the room temperature. The cable must
be routed away from the rear vents.
HOT PARTS
! The manufacturer declines any liability should these safety measures not be observed.
We recommend cleaning the oven before using it for the first time, following the instructions provided in the "Care and maintenance" section.
Anti-tilt Wall Bracket
! In order to prevent accidental tipping of the appliance, for example by a child climbing onto the oven door, the supplied "antitilt bracket" MUST be installed!
To install the Anti-Tilt Wall Bracket:
1.Fit the cooker between the cabinets and adjust the height of the appliance (if necessary) by means of adjustable feet.
2.Take out the lower compartment.
3.On the wall behind the cooker draw a line along the horizontal edge A and then along the vertical edge B so that the lines cross (see figures below).
4. Pull the cooker out of the space between cabinets and attach the Anti-tilt Bracket with (its shorter arm to the wall) in the position shown in the picture below:
37 mm left and 5 mm up from the crossing of the lines
A and B, inserting two bolts of 6mm diameter in the holes: x and y.
x |
y |
5.Place the cooker back between the cabinets so that the Anti-Tilt Wall Bracket fits inside the appliance.
6.Reinsert the lower compartment.
! The Anti-Tilt Wall Bracket may be installed both on the left and on the right handside of the cooker.
4
Description of the appliance
|
|
|
|
|
|
Overall view |
|
AU |
|
|
|
Glass ceramic hob
Control panel |
|
|
|
|
|
|
|
|
|
|
|
|
|
GUIDE RAILS |
|
|
|
|
|
|
|
|
|
|
|
|
|
for the sliding racks |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
GRILL rack |
|
|
|
|
|
|
|
|
|
|
|
position 5 |
||
|
|
|
|
|
|
|
|
|
|
|
||||
DRIPPING pan |
|
|
|
|
|
|
|
|
|
|
|
|
position 4 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|||
|
|
|
|
|
|
|
|
|
|
position 3 |
||||
|
|
|
|
|
|
|
|
|
||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
position 2 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Adjustable foot |
|
|
|
|
|
|
|
|
|
|
|
position 1 |
||
|
|
|
|
|
|
|
|
|
|
|
||||
|
|
|
|
|
|
|
|
Adjustable foot |
||||||
|
|
|
|
|
|
|
||||||||
|
|
|
|
|
|
|
|
|
|
|
||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Control panel
ACTIVE HOTPLATE
indicator light
THERMOSTAT indicator light
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
SELECTOR |
THERMOSTAT |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Electronic programmer |
|
|
|
|
|
|||||||||
knob |
|
|
|
|
|
||||||||||
knob |
|
|
|
|
|
|
|
|
|
|
|
|
ELECTRIC HOTPLATE |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
control knobs |
|
5