Hopkins CWL623 User Manual

CWL623 OWNER’S MANUAL

BLAZER-INTERNATIONAL.COM

1-800-241-3808

Overview

This product is a professional wire management system that is linked to your
smartphone. The WMS is designed for operating accessories (including lights, horns,
warning beacons, etc.) typically used on work or off-road vehicles (trucks, jeeps,
ATV/UTV, boats, heavy equipment, farm equipment, etc.).
The unit works on 12V DC and provides output to four terminals which are protected
by a 40A fuse.

Please note that before you can operate this system, you need to download and install
BLAZER LINK app for your smartphone.

Installation

Main Unit

1. Please read these instructions carefully before installing this product. It is
recommended to consult a professional installer to prevent damage to vehicle
and/or system.

2. Do not connect to 24V DC or higher voltage system, as this product is designed for
a 12V DC battery system. In case you have a larger than 12V DC system, check
vehicle owner’s manual to determine if a 12V DC output is available and how to
connect in order to use it safely, otherwise, the product will be damaged.

3. Find a suitable flat surface near the battery, clean the surface free of dirt and oil
and then affix the unit using provided adhesive strips and/or mounting holes.

4. Remove the 40Afuse from the holder and disconnect the vehicle battery.

5. Securely attach the positive (red) cable of the WMS unit to the positive terminal of
the battery (or battery cable) and the negative (black) cable of the WMS to the
negative battery cable or chassis.

6. Attach the auxiliary lights/equipment following correct polarity on the terminals and
not exceeding the maximum amperage of the channels (amperage printed on WMS
and corresponds to amperage printed on the remote control for each terminal).
See FIG 1

7. Reconnect battery cables.

8. Insert the 40Afuse back into its holders and snap the cover closed.

Page 1 of 06

CWL623 OWNER’S MANUAL

BLAZER-INTERNATIONAL.COM

1-800-241-3808

App Instructions

9. Download and install BLAZER WMS app for your smartphone operating system.
Available on app stores.

10. For initial setup, tap the "radio" icon to go to the "Connect" screen.

Simply select the module and enter the appropriate numerical password.

11. Once connected, hit the back button to return to the main screen.

12. Now, select your vehicle type by tapping on the arrow to the right of the initial

schematic.

13. Next, select Light Position setup to assign lights to different locations on your

vehicle. Tap on the terminal and then tap on the desired location. Repeat this for
the remaining terminals and then hit enter to return to the main screen.

14. You are now set up to operate your Lights.

15. Activate the system by tapping the power icon It will turn green to indicate

that it

is powered on .

.

16. Now, select a light. The light icon will turn blue to indicate it is the active selection.

17. You can turn on and off the light via the "individual Terminal ON/OFF" switch.

18. Note, terminal 2Ais used in conjunction with a warning light with different strobe

patterns built into it. Turning on and off this terminal advances the flash to the next
flash pattern. In absence of a warning light, this terminal can be used just like the
other terminals in order to power on and off lights etc..

a. Most warning lights with strobe function will have three wires. Black, red and

yellow.

Black is to be connected to negative of 18A, red to positive terminal of
18A and
manufacturer of the
circuit or on the positive side

yellow is for advancing the strobe patterns. Consult with the

light to determine if yellow is on the negative side of the

and connect it to the appropriate polarity of

terminal 2A .

19. Terminal 2B has been specifically designated for additional light controls.
With applicable lights, you may use the respective sliders to adjust both
brightness

and flash speed.

Page 2 of 06