CA HF
G
L1**
L2**
H*
T
U
T
S
N
®
O
U
P
I
V*
J
C B D
Q
F
USER MANUAL
W*
PRINTED IN P.R.C.
48011706
K
E
R
GP
L**
X*
M**
A
®
1
* Certain models only
Y*
** Certain models only, nozzles may vary according to model
**
2 3 4 5
** *
6 7 8 9
14 15 16 17
18 19 20 21
10 11 12 13
22 23
* Certain models only
** Certain models only, nozzles may vary according to model
INSTRUCTIONS FOR SAFE USE
This appliance should only be used for domestic cleaning,
as described in this user guide. Please ensure that this
guide is fully understood before operating the appliance.
Do not spray with or pick up ammable liquids, cleaning
uids, aerosols or their vapours.
Do not run over the power cord when using your appliance
or remove the plug by pulling on the power cord.
Do not leave the appliance plugged in. Always switch off
and remove the plug from the socket after use, or before
cleaning the appliance or any maintenance task.
This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by
children without supervision.
If the power cord is damaged stop using the appliance
immediately. To avoid a safety hazard, an authorised
HOOVER service engineer must replace the power cord.
Keep hands, feet, loose clothing and hair away from rotating
brushes.
Use only attachments, consumables or spares recommended
or supplied by HOOVER.
Do not continue to use your appliance if it appears faulty.
HOOVER service: To ensure the continued safe and efcient
operation of this appliance we recommend that any servicing
or repairs are only carried out by an authorised HOOVER
service engineer.
Do not stand on or wrap the cord around arms or legs when
using your appliance.
Do not use the appliance to clean animals or people.
Do not position the appliance above you when cleaning the
stairs.
The Environment
The symbol on this appliance indicates that this appliance may not be treated
as household waste. Instead it must be handed over to the applicable collection
point for the recycling of electrical and electronic equipment. Disposal must
be carried out in accordance with local environmental regulations for waste
disposal. For more detailed information about treatment, recovery and recycling
of this appliance, please contact your local city ofce, your household and waste disposal
service or the shop where you purchased the appliance.
Static electricity: Some carpets can cause a small build up of
static electricity. Any static discharge is not hazardous to health.
Do not use your appliance out of doors or on any wet surface
or for wet pick up.
Do not pick up hard or sharp objects, matches, hot ashes,
cigarette ends or other similar items.
1
This appliance complies with the European Directives 2006/95/EC, 2004/108/EC
and 2011/65/EU.
HOOVER Limited, Pentrebach, Merthyr Tydl, Mid Glamorgan, CF48 4TU, UK
GETTING TO KNOW YOUR CLEANER
USING YOUR CLEANER
A. Cleaner main body
B. Dust Container
C. Dust Container Release Button
D. Dust Container Door Release Button
E. On/Off Button
F. Cord Rewind Button
G. Handle
H. Suction Regulator*
I. Telescopic Tube
J. Telescopic tube adjuster
K. Parking slot
L. Carpet and Floor Nozzle (GP)**
L1. Carpet Nozzle (CA)**
L2. Hard Floor Nozzle (HF)**
M. Floor Type Selector Pedal**
N. Hose
O. Pre motor Filter
P. Multi-cyclonic Separation Unit
Q. Dust Bin
R. Exhaust Filter
S. Accessories holder
T. 2 in 1 Accessory
U. Furniture Nozzle
V. Parquet Nozzle*
W. Pet Hair Remover Mini Turbo Nozzle*
X. Allergen Remover Mini Turbo Nozzle*
Y. Grand Turbo Nozzle*
1. Extract power cord and plug it into the power supply. Do not pull the cord beyond
the red marker. [5]
2. Adjust the telescopic tube to the desired height by moving the telescopic release
button up and raise or lower the handle to the most comfortable cleaning position. [6]
3. Carpet and Floor Nozzle** - Select the type of surface to be cleaned by pressing the
pedal** in the nozzle. [7]
Hard Floor – Brushes are lowered to protect the oor.
Carpet – Brushes are raised for the deepest clean.
4. Switch the cleaner on by pressing the On/Off Button on the cleaner main body. [8]
5. Adjust the suction by moving the suction regulator to the desired level.* [9]
6. Switch off at the end of use by pressing the On/Off Button. Unplug and press the
cord rewind button to wind the power cord back into the cleaner. [10]
7. To store your cleaner adjust telescopic tube to the lowest height setting and park the
nozzle in the parking slot on the cleaner main body. [11]
ACCESSORIES AND NOZZLES
#1
To obtain the best performance and energy efciency
correct nozzles are used for the main cleaning operations. These nozzles are indicated
in the diagrams by the letters GP, HF or CA.
A nozzle type GP can be used to clean both carpet and hard oor.
A nozzle type HF is suitable for use only on hard oor.
A nozzle of type CA is suitable for use only on carpet.
The other nozzles are accessories for specialist cleaning tasks and are recommended
for occasional use only.
It is important to note that this vacuum cleaner is supplied with an Energy Label as
required by European Regulation (EU) 665/2013.
it is recommended that the
ASSEMBLING YOUR CLEANER
Remove all components from the packaging.
1. Connect the hose to the cleaner main body, ensuring it clips and locks into position.
To release: simply press the button on the hose end and pull. [2]
2. Connect the tube upper end to the hose handle. [3]
3. Attach the accessory holder to the the telescopic tube and store the accessories on
the holder. [1]
4. Connect the tube lower end to the carpet and oor nozzle.[4]
*Certain Models Only ** Certain models only, nozzles may vary according to model
If the label shows a red prohibition circle on the left covering the carpet symbol, then this
indicates that the vacuum cleaner is not suitable use on carpets.
If the label shows a red prohibition circle on the right covering the hard oor symbol, then
this indicates that the vacuum cleaner is not suitable for use on hard oors.
#1
NOTE: Dust pick up ability carpet, dust pick up ability hard oor, and energy efciency
in accord with Commission Regulations (EU) 665/2013 and (EU) 666/2013.
All accessories can be tted to the end of the hose handle or to the end of the telescopic tube.
2 in 1 tool – Combines several functions in one. [12]
2
Dusting Brush – For bookshelves, frames, keyboards and other delicate areas. To
extend the brushes push the button on the body of the tool.
Crevice Tool – For corners and hard to reach areas.
Furniture Nozzle – For soft furniture and fabrics [13]
Parquet Caresse Nozzle* – For parquet oors and other delicate oors. [1U]
Pet Hair Remover Mini Turbo Nozzle* - Use the mini turbo nozzle on stairs or for
deepcleaning on textile surfaces and other hard to clean areas. Particularly suitable for
pet hairs removal. [1V]
Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for
deepcleaning on textile surfaces and other hard to clean areas. Particularly suitable for
allergen removal. [1W]
Grand Turbo Nozzle* – Use the turbo nozzle for deep cleaning on carpets. [1X]
IMPORTANT: Do not use the grand turbo and mini turbo nozzles on rugs with long fringes,
animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary while
the brush is rotating.
CLEANER MAINTENANCE
To access the pre-motor lter:
1. Release the container by sliding the dust container release button towards the rear
of the cleaner. Lift the dust container from the cleaner main body. [14]
2. Hold the dust container with one hand and with the other hand rotate the bin handle
anti clockwise to release it from the dust container. [16]
3. Remove the blue lter pack located in the dust container handle. [17]
4. Gently tap and wash the lter using warm water. Do not use hot water or detergents.
Remove excess water from the lter and leave to dry fully before re-using. [18]
5. Reassemble to lter pack once fully dry and ret to the cleaner.
IMPORTANT: Do not use the product without the lter pack tted.
To access the exhaust lter:
1. Release the container by sliding the dust container release button towards the rear
of the cleaner. Lift the dust container from the cleaner main body. [14]
2. Unclip the exhaust lter cover from the dust container cradle on the cleaner main
body. [19]
3. Using the tab remove the exhaust lter from the cleaner main body. [20]
4. Gently tap and wash the lter using warm water. Do not use hot water or detergents.
Remove excess water from the lter and leave to dry fully before re-using. [21]
Emptying the Dust Container
When the dust reaches the max level indicator in the container empty the dust bin.
IMPORTANT:To maintain optimum performance do not allow the dust to sit higher than
the max level.
1. Release the container by sliding the dust container release button towards the rear
of the cleaner. Lift the dust container from the cleaner main body. [14]
2. Hold the dust container over a bin with one hand and use the other hand press the
Dust Container Door Release Button. [15]
3. Close the Dust Container door and ret to the cleaner main body.
Cleaning the washable lters
The cleaner is tted with a blue lter pack. To maintain optimum cleaning performance
regularly remove the the lters and tap against the side of the bin to release dust. The lters
should be washed after 5 container empties or when the lter has excessive dust level.
IMPORTANT: All bagless cleaners require regular lter cleaning. Failure to clean
your lters may result in air blockage, overheating and product failure. This may
invalidate your guarantee.
IMPORTANT: Regularly check and maintain the lters by following the lter
maintenance instructions , it is also recommended that you purchase new lters
after every 3rd lter wash. This will maintain your cleaners performance.
IMPORTANT: Always ensure the lters are fully dry before use.
*Certain Models Only ** Certain models only, nozzles may vary according to model
Cleaning the dust container / multi-cyclonic separation unit
This cleaner uses a multicyclonic separation system, unique to Hoover. If necessary the
separation unit can be disassembled from the dust container and cleaned.
1. Release the dust container by sliding the dust container release button towards the
rear of the cleaner. Lift the dust container from the cleaner main body. [14]
2. Hold the dust container with one hand and with the other hand rotate the dust
container handle anti clockwise to release it from the dust container. [16]
3. Remove the multicyclonic separation unit from the dust container by pulling the
handle provided.[22]
4. If necessary, use a cloth to remove excessive dust from the multi-cyclonic unit
surface. [23]
5. Reassemble the multicyclonic separation unit to the dust container and ret the lter
pack in position.
6. Reassemble the dust container handle to the bin container. Ret the dust container
to the cleaner.
NOTE: For stubborn dirt the multi-cyclonic separation unit, or the dust container can be
washed, but care must be taken to ensure that both are completely dry before use.
IMPORTANT: For optimum performance, we recommend that the multi-cyclonic
separation system is inspected after each empty.
Removing a blockage from the cleaner
1. Check if the dust container is full. If so refer to ‘Emptying the dust container’.
3
2. If the dust container is empty but suction is still low:
A. Do the lters need cleaning? If so refer to ‘Cleaning the washable lters’.
B. Check if there is any other blockage in the system - Use a rod or pole to remove
any blockage from the extension tube or exible hose.
C. Check if pre-motor lter is tted.
D. Check if the separation unit needs to be cleaned. Refer to ‘Cleaning the separa-
tion unit’
USER CHECKLIST
Should you have a problem with the product, complete this simple user checklist
before calling your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another
electrical appliance.
• Is the dust container over-filled? Please refer to ‘Cleaner Maintenance’.
• Is the filter blocked? Please refer to ‘Cleaner Maintenance’.
• Is the hose or nozzle blocked? Please refer to ‘Removing a blockage from the
system’.
• Has the cleaner overheated? If so, it will take approximately 30 minutes to automatically reset
IMPORTANT INFORMATION
Your Guarantee
The guarantee conditions for this appliance are as dened by our representative in the
country in which it is sold. Details regarding these conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
Subject to change without notice.
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local Hoo-
ver dealer or direct from Hoover. When ordering parts always quote your model number.
Hoover Service
Should you require service at any time, please contact your local Hoover Service Ofce.
Hoover Customer Helpline Service
Should any faults occur with your cleaner during the rst 12 months contact the Hoover
Customer Helpline on the number below.
Tel: 08444 995 599
Email: customer.services@hoovercandy.com
Hoover have a computerised nationwide service network of over 500 engineers who will
quickly respond to your call and guarantee your repair for 12 months.
Quality
Hoover’s factories have been independently assessed for quality. Our products are
made using a quality system which meets the requirements of ISO 9001
4
Loading...