Page 1
CA
F
M1**
E
HF
M2**
G
C
M
D
P
Y
K
CM
MY
CY
CMY
K
USER MANUAL
C
O
O
T*
B
A
H
I
N
J
R
U*
K
PRINTED IN P.R.C.
48021208
M
* Certain models only
L
S
V*
** Certain models only, nozzles may vary according to model
Page 2
1 2 3 4
13 14 15 16
**
C
M
Y
CM
MY
CY
CMY
**
K
5
**
6 7 8
17 18 19 20
11 12
10
9 10 11 12
2221
* Certain models only
** Certain models only, nozzles may vary according to model
Page 3
INSTRUCTIONS FOR SAFE USE
This appliance should only be used for domestic cleaning, as
described in this user guide. Please ensure that this guide is
fully understood before operating the appliance.
Do not spray with or pick up ammable liquids, cleaning
uids, aerosols or their vapours.
Do not run over the power cord when using your appliance or
remove the plug by pulling on the power cord.
Do not leave the appliance plugged in. Always switch off and
remove the plug from the socket after use, or before cleaning
the appliance or any maintenance task.
This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children without
supervision.
If the power cord is damaged stop using the appliance
immediately. To avoid a safety hazard, an authorised
HOOVER service engineer must replace the power cord.
Keep hands, feet, loose clothing and hair away from rotating
brushes.
Use only attachments, consumables or spares recommended
or supplied by HOOVER.
Do not continue to use your appliance if it appears faulty.
HOOVER service: To ensure the continued safe and efcient
operation of this appliance we recommend that any servicing
or repairs are only carried out by an authorised HOOVER
service engineer.
Do not stand on or wrap the cord around arms or legs when
using your appliance.
Do not use the appliance to clean animals or people.
Do not position the appliance above you when cleaning the
stairs.
The Environment
The symbol on this appliance indicates that this appliance may not be treated as
household waste. Instead it must be handed over to the applicable collection point
for the recycling of electrical and electronic equipment. Disposal must be carried
out in accordance with local environmental regulations for waste disposal. For
more detailed information about treatment, recovery and recycling of this appliance,
please contact your local city ofce, your household and waste disposal service or the shop
where you purchased the appliance.
Static electricity: Some carpets can cause a small build up of
static electricity. Any static discharge is not hazardous to health.
Do not use your appliance out of doors or on any wet surface
or for wet pick up.
Do not pick up hard or sharp objects, matches, hot ashes,
cigarette ends or other similar items.
This product complies with the European Directives 2014/35/EU, 2014/30/EU
and 2011/65/EU.
CANDY HOOVER GROUP S.r.l. Via Privata Eden Fumagalli, 20861 Brugherio (MB) Italy
1
Page 4
GETTING TO KNOW YOUR CLEANER
CLEANER MAINTENANCE
A. On/Off Button
B. Bag Door
C. Telescopic Tube Adjuster
D. Telescopic Tube
E. Suction Regulator
F. Hose Handle
G. Hose
H. Bag Check Indicator
I. Cord Rewind Button
J. Exhaust Filter Cover
K. 2 in 1 Tool
L. Floor Type Selector*
M. Carpet and Floor Nozzle (GP) **
M1. Carpet Nozzle (CA) **
M2. Hard Floor Nozzle (HF) **
N. Main Cleaner
O. Bag Door Release Latch
P. Bag Holder
Q. Pre-motor Filter Frame
R. Pre-motor Filter
S. Exhaust Filter
T. Pet Hair Remover Mini Turbo Nozzle*
U. Allergy Remover Mini Turbo Nozzle*
V. Parquet Nozzle*
ASSEMBLING YOUR CLEANER
Remove all components from the packaging.
1. Connect the hose to the cleaner main body, ensuring it clips and locks into position. [1]
To release: simply press the two buttons on the hose end and pull. [1]
2. Connect the tube upper end to the handle. [2].
3. Connect the tube lower end to the carpet and oor nozzle**.[3]
USING YOUR CLEANER
1. Extract power cord and plug it into the power supply. Do not pull the cord beyond the
red marker. [4]
2. Adjust the length of telescopic tube by moving the telescopic tube adjuster up, and
raise or lower the handle to the most comfortable cleaning position. [5]
3. Carpet and Floor Nozzle**: Press the oor type selector pedal* on the nozzle to select
the ideal cleaning mode for the oor type. [6]
Hard Floor: The brushes are lowered to protect the oor
Carpet: With lifted brushes for the deepest clean
4. Switch the cleaner on by pressing the on/off button on the cleaner main body. [7]
5. Adjust the suction regulator to the desired level. [8]
6. Switch off at the end of use by pressing the on/off button. Unplug and press the
cord rewind button to wind the power cord back into the cleaner. [9]
7. Packing and storage – The tube can be parked for temporary storage while in use, or
in the storage position when not in use. [10]
*Certain Models Only ** Certain models only, nozzles may vary according to model
Replacing the Dust Bag
If the bag check indicator is red please check and, if necessary, replace the bag.
1. Lift the bag door release latch [11] to open the bag door. Pull the bag holder [12] and
pull the bag collar to remove the bag. [13]
2. Apply the peel and seal sticker, located on the bag collar, to the bag inlet. The full dust
bag should be disposed of correctly and carefully.
3. Fold a new bag as shown on the bag and t by inserting the collar into the bag holder. [13]
4. Ret the bag holder and close the bag door.
WARNING: The bag door will NOT close if the dust bag and/or the bag holder are not
assembled to the cleaner. Always ensure the bag and bag holder are present when closing
the bag door.
Remember: The bag check indicator may also be red if an obstruction has occurred. In this
case, refer to ‘Removing a blockage from the system’.
Cleaning the Filters
To maintain optimum performance of your cleaner, please wash the lters after each 5 bag
changes.
Cleaning the pre-motor lter:
1. Lift the bag door release latch [11] to open the bag door and remove the bag.[12]
2. To remove the pre-motor lter, slide the pre-motor lter frame from the cleaner. [14]
3. Remove the lter from the holder. [15]
4. Wash it in hand warm water [18], and allow it to dry thoroughly before replacing it in
the cleaner. [19]
Cleaning the exhaust lter:
1. To remove the exhaust lter, unclip the exhaust lter cover [16] and remove the
exhaust lter pack. [17]
2. Wash the lter in hand warm water [18] and allow it to dry thoroughly before replacing
it in the cleaner. [19]
Remember: Do not use hot water or detergents. In the unlikely event of the lters becoming
damaged, t a genuine Hoover replacement. Do not try and use the product without a dust
bag or lter tted.
Cleaning the permanent cloth dust bag*:
To maintain optimum performance we recommend that you wash the permanent cloth dust
bag under hand warm water after every 5 full bags. Remove excess water and leave to dry
fully before replacing.
Removing a Blockage From The System
If the bag check indicator is red:
1. Check if the bag is full. If so refer to ‘Replacing the dust bag’.
2
Page 5
2. If it is not full, then;
A. Do the lters need cleaning? If so refer to ‘Cleaning the lter’.
B. Check if there is any other blockage in the system - Use a rod or a pole to remove
any blockage from telescopic tube or exible hose.
Warning - The bag check indicator will turn red if the cleaner is used when the bag is full, if
there is a blockage or if the lters are dirty. If the cleaner is used for a signicant period of
time with bag check indicator is red, a thermal cut out will switch the cleaner off to prevent any
risk of overheating. The bag check indicator turn green once the cleaner has switched off to
signal that the thermal cut out has been activated. If this should happen, switch the cleaner off,
unplug and correct the fault. It will take about 30 minutes for the cut out to automatically reset.
Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas.
Parquet Nozzle*– For wooden oors and other delicate oors.
IMPORTANT: Do not use the grand turbo nozzle or mini turbo nozzles on rugs with long
fringes, animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary
while the brush is rotating.
USER CHECKLIST
ACCESSORIES AND NOZZLES
#1
To obtain the best performance and energy efciency
nozzles are used for the main cleaning operations. These nozzles are indicated in the
diagrams by the letters GP, HF or CA.
A nozzle type GP can be used to clean both carpet and hard oor.
A nozzle type HF is suitable for use only on hard oor.
A nozzle of type CA is suitable for use only on carpet.
The other nozzles are accessories for specialist cleaning tasks and are recommended for
occasional use only.
It is important to note that this vacuum cleaner is supplied with an Energy Label as required
by European Regulation (EU) 665/2013.
If the label shows a red prohibition circle on the left covering the carpet symbol, then this
indicates that the vacuum cleaner is not suitable use on carpets.
If the label shows a red prohibition circle on the right covering the hard oor symbol, then
this indicates that the vacuum cleaner is not suitable for use on hard oors.
#1
NOTE: Dust pick up ability carpet, dust pick up ability hard oor, and energy efciency in
accord with Commission Regulations (EU) 665/2013 and (EU) 666/2013.
All accessories can be tted to the end of the handle or the end of the tube.
2 in 1 tool – Combines two functions in one, the 2 in 1 tool can be connected as a crevice
tool. By rotating the end piece converts to a dusting brush. The 2 in 1 tool can be stored
neatly at the rear of the cleaner.
Crevice Tool – For corners and hard to reach areas.
Dusting Brush – For bookshelves, frames, keyboards and other delicate areas. To extend
the brushes push the button on the body of the tool.
Pet Hair Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas.
*Certain Models Only ** Certain models only, nozzles may vary according to model
it is recommended that the correct
Should you have a problem with the product, complete this simple user checklist
before calling your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another electrical
appliance
• Is the dust bag over-lled? Please refer to ‘Cleaner Maintenance’
• Is the Filter blocked? Please refer to ‘Cleaning the lter’
• Is the hose or nozzle blocked? Please refer to ‘Removing a blockage from the system’
• Has the cleaner overheated? If so, it will take approximately 30 minutes to automatically
reset
IMPORTANT INFORMATION
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering parts always quote your model number.
Hoover Service
Should you require service at any time, please contact your local Hoover Service Ofce.
Quality
BSI ISO 9001
Hoover’s factories have been independently assessed for quality. Our products are made
using a quality system which meets the requirements of ISO 9001.
Your Guarantee
The guarantee conditions for this appliance are as dened by our representative in the
country in which it is sold. Details regarding these conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
Subject to change without notice.
3
Loading...