Page 1
Heritage
5010
HERITAGE
Compact Bagless
Vacuum Cleaner
Bagless Technology
HEPA Filtration
Ergonomic Handle Design
11447_HV_Heritage_5010_Manual_FA.indd 1 26/08/11 12:18 PM
Page 2
6
5
7
9
3
1
2
4
8
11447_HV_Heritage_5010_Manual_FA.indd 2 26/08/11 12:19 PM
Page 3
5010 Heritage
Features
Congratulations on your purchase of your new HOOVER vacuum cleaner. There are many
useful features built into your cleaner and we recommend that you carefully read this
instruction book so that you may take best advantage of them.
Features:
1. On/Off Switch 6. Handle
2. Power Regulator 7. Telescopic Tube
3. Cable Rewind Button 8. Floor Brush
4. Hose Inlet 9. Combination Floor Tool
5. Hose
Specifications:
Watts: 1250W
Dust Capacity: 1.1L
Noise Level: <84dBa
Telescopic Tube: Chrome
Power Cable Length: 5m
Weight: 4.8kg
Please contact Hoover Customer Care: 1300 360 845 to find your local spare parts provider.
Part Part Number
Dust Container 33151744
Filter Cone 32200732
Hose 31220421
Filter Assembly Set 32200733
11447_HV_Heritage_5010_Manual_FA.indd 3 26/08/11 12:19 PM
Page 4
Before you begin
The cleaner must be operated in accordance with these instructions and used only for domestic household
cleaning to remove DRY dirt and dust from household carpets, flooring and fabrics. This cleaner is not fit to
be used as an industrial cleaner, and is not designed for the collection of vitreous building material including
particle board, construction products and similar products such as wood/fibres, cement, fillers, fibre glass
etc or excessive or frequent sand. The infrequent pick-up of these materials in these circumstances may be
harmful to your cleaner and may void the manufacturer’s warranty.
Please read these instructions thoroughly
This will ensure you obtain full benefit from your new cleaner. Keep this Instruction Manual in a handy place
for future reference.
Important
Always switch the cleaner off and remove the plug from the electricity supply before cleaning your
appliance, when not in use, or attempting any maintenance task. The cleaner must only be connected to
an AC supply at the voltage shown on the rating plate. This cleaner should only be used for its intended
purpose as described in these instructions. Never operate the vacuum cleaner without filters.
11447_HV_Heritage_5010_Manual_FA.indd 4 26/08/11 12:19 PM
Page 5
Before you Begin
Precautionary measures:
1. Do not operate the vacuum cleaner too close to heaters, radiators, and other
hot surfaces.
2. Before inserting the plug into the wall, make sure your hand is dry.
3. Before turning on the vacuum cleaner, remove any large or sharp objects
from the floor or cleaning surface in order to prevent damage to the filter.
4. When you want to pull the plug from the wall, do not use the power cable,
gently pull the plug from the power socket.
If the air inlet or floor head are blocked, you should switch off the cleaner straight
5.
away and remove from mains power. First clear the blocked substance before
attempting to start the vacuum cleaner again.
11447_HV_Heritage_5010_Manual_FA.indd 5 26/08/11 12:19 PM
Page 6
Warning
To reduce the risk of fire, electric shock, or injury:
1. Do not leave the appliance connected to the mains power supply when not in use. Disconnect from
any power supply before per forming any maintenance duties.
2. To reduce the risk of electric shock, do not use outdoors or on wet surfaces.
3
4. Use only as described in this instruction manual. Do not use for any other purpose except those outlined
in this instruction manual.
5. If the power cable or plug appears damaged, do not use. If the vacuum cleaner is not working correctly, has
been dropped, damaged, left outdoors, or dropped into water, return to a Hoover service agent or contact
.dednettanu ecnailppa eht esu ot nerdlihc wolla ton oD .yot a sa desu eb ton tsum ecnailppa sihT .
cable around sharp edges or corners. Avoid running the appliance over the power cable.
7. Keep the appliance away from heated surfaces.
8. Unplug the appliance by lightly grasping and pulling the plug from the wall. Do not unplug the machine
by pulling on the power cable.
10. Always ensure that all openings and entry points on the appliance are clear from objects or any blockages
before commencing use. Removal of dust, lint, hair and dirt from all openings and entry points will help
13. Use extra care when cleaning on stairs.
cigarettes, matches or anything burning) or use in areas where such substances and items may be present.
15. Hold the plug when rewinding onto cord reel. To prevent accidental injury do not allow the plug to whip
when rewinding.
16. Ensure the appliance is disconnected from the mains power supply before connecting the hose to the unit.
18. If the power cable is damaged, return to a Hoover service agent or contact Hoover Customer Care in order
to avoid a h azard.
19.
20.
21.
.sdnah tew htiw elbac rewop ro/dna ecnailppa eht eldnah ton oD .9
been
for
appliance.
rewop eht llup ro ,eldnah a sa elbac rewop eht esu ,elbac rewop eht yb ecnailppa eht yrrac ro llup ton oD .6
11447_HV_Heritage_5010_Manual_FA.indd 6 26/08/11 12:19 PM
Page 7
Instructions for Use
Instructions for use
Before using, unwind a sufficient length of cable and insert the plug into the power
socket. A yellow mark on the power cable shows the ideal cable length. Do not
extend the cable beyond the blue mark.
1. Press the on/off button to switch the vacuum on.
On/Off Button
Rewind Button
2. To rewind the power cord, press the rewind button with one
hand and guide the cord with the other hand to ensure that it
does not whip, causing damage to the cord.
3. Twist the power regulation control to increase or decrease
the suction power of the vacuum.
11447_HV_Heritage_5010_Manual_FA.indd 7 26/08/11 12:19 PM
Page 8
Instructions for use
Always remove the plug from the power socket before fitting or removing accessories!
Assembling the
vacuum cleaner
1. Fitting or removing the hose
To fit the hose, insert into the air intake
duct at the front of the cleaner. Press
until it clicks into position.
To remove the hose, squeeze the end
of the hose and gently pull from the
air intake duct.
2. Fitting the telescopic tube,
accessories and floor head
a. To fit the telescopic tube to the
handle, gently insert the end of
the handle into the top of the
telescopic tube as shown.
11447_HV_Heritage_5010_Manual_FA.indd 8 26/08/11 12:19 PM
Page 9
Instructions for Use
Floor Head
Extension Tube
b. To fit the floor head to the
telescopic tube, gently insert the
telescopic tube into the top of the
floor head as shown.
The Floor Brush is ideal
for cleaning on hard floors.
The Combination Floor
Tool is ideal for cleaning
on carpets and
hard floors
Carpet Hard Floor
11447_HV_Heritage_5010_Manual_FA.indd 9 26/08/11 12:19 PM
Page 10
Maintenance
Emptying the dust canister
Always operate the cleaner with the dust compartment correctly installed. Ensure the filter is correctly
installed when the cleaner is in use to prevent any damage to the cleaner.
1. Gently remove the dust canister
by pulling in an upwards
direction.
2. Suspend the dust canister in an
upright position over a rubbish
bin (or location of disposal). Press
the locking button to open base
and allow the dust to fall from
the canister.
3. Close the base of dust canister
and insert the canister back into
the vacuum.
11447_HV_Heritage_5010_Manual_FA.indd 10 26/08/11 12:19 PM
Page 11
Maintenence
Cleaning and changing the filter
Ensure the cleaner is not connected to the mains power when performing any maintenance duties.
• The air inlet lter should be cleaned at least twice a year or when it appears dirty.
• The HEPA air inlet lter should be cleaned when it appears dirty.
• Always operate the cleaner with lters and HEPA installed to prevent damage to the motor
or decreasing suction performance.
• Do not use a washing machine to rinse the lter.
• Do not use hair dryer to dry the lter.
1. Cleaning and changing the air inlet filter
and HEPA filter
a. Remove the dust canister from the unit .
b. Remove the HEPA bracket as shown.
c. Rinse the HEPA filter and the sponge
in warm water, allow to dry thoroughly
before reassembling.
d. Reassemble the HEPA filter and sponge back
the vacuum. Alternatively, replace the HEPA
filter and sponge with new ones.
2. Changing the air outlet filter.
a. Open the grille for the air-outlet at the rear
of the cleaner.
b. Remove the air outlet filter and replace
with a new air outlet filter (Part Number
32200733).
Close the grille for the air-outlet filter.
c.
11447_HV_Heritage_5010_Manual_FA.indd 11 26/08/11 12:19 PM
Page 12
Conditions of warranty
Your Hoover cleaner, in the case of domestic use, has a two
year parts and labour warranty against product defects
and failures when the product is used in accordance with
the terms and conditions of this warranty statement.
This warranty commences from the original date of
purchase and is not transferable; please retain your original
proof of purchase for any warranty claims. This warranty is
valid only in the country where the cleaner is purchased.
The cleaner must be operated in accordance with these
instructions and used only for domestic household
cleaning to remove DRY dirt and dust from household
carpets, flooring and fabrics. This cleaner is not fit to be
used as an industrial cleaner, and is not designed for the
collection of vitreous building material including particle
board, construction products and similar products such
as wood/fibres, cement, fillers, fibre glass etc or excessive
or frequent sand. The infrequent pick-up of these
materials in these circumstances may be harmful to your
cleaner and may void the manufacturer’s warranty.
Accessories and consumables including dust bags and
filters, unless defective in manufacture, are not subject to
this warranty. In order to prolong the life of accessories and
consumables, regular care and maintenance is recommended.
When properly used and cared for, your cleaner
will render excellent service; refer to the instruction
manual for further details, as misuse or failure to
follow the instructions makes this warranty void.
In the event of service or advice being needed, please
contact Hoover Floorcare Asia Pacific Pty Ltd, Level 1,
Building 2 Brandon Park Business Park, 530 Springvale Road,
Glen Waverley Victoria 3150, or on 1300 360 845, MondayFriday 9am-5pm EST. The decision to repair or replace the
cleaner is at the sole discretion of Hoover Floorcare. If Hoover Floorcare
decide to repair or replace the cleaner, it will do so at its own cost.
Hoover Floorcare is unable to accept responsibility under this
warranty for any repair work not carried out by an authorised
Hoover Service Agent or from the use of non-genuine parts.
If any part is no longer available or manufactured, Hoover
Floorcare will replace it with a genuine functional replacement
part. This warranty does not apply to the cost of replacing any
parts of the product due to normal wear and tear, alterations,
improper installation, physical abuse, misuse or accidental
damage. Any transportation costs involved in the repair of
defective parts shall be borne by the claimant.
If proof of purchase cannot be provided at the time of
a warranty claim or service, any work carried out on
the cleaner is chargeable.
The repair or replacement of the cleaner under
this warranty does not extend the original period
of warranty.
The benefits conferred by this warranty are
in addition to all other rights and remedies in
respect of the product as outlined under the
Competition and Consumer Act and other State
and Territory laws.
“Our goods come with guarantees that cannot
be excluded in the Australian Consumer Law.
You are entitled to a replacement or refund
for a major failure and for compensation for
any other reasonably foreseeable loss or
damage. You are also entitled to have the
goods repaired or replaced if the goods fail
to be of acceptable quality and the failure
does not amount to a major failure.”
Australia 1300 360 845
To find out more about our range,
visit: www.hooverfloorcare.com.au
email: sales@hooverfloorcare.com.au
Call Hoover Floorcare
with any product queries
11447_HV_Heritage_5010_Manual_FA.indd 12 26/08/11 12:19 PM
Loading...