INSTALLATION INSTRUCTIONS RF 20 ROOM SENSOR
1.Open housing of the room sensor by pressing the snap-on locks and remove housing cover.
Figure 1: Removing housing cover
2.Screw room sensor to the flush distribution box.
Figure 2: Installation onto flush distribution box
3. Connect cable coming from controller.
Figure 3: Terminals
Connection to terminals:
1 = Room temperature sensor (1 is left)
2 = not used
3 = GND
EN1H-0133 GE51R0104
4.Return cover to housing by placing top edge against back plate and snap lower part of cover onto housing.
Figure 4: Replacing of housing cover
Automation and Control Solutions
Honeywell GmbH
Böblinger Strasse 17
D-71101 Schönaich
Phone: (49) 7031 637 01
Fax: (49) 7031 637 493
http://europe.hbc.honeywell.com
Manufacturing location certified to
Subject to change without notice. Printed in Germany
EN1H-0133 GE51R0101