Installation & Operation Instruction Manual
HU-30 Desktop Water Purifier
Honeywell Environmental & Combustion Controls (Tianjin) Co., Ltd.
Content
Important Notes for Users ------------------------------------------ 1
Safety Notices --------------------------------------------------------- 1
Operation Instruction------------------------------------------------- 2
Technical Parameter------------------------------------------------- 2
Parts --------------------------------------------------------------------- 3
Usage Method --------------------------------------------------------- 4
Electronic device and application--------------------------------- 4
Changing cartridge --------------------------------------------------- 5
Troubleshooting guide----------------------------------------------- 7
Installation method --------------------------------------------------- 7
Important Notes for Users
Safety Notices
1
The user should engage professional installation staff and use the water purifier in strict
conformity with the installation and usage instructions as described in this “Installation &
Operation Instruction Manual” (hereinafter called “Instruction Manual”), otherwise our
company would not be liable for any financial or legal responsibilities in relation to
damage or leakage of the water purifier as a result of failure to install or use it in
accordance with the Instruction Manual.
• Regularly inspect the water purifier and water pipe parts to ensure that there are no
water leakage;
• The water purifier is designed for home use only; it may not be suitable for use in
other premises;
• Repair and maintenance of the water purifier and replacement cartridge or parts
should be carried out using replacement parts approved by Honeywell Environmental
and Automated Control Products (Tianjin) Co., Ltd. Quality issues, reduced performance or loss or damage to property arising from the use of unauthorized parts or
accessories would not be covered by warranty.
• Repair, maintenance and replacement of cartridge for the water purifier are chargeable services.
• Municipal tap water which is compliant with GB5749 should be used for the water
purifier;
• Do not under any circumstances install the water purifier on water-supply pipelines
with a water pressure in excess of 0.6MPa. If the water pressure for inlet water
exceeds 0.6 Mpa, pressure-reduction valve (to be separately purchased) must be
installed;
• Temperature of inlet water should be 5~38°C. Inlet water temperature exceeding
38°C may damage the sealing parts and cause leakage. Inlet water temperature
below 5°C may cause frosting and result in cracks in the water pipe or cartridge,
which in turn leads to water leakage;
• Do not use decontaminating agent, detergent, diluting agent, benzene, alcohol and
kerosene, etc. They will cause cracks to form as well as de-coloration;
• Do not install the water purifier in places under direct sunlight or which are exposed
to hazardous chemicals, or in any place that may make it susceptible to fall or impact,
thus causing damage to it;
• The water purifier should be placed far away from any heat sources, especially gas
stoves (the latter will cause it to undergo heat-deformation or experience breakdown);
• Do not place the water purifier upside-down during installation or change of cartridge
in order to prevent water from flowing onto the circuit board and damaging the
electronic components;
• It is essential to screw the upper cover tightly and ensure that there are no gaps in
order to prevent leakage or breakdown of the water purifier;
• Do not use the water purifier after removing the outlet water pipe; otherwise it may
experience leakage or breakdown.
Operation Instruction
Technical Parameter
Flow rate
1.5 L/min
Filtration composition of cartridge
Granular active carbon, ultrafiltration membrane
Applicable inlet water pressure
0.07 MPa ---0.6 MPa
Rated total purified water
1500 L
Product gross weight
Dimension
Height 275 mm x Diameter 136.6 mm
Inlet water requirements
Municipal tap water, GB5749-2006 compliant
2
• Regularly check the water purifier and water pipe parts to ensure that there is no
water leakage;
• Drain water for 5-10 seconds if the water purifier has not been in use for 24 hours. If it
has not been used for more than 5 days (3 days in the case of summer), drain water
for 2 to 3 minutes before resuming usage. Once the cartridge is in use it cannot be
left idle for prolonged period of time, especially during summer. Generally the idling
period should not exceed 14 days. If so, change of cartridge is recommended;
• If filtered water is to be obtained and stored, pour it into a clean vessel and cover the
vessel tightly. Place the vessel in the refrigerator. Water stored in this manner may be
preserved for only two days.
• Immediately cut off the water inlet for the water purifier (by turning the water
segregator to “TAP” position) and promptly contact the service provider in any of the
following circumstances:
If there is water leakage for the water purifier’s pipe or relevant parts;
If there are other abnormal phenomena or breakdowns
1.54 Kg
* The rated total purified water volume is effective treatment volume spiked at full
process in accordance with of the Ministry of Health’s inspection provisions. The
actual treatment volume may vary according to the local water quality and usage
environment.
* Flow rate: The actual situation may vary according to the usage environment, water
pressure and water quality.
Loading...