Honeywell HEV-312 User Manual
IMPORTANT
SAFETY INSTRUCTIONS
READ AND SAVE THESE SAFETY
INSTRUCTIONS BEFORE USING
THIS HUMIDIFIER
When using electrical appliances, basic
precautions should always be followed to
reduce the risk of fire, electric shock, and
injury to persons, including the following:
1. Always place this humidifier on a firm, flat
and level surface. This humidifier may not
work properly on an uneven surface.
2. Place this humidifier in an area where
it is not accessible to children.
3. Do not place the humidifier near any
heat sources such as stoves, radiators,
and heaters.
4. Do not use the humidifier outdoors.
5. Before using the humidifier, check the
power cord for any signs of damage.
If the cord is found to be damaged,
DO NOT USE and return the humidifier
to the manufacturer under the warranty
agreement for repair.
6. This appliance has a polarized plug (one
blade is wider than the other). To reduce
the risk of shock, this plug is intended
to fit only one way in a polarized outlet.
If the plug does not fit securely in the
outlet, reverse the plug. If it still does not
fit, contact a qualified electrician. DO NOT
attempt to defeat this safety feature.
HONEYWELL COOL
MOISTURE HUMIDIFIER
MODEL HEV312
Replacement Wicking Filter
Honeywell HAC-504AW Filter Type A
7. To disconnect the humidifier, first turn
controls to the OFF position, then grip
the plug and pull it from the wall outlet.
Never pull by the cord.
8. A loose fit between the AC outlet
(receptacle) and plug may cause
overheating and a distortion of the plug.
Contact a qualified electrician to replace
loose or worn outlet.
9. The humidifier should always be unplugged
and emptied when not in operation or while
being serviced or cleaned.
10. Never tilt or attempt to move the humidifier
while it is operating or filled with water.
UNPLUG the humidifier before moving.
11. This humidifier requires regular cleaning.
Refer to the CLEANING instructions
provided. Never clean the humidifier in any
manner other than as instructed in this
manual.
12. Do not direct moisture flow directly at
individuals, walls or furniture.
13. When a humidifier is used in a closed
room or small rooms, check periodically
for proper ventilation, as excessive humidity
can cause condensation stains on walls.
14. Turn the humidifier OFF if you notice
moisture on the inside of your windows.
For proper humidity reading, use a humidity
monitor like Honeywell HHM10 available at
retailers or www.honeywellcomfort.com.
Honeywell is a trademark of Honeywell International Inc., used under license by Helen of Troy Limited.
Honeywell International Inc. makes no representation or warranties with respect to this product.
SETTING UP YOUR HUMIDIFIER
Your humidifier is made up of these parts:
SETTING UP YOUR HUMIDIFIER (CONT’D)
WATER TANK
SEAL PAD
TANK CAP
FILTER
FILTER HOLDING BASKET
MAIN
HOUSING
Placement
Soak Filter
Fill Tank
Step 1
Select a firm, level location at least 6” (15cm) from
any walls for proper airflow. Place the humidifier on a
water-resistant surface, as water can damage furniture
and some flooring.
Kaz USA, Inc. will not accept responsibility for property
damage caused by water spillage.
Step 1
Remove the water tank
and carefully set aside.
Remove the filter from
the holding basket.
Soak the filter in cool water.
Step 3 Step 2
Place wet filter back in
the filter holding basket
and place back in unit.
DO NOT squeeze filter.
Step 1 Step 2 Step 3
HEV312
Power
Turn tank upside-down.
Remove tank cap by
turning counterclockwise
Step 1
.
Fill tank with cool
tap water.
Replace tank cap. Tighten
by turning clockwise
Place tank back on
humidifier.
With the power switch in the OFF position, plug the filled
Once the filled water
tank has been placed
on the unit do not move
humidifier. Doing so
.
could cause leakage
and spills.
humidifier into a polarized 120V outlet. DO NOT FORCE
THE POLARIZED PLUG INTO THE OUTLET; it will only fit
one way.
DO NOT plug in humidifier with wet hands to avoid
electric shock.
2 2
3 3
OPERATING YOUR HUMIDIFIER
Output/Fan Speed Control
Step 1
Step 2
CHANGING YOUR FILTER
The filter should be changed every 1-3 months depending on your water quality. Keep in mind, depending
on your water quality, mineral deposits can still clog or discolor the filter, affecting it’s life and that of the
humidifier.
It is recommended you change your filter in the bathroom or kitchen. Keep in mind your filter may be
damp depending on your last usage.
To change the filter:
Set Humidity
Press power to start unit
in high speed.
Push ( ) Up button or
(
) Down button to select
the output level.
Step 1
Min: approximately 35%
Max: approximately 55%
Use the ( ) up or ( ) down button to
set desired humidity.
The unit will operate until the selected humidity is reached
or the unit is turned off. When desired humidity is reached,
the fan will shut off but LED will remain lit. The fan will
turn back on when the room humidity drops below the
set level.
NOTE: To go back to continuous run mode, turn your
unit off and on again.
Step 1
Uses replacement filter
Filter A HAC-504AW.
Step 5 Step 6 Step 7
Soak new filter in cool
water.
Do not squeeze out.
Step 2 Step 3
Turn off and unplug
your humidifier.
Insert new filter into
Remove the water tank
and carefully set aside.
Replace the water tank.
holding basket and
place filter holding
basket back in unit.
Step 4
Remove filter holding
basket and discard old
filter.
4
5
CLEANING
CLEANING (cont’d.)
NOTE: It is recommended that all maintenance be done in the kitchen or bathroom on a water
resistant surface. Remove water tank from unit before moving.
Cleaning involves two steps, SCALE REMOVAL and DISINFECTING. Be sure to perform these in the
proper order to avoid harmful chemical interactions.
NOTE: REMOVE FILTER BEFORE CLEANING.
Failure to remove filter during cleaning will destroy the filter.
SCALE REMOVAL
Step 1 Step 2 Step 3 Step 4
Turn off and unplug
your humidifier.
Place basket in sink or
tub and fill the bottom
of the basket with
undiluted vinegar.
Remove the water tank
and carefully set aside.
Let stand for 20
minutes.
Remove filter basket. Remove filter from
basket. Failure to do so
will destroy the filter.
Step 7 Step 6 Step 5
With vinegar in the
basket, wipe surface
with a soft cloth or
brush.
Step 8
Rinse the filter basket
thoroughly with water
to remove scale and
cleaning solution.
DISINFECTING
Step 1
Remove the water tank
and carefully set aside.
Step 2 Step 3
Remove filter holding
basket.
Remove filter and set
aside. Failure to do so
will destroy the filter.
Step 5
Pour some solution into
the filter basket.
Step 6 Step 7
Let stand for 20
minutes.
Rinse with water until
the smell of bleach is
gone.
END-OF-SEASON CARE AND STORAGE
• Follow the CLEANING instructions when the humidifier will not be used for at least one week or more,
or at the end of the season.
• At the end of the season, remove and throw away the filter; do not store with a used filter.
• Dry the humidifier completely before storing. DO NOT store with water inside the Base or Water Tank.
• Pack the unit in its original carton and store in a cool, dry location.
• Before next use, remember to clean your humidifier and install a new filter.
Step 4
1
l
g
a
Fill water tank with
1 tsp. of household
bleach and 1 gallon of
cool water
NOTES: The use
of other water
treatment products
and chemicals may
cause deterioration of
the filter or damage
the humidifier,
thereby hindering
the humidifier’s
effectiveness.
CONSUMER RELATIONS
Mail questions or comments to:
Kaz USA, Inc.
Consumer Relations Dept.
250 Turnpike Road, Southborough, MA 01772
Please be sure to specify model number.
Call us toll-free at: 1-800-477-0457; E-mail: consumerrelations@kaz.com
Or visit our website at: www.honeywellcomfort.com
Purchase replacement filter part number HAC-504AW or FILTER A.
6
7
Loading...