Honeywell HCD484E, HCD485EX, HCD484EX User Manual

Day/Night Camera

HCD484E HCD485EX

HCD484EX

User Guide

NTSC

PAL

Document 900.0355 – 01/06 – Rev 1.01

Rev 1.01 ii 900.0355

01/06

Revision

Issue Date Revisions

1.00 11/05 New document.

1.01 01/06 Minor corrections and updated
illustrations.

Rev 1.01 iii 900.0355

01/06

Explanation of Graphical
Symbols

This symbol indicates the presence of
uninsulated “dangerous voltage” within
the product’s enclosure that may be of
sufficient magnitude to constitute a risk
of electric shock to persons.

This symbol indicates the presence of
important operating and maintenance
(servicing) instruction in the literature
accompanying the product.

CAUTION: TO REDUCE THE RISK OF

ELECTRIC SHOCK, DO NOT REMOVE THE

COVER (OR BACK). NO USER-SERVICEABLE

PARTS INSIDE. REFER SERVICING TO

QUALIFIED SERVICE PERSONNEL.

RISK OF ELECTRIC

SHOCK DO NOT OPEN

CAUTION

Rev 1.01 iv 900.0355

01/06

Warnings

Installation and servicing should be performed only by
qualified and experienced personnel.

For outdoor applications, use an appropriate protecting
housing conforming to IP65.

Safeguards

This camera is designed for use in general-purpose indoor
CCTV applications and no other purpose.

Only operate your camera between the temperature of -10°C to
+50°C (14°F to 122°F).

Do not operate your camera outside its specified power supply
range.

Camera must only be used in clean, dry, dust-free
environments unless housed in suitable protective housings to
IP65 or better.

To prevent fire or shock hazard, do not
expose this camera to rain or moisture.

Regulatory Notice

INTENDED PURPOSE:

SECURITY AND SURVEILLANCE CCTV
APPLICATIONS.

The product must be installed and maintained in accordance
with good installation practice to enable the product to function
as intended and to prevent problems. Refer to Honeywell
Video Systems for installation guidance.

Manufacturer’s Declaration of
Conformance

FCC Statement (U.S.A.)

This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.

Industry Canada Notice

This digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.

Cet appareil numérique toutes les exigences du Règlement sur
la matériel brouilleur du Canada.

Œ

The Πmark on the product indicates that the system has
been tested to, and conforms with, the provisions noted within
the 89/336/EEC Electromagnetic Compatibility Directive.

Rev 1.01 v 900.0355

01/06

Rev 1.01 vi 900.0355

01/06

Rev 1.01 vii 900.0355

01/06

Contents

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

Connecting Cables . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Connecting the Power Cable . . . . . . . . . . . . . . . . . . . . . 3

Main Power Model (100 VAC ~ 240 VAC, 50 Hz) . . . 3

Dual Power Model (12 VDC / 24 VAC) . . . . . . . . . . . 4

Connecting the Video Cable . . . . . . . . . . . . . . . . . . . . . . 4

Connecting the RS485 Cable . . . . . . . . . . . . . . . . . . . . . 5

Connecting LAMP Contact . . . . . . . . . . . . . . . . . . . . . . . 5

Lens Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Installing Video Auto Iris Lens . . . . . . . . . . . . . . . . . . . . . 6

Installing DC Auto Iris Lens . . . . . . . . . . . . . . . . . . . . . . . 6

Mounting the Lens . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

Focus and Back Focal Adjustment . . . . . . . . . . . . . . . . . 7

OSD Menu Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8

Tact Switch Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

Opening the Set Up Menu . . . . . . . . . . . . . . . . . . . . . . . 9

Reset . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

Function Operations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11

Synchronization Setting (SYNC) . . . . . . . . . . . . . . . . . . 11

Line-Lock Sync Mode (LL) . . . . . . . . . . . . . . . . . . . 11

Shutter Speed Setting (Shutter) . . . . . . . . . . . . . . . . . . 11

Lens . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

Bright Setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

BF Setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

BLC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

Configure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13

Aperture . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13

Gamma . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13

Pedestal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13

Chroma . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13

AGC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

CAM Title . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

White Balance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

WB-Auto (White Balance Auto) . . . . . . . . . . . . . . . . 14

WB-Manual (White Balance Manual) . . . . . . . . . . . . 14

WB-Push . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

D/N . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15

Fuzzy . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15

IR Pass . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15

IR Cut . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15

RS485 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15

Password Setting . . . . . . . . . . . . . . . . . . . . . . . . . . . 16

Address . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16

B-Rate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16

For More Information . . . . . . . . . . . . . . . . . . . . . . . . . . . 16

Care and Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . 17

Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18

Service and Support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19

Service and Support . . . . . . . . . . . . . . . . . . . . . . . . . . . 19

Limited Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19

Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20

General Specifications . . . . . . . . . . . . . . . . . . . . . . . . . 20

Functional Specifications . . . . . . . . . . . . . . . . . . . . . . . 20

Function Control or Selectable by OSD and

RS-485 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . 21

Rev 1.01 viii 900.0355

01/06

Rev 1.01 1 900.0355

01/06

Introduction

Honeywell’s Day Night Color Camera provides high picture
quality and resolution with a highly sensitive 1/3 inch interline
transfer CCD image sensor.

This camera uses advanced Digital Signal Processing LSI
(DSP) technology to convert images into a digital format for
exceptional picture quality. It is ideal for advanced surveillance
applications or as an input device for an image processing
system.

An intuitive menu and On-Screen-Display (OSD) helps you to
quickly set up the camera and ensure the best picture quality
for your unique environment.

Figure 1 Product Overview

Features

• High sensitivity with minimum illumination needed for
quality video.

• Low image distortion and residual images, withstands
electric and magnetic field interference and mechanical
vibrations.

• Applications: Surveillance, Monitoring and Security.

• Excellent signal to noise ratio.

• Accurate color reproduction and a two application range
of Auto Tracing White balance (ATW) over a wide color
temperature.

• Aperture and color suppression under low light to reduce
spectral and Chroma noise.

Rev 1.01 2 900.0355

01/06

• Automatic electronic shutter provides > 1,600:1,
equivalent to 40 steps, dynamic range to correct
exposure, if a manual iris lens is used.

• Built-in functions:

• On-Screen-Display (OSD) digital control.

• Internal and line lock synchronization.

• Auto Iris (AI) / Auto Electronic Shutter (AES).

• Auto Iris level adjustment by digital process, manual

adjustment on OSD.

• Six options for full application of Back Light

Conversion (BLC).

• Advanced parameter adjustment for application

conditions.

• Two range Auto Tracking White balance (ATW) for

indoor and outdoor application conditions.

• Back focus adjustment allows for easy installation and
quick adjustment.

• Excellent picture quality:

• Two edge (vertical, horizontal) picture enhancer for

greater picture sharpness.

• New Chroma processing circuit for better color

reproduction.

• New concept ATW curve for good color correction.

Package Contents

Check that the items received match those listed on the order
form and packing slip. The Day Night camera packing box
should include, in addition to this User Guide:

If any parts are missing or damaged, contact the dealer you
purchased the camera from or call Honeywell Customer
Service.

• One Day Night camera • CCD Protect Cover

• Main Power Cable (main power model only)