Page 1
HCE80/HCC80/HCE80R/HCC80R
UNDERFLOOR HEATING-ZONEING CONTROLLERS
PRODUCT DATA
FEATURES
• Easy and fast installation because the new wiring
design
• Pluggable terminals for fast wiring connection
because clamp contacts
• Integrated pump relay for pump control
Relay (230V AC non potential free contact)
• Integrated antenna for the controllers HCC80 and
HCC80R only
• External antenna for HCE80 and HCE80R only
• Up to 3 controllers can be connected to one antenna
external HRA80 or integrated antenna
• Basic 5 configuration 5 zones
• Easy extendable with HCS80 for up to 8 zones
• Central operating via HCM200D / CM67z possible
• LED indication for voltage, operation mode, status
and errors, RF check
• Outputs for a maximum of 24 thermal actuators
• Analogue output for boiler feedback to MCR200 /
MCR40/ Panther / Smile (only HCE80/HCC80)
• Boiler control with integrated boiler relay potential
free contact 42V (only HCE80R and HCC80R)
• Boiler feedback in dependence of valve setting with
HC60NG possible
• Switchable between normally closed/open thermal
actuators
• Potential free switch over contact heating / cooling
GENERAL
The underfloor heating-zoning controllers are used for
individual room temperature control. The applications are
underfloor heating and radiator control as well. Each zone
can be controlled with easily operating devices used as
analogue or digital interface. The controllers are designed
with an intelligent control algorithm (Fuzzy control) to keep
the room setpoint temperature constant. Because of the used
system components HCW82/HCF82/CM67z the measured
room temperature will be sent to the controllers. The basic
configuration of each controller HCE80/HCC80/HCE80R and
HCC80R is 5 zones however it can be upgraded up to 8
zones by using the extension module HCS80.
Each zone can be controlled individually with time program
by using the CM67z and HCM200D. With HCM200D up to 16
zones can be controlled with their own time program which
save energy costs.
Two types of controllers are provided with internal and
external antenna HRA80. Up to 3 controllers can be
connected to one antenna. The controllers HCE80/HCE80R
are connected with the external antenna HRA80. The
controllers HCC80/HCC80R include the antenna on the
circuit board. The antenna includes also the transceiver
868,3MHZ.
Because of the new wiring concept the thermal actuators can
be installed very fast and pre wired without screws. All
connectors are pluggable.
Cooling applications are also possible by switching from
heating into the cooling mode with potential free change over
contact.
Note: The controllers HCE80/HCC80/HCE80R and HCC80R
have the same functionality exception the output for the boiler
feedback.
HCE80/HCC80: Analogue output for OTC controllers MCR,
Panther, Smile (additional boiler relay not available)
HCE80R/HCC80R: Additional boiler relay 42V (analogue
output for OTC controllers is not available
EN0H0501GE51 R0805
Page 2
HCE80/HCC 80../R
SPECIFICATIONS
Electrical
Voltage supply : 230 V AC, 50 Hz + 10 % / -15
Power consumption :max. 1750 VA with connected
Integrated pump relay : 42 Volt potential contact, 6A
Safety fuse : Ceramics safety fuse 230 VAC,
2,5 A swift,
5 x 20 mm
Optional : Expansion module HCS80
enhance the controller to 8
zones
Wiring
Admissible cable types and lengths :
Thermal actuators
Cable diameter
Cable length
Cable cross-section
Strip length
Network and pump connection 230 VAC
Outside cable diameter
Cable length
Cable cross-section
Strip length
Antenna
Cable length
Cable cross-section / type
Heating / Cooling, Boiler feedback
Cable length
Cable cross-section / type
Pump6A)
max180 VA without pump
Min. 3.5 mm/Max. 5.3mm
Max. 400 m
Max. 1.0 mm²
4 mm
Min. 8.0 mm/Max. 11 mm
Max. 100 m
Max. 1.5 mm²
7 mm
Max. 30 m
JE-LiYCY 2x2x0.8 mm²;
JE-Y(St)2Y 2x2x0.8 mm²;
2 x 0.5 mm²
Max. 100 m
JE-LiYCY 2x2x0.8 mm²;
JE-Y(St)2Y 2x2x0.8 mm²;
2 x 0.5 mm²
RF COMMUNICATION
RF band : 868,3 MHz Transceiver
(integrated in the antenna)
The external HRA80 includes the transceiver used for
HCE80 and HCE80R
HCC80 and HCC80R includes the antenna and transceiver
on the circuit board
Receiver class : 2
RF communication range : 30m in a residential building
environment
RF communication : short, high rate transmission to
Technology minimize air time and avoid
collisions
ENVIRONMENTAL and STANDARDS
Mounting : Wall mounting or DIN track
Measurements (WxHxD) : 350 x 52 x 82 mm
Protection class : IP 30
Operating temperature : 0…+50 °C
Storage temperature : -20......+70 °C
Relative humidity : max. 5…93 %
Fire protection class : 0
Authorization : C
EN0H0501GE51 R0805
Page 3
HCE80/HCC 80../R
1 = Bus (+)
2 = Bus (-) for external antenna
3 = Input heating / cooling
4 = Mass for heating / cooling
5 = Analogue output (TW)
6 = Analogue output (mass)
Internal antenna
of HCC80
Malfunction
LED
Installation LED
Function
button
Installation
button
Potential
afflicted
Safety
fuse
EN0H0501GE51 R0805
Page 4
HCE80/HCC 80../R
Wiring connections
Example
Switch-over contact
Heating/Cooling
1 = (+) Bus for external antenna
2 = (-) Bus for external antenna
3 = Input heating / cooling
4 = Mass for heating / cooling
5 = Analogue output (TW)
6 = Analogue output (mass)
HRA80
Heating
Boiler
feedback
Analogue
feedback
Voltage supply
1 + 6 = Ground wire (PE)
3 + 8 = Neutral wire (N)
4 + 9 = Phase (L)
5 + 10 = Pump outlet (220 V)
EN0H0501GE51 R0805
Page 5
HCE80/HCC 80../R
APPLICATION EXAMPLES
Application A
Underfloor heating with and without time
program .
The room unit CM67z can control up to 2
zones with individual time program. Only the
zone 1 of the CM67z includes the room sensor
for zone 2 the HCF82 must be additional
allocated for the room temperature
measurement to the same zone of the
underfloor heating co ntroll er. The HCW82 is
sending the room temperature and setpoint
offset to the allocated zones without time
program.
Communication 868,3 MHZ
CM67z
Pump control
Pump control
Pump control
Up to 8 zones
Underfloor heating controller
Underfloor heating controller
HCE80/HCE80R/HCC80/HCC80R
HCE80/HCE80R/HCC80/HCC80R
HRA80
HRA80
HRA80
HCW 82HCF 82
Antenna for
Antenna for
HCE80
HCE80
HCE80R
HCE80R
Automation and Control Solutions
Honeywell AG
Boeblinger Strasse 17
D-71101 Schoenaich
Phone: (49) 7031 63701
Fax: (49) 7031 637493
http://europe.hbc.honeywell.com
Subject to change without notice. Printed in Germany Manufacturing location certified to
EN0H0501GE51 R0805
Page 6
HCE80/HCC 80../R
Application B
Underfloor heating and radiator control
Communication 868MHZ
HCM200D
HCW 82
HCF 82
HRA80
HRA80
CM67z
Setpoint
S
e
R
tp
o
o
o
m
i
n
t
te
m
p
.
HR80
Pump control
Pump control
Underfloor heating controller
HCE80/HCE80R/HCC80/HCC80R
HC60NG
R6660D
• Analogue Boiler feedback OTC controller
• Analogue Boiler feedback OTC controller
MCR/Panther/Smile (HCE80/HCC80) only
MCR/Panther/Smile (HCE80/HCC80) only
• Boiler feedback relay potential free contact 42V
• Boiler feedback relay potential free contact 42V
(HCE80R/HCC80R) only
(HCE80R/HCC80R) only
• Thermal actuator up 24 (MT4-230)
• Thermal actuator up 24 (MT4-230)
• Change overcontact heating/cooling
• Change overcontact heating/cooling
Automation and Control Solutions
Honeywell AG
Boeblinger Strasse 17
D-71101 Schoenaich
Phone: (49) 7031 63701
Fax: (49) 7031 637493
http://europe.hbc.honeywell.com
Subject to change without notice. Printed in Germany Manufacturing location certified to
EN0H0501GE51 R0805
Loading...