Honda NC700JD User Manual

HEATED GRIPS

BACKREST

HEATER SWITCH

BACKREST

• This accessory combines the heated grip with the throttle pipe. Therefore, the throttle operation has a different feeling after installation.

• Check the accessory mounts frequently.

• Clean this accessory with a soft cloth soaked with a solution of mild detergent and water. Then wipe with a clean cloth soaked with water to remove dirt and detergent. Finally, wipe dry with a soft, clean cloth.

• The weight of the cargo must not exceed the following maximum loading capacity:

3.0 kg (6.6 lb)

• Check the accessory mounts frequently and retighten if necessary.

• Clean this accessory with a soft cloth soaked with a solution of mild detergent and water. Then wipe with a clean cloth soaked with water to remove dirt and detergent. Finally, wipe dry with a soft, clean cloth.

TALL WINDSCREEN

NC700JD (NM4)

Genuine Accessory User’s Guide

• Handle this accessory with care. It can be damaged if it is bent excessively or is subject to strong shock or impact.

• Park the motorcycle in the shade when it is to be left unattended in the summer for an extended period of time with a body cover placed over it.

• Failure to observe this precaution can cause this accessory to be deformed due to heat built up under the body cover.

• Select a firm, level sur face when you park the motorcycle. Also bear in mind that strong wind can cause the motorcycle to topple to the ground.

• Check the accessory mounts frequently and retighten if necessary.

• When this accessory becomes dirty, rinse it thoroughly with cool water to remove loose dirt, then wipe with a clean cloth or sponge. Do not use a brush to clean this accessory as it may scratch the surface.

• Never use petroleum solvents such as gasoline, thinner or benzine to clean this accessory. Also do not use acid or alkaline cleaners.

• Wipe up spilled brake fluid at once as it may damage the plastic surface.

1 of 1