Honda goldwing gl1200 line cb Installation Manual

hondaline

CB TRANSCEIVER KIT FOR GL1200

Installation Manual

The
Type III Radio & Cassette Deck has all of the advantages
without compromises.
Now available is a CB Radio for use with the Type III unit.
To use the CB Radio, it is necessary to purchase the
extension kit.
NOTE: This fairing is designed for use only on the
GL1200A motorcycle

hondaline

Index No. Part Name Q’ty

61 CB Transceiver assy. 1
62 Component, terminal 1
63 Distributor, ant. 1
64 Cover assy. 1
65 Transceiver harness 1
66 Stay assy., auto vol. 1
67 Nut, hex., 5 mm 1
68 Screw, tapping 3x54 mm 1
69 Nut, hex., cap 5 mm 4
70 CB handlebar switch 1
72 Washer, number brkt. Set 4
73 Cap, socket bolt 5 mm 4
74 OW. CB, passenger 1
75 Installation DWG 1
76 Owner’s Instl. 1
77 Collar, radio SW. 1

PRECAUTIONS

The descriptions are based on the motorcycle already equipped with the Type III radio. And references are to be
made to the instructions furnished with the radio.

INSTALLATION

1) Remove the right and left side covers.
Disconnect the battery negative cable from the battery negative terminal.

2) Remove the left fairing pocket.

3) Remove the Auto volume control unit.

-1 Remove the CB blind cover from the fairing by removing the four 5 x 22 mm socket head bolts. (Fig. 2)
Disconnect the three wire connectors of the auto volume unit. (Fig. 3)

-2 Remove the two 4 x 12mm tapping screws and remove the knob and nut from the auto volume control unit.

(Fig. 1)

-3 Remove the bracket form the auto volume control unit.

NOTE: Discard the CB blind cover, 4 x 22mm tapping screws, and bracket.

4) Remove the seat.

5) Remove the shelter.

NOTE: To remove the front of the shelter, it is necessary to remove the inner cover by lifting the rear of the
cover.

6) Remove the two tapping screws attaching the left coupler cover and move the holder towards the center.

7) Remove the main amplifier.

-1 Disconnect the main amplifier 2-P black connector.

-2 Straighten the four wire clamps at the main amplifier to release the harnesses.

-3 Remove the two nuts and washers holding the main amplifier; pull the amplifier out between the left fairing

pocket and handlebar by pulling up on the bottom.

8) Connect the two DIN connectors if the transceiver harness (65) to the terminal component (62) color-to-color

(Fig. 7).

9) Remove the seals from the terminal component mounts inside the fairing. Position the terminal component (62)

on the mounts and install using cap nuts (69) and washers (72).

NOTE: Use care when installing the terminal component (62) not to push in the audio harness, CB harness

and terminal component harness into the fairing pocket.