HONDA 08B26-S9V-100 User Manual

INSTALLATION

www.collegehillshonda.com/parts

INSTRUCTIONS

P ARTS LIST

Accessory Application Publications No.

CD CHANGER

ATTACHMENT

2003-2004 PILOT

All 23607

Issue Date

MAY 2002

CD Changer Attachment Kit (sold separately): P/N 08B26-S9V-100

Right base bracket

Left base bracket

Right changer bracket

Left changer bracket

8 Wire ties

4 Washer-screws, 4 x 8 mm

2 Wire clips

CD Changer (sold separately): P/N 08A26-1B1-100

CD changer

BUS Cable

4 Flange bolts, 6 x 12 mm

4 Flange nuts

2 EPT seals (Black)

2 Cushion tapes (Gray)

4 Washer-screws, 4 x 6 mm (Not used)

Adhesive seal sheet

Locking covers

CD magazine

Owner’s Manual

Small wire tie (Not used)

TOOLS AND SUPPLIES REQUIRED

Flat-tip screwdriver Phillips screwdriver Shop towel Diagonal cutters 10 mm Combination wrenches Isopropyl alcohol Utility knife

INST ALLATION

Customer Information: The information in this

installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.”

1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons.

2. Disconnect the negative cable from the battery .

• Remove the four screws that fasten the audio brackets. Pull the audio unit out toward you, unplug the vehicle connector and antenna lead from the rear of the audio unit.

ANTENNA LEAD

AUDIO UNIT

AUDIO BRACKET

VEHICLE CONNECTOR

3. Remove the audio unit.

Without Navigation Unit:

• Using a flat-tip screwdriver wrapped with a shop towel, gently pry out on the audio panel to remove the five clips. Unplug the connectors and remove the audio panel.

VEHICLE CONNECTOR

SCREWS (Reuse.)

AUDIO BRACKET

With Navigation Unit:

• Remove the driver’s and passenger’s center console trim pieces (three clips each). Take care not to damage the clips.

DRIVER’S CENTER CONSOLE TRIM

PASSENGER’S CENTER CONSOLE TRIM

AUDIO P ANEL

CLIPS (3)

CLIPS (5)

• Remove the center panel (four self-tapping screws, two clips, and unplug the vehicle accessory power outlet).

CLIPS (2)

CENTER PANEL

SELFTAPPING SCREW

VEHICLE CONNECTOR

4. On the driver’s side of the vehicle, gently pull the center console lower cover out toward you to release the seven clips and remove the center console lower cover. Take care not to damage the clips.

DRIVER’S SEAT

DRIVER’S CENTER CONSOLE LOWER COVER

CLIPS (7)

• Remove the four screws that fasten the audio brackets. Pull the audio unit/heater control unit out toward you, unplug the vehicle connectors and antenna lead.

ANTENNA HEATER CONTROL UNIT

AUDIO BRACKET

SCREW

AUDIO UNIT

LEAD

VEHICLE CONNECTOR

AUDIO BRACKET

5. Remove the driver’s seat front cover by pulling it toward you. Take care not to damage the clips.

DRIVER’S SEAT

DRIVER’S SEA T FRONT COVER

CLIPS (4)

+ 5 hidden pages