Homelite 19591A User Manual
19591A
4-04
INSTRUCTION SHEET
GUTTER MAINTENANCE KIT
READ ALL SAFETY INSTRUCTIONS IN Y OUR OWNER'S MANU AL
For models:
HB180, HB180V, HB180VI, HB180VGK, HB290, HB290V, HB390, HB390V, HB390VI, Yard Sweeper, UT08929A, UT08930A,
UT08120, UT08931, UT08932, UT08934, Vac Attack II, Yard Broom II
1. Make sure blower has been turned off. Remove all tube
attachments from the blower. (See illustration 1.)
ILLUSTRATION 1
REMOVE
ILLUSTRATION 4
FULL
ELBOW
2. Make sure adapter is free to rotate on the elbow. Loosen
clamp and install over exposed end of elbow. (See illustration 2.)
ILLUSTRATION 2
SWIVEL ADAPTER
CLAMP
UPPER ELBOW
3. Attach above assembly (as shown in illustration 3) over
blower exhaust until elbow clamp groove matches blower
groove. Align assembly so adapter end points upward.
Tighten clamp screw.
ILLUSTRATION 3
CLAMP SCREW
SWIVEL ADAPTER POINTS
UPWARD
STRAIGHT TUBE
(As required)
SWIVEL
ADAPTER
UPPER
ELBOW
4. Attach full elbow threaded joint onto straight tube. Continue
attaching straight tubes until the preferred length is acquired.
Make sure all joints are screwed tightly into position or the
blower may vibrate and push tubes apart. (See illustration
4.)
WEAR EYE PROTECTION!
LARGE
CLAMP
KIT DOES NOT INCLUDE BLOWER
READ ALL SAFETY INSTRUCTIONS IN Y OUR OWNER'S MANU AL
For models:
d25mhv, z25mhv, d30mha, d30mhv, i25mhv, i30mhv, BVM160, HB25150, HB30160, Vac Attack
1. Make sure blower has been turned off. Remove all tube
attachments from the blower. (See illustration 1.)
ILLUSTRA TION 1
REMOVE
ILLUSTRA TION 4
FULL
ELBOW
2. Tur n adapter clockwise to screw into blower housing until
tight. (See illustration 2.)
ILLUSTRA TION 2
3. Loosen clamp and place over exposed end of upper elbow.
Install swivel onto adapter. (See illustration 3.) Swivel
adapter must be free to rotate on the elbow.
ILLUSTRA TION 3
SWIVEL ADAPTER
ADAPTER
SWIVEL ADAPTER POINTS
UPWARD
ADAPTER
STRAIGHT TUBE
(As required)
SWIVEL
ADAPTER
UPPER
ELBOW
UPPER
ELBOW
4. Attach full elbow threaded joint onto straight tube. Continue
attaching Straight Tubes until the preferred length is acquired. Make sure all joints are screwed tightly into position
or the blower may vibrate and push tubes apart. (See illustration 4.)
CLAMP
WEAR EYE PRO TECTION!
LARGE
CLAMP
ADAPTER
KIT DOES NOT INCLUDE BLO WER
Loading...