Homedics SF-P1 Instruction Manual

Mail To:

HoMedics
Service Center, Dept. 168
3000 Pontiac Trail
Commerce Township, MI
48390

e-mail:
[e-mail]

ONE YEAR LIMITED WARRANTY
(Valid in USA only)

HoMedics, Inc., guarantees this product free from defects in materi­al and workmanship for a period of one year from the date of origi­nal purchase, except as noted below.

This HoMedics product warranty does not cover damage caused
by misuse or abuse; accident; the attachment of any unauthorized
accessory; alteration to the product; or any other conditions what­soever that are beyond the control of HoMedics. This warranty is
effective only if the product is purchased and operated in the USA.
A product that requires modification or adaptation to enable it to
operate in any country other than the country for which it was
designed, manufactured, approved and/or authorized, or repair of
products damaged by these modifications is not covered under
warranty. HoMedics shall not be responsible for any type of inci­dental, consequential or special damages. All implied warranties,
including but not limited to those implied warranties of fitness and
merchantability, are limited in the total duration of one year from
the original purchase date.

To obtain warranty service on your HoMedics product, either hand
deliver or mail the unit and your dated sales receipt (as proof of
purchase), postpaid, along with check or money order in the
amount of $5.00 payable to HoMedics, Inc. to cover handling.

Upon receipt, HoMedics will repair or replace, as appropriate, your
product and return it to you, postpaid. If it is appropriate to replace
your product, HoMedics will replace the product with the same
product or a comparable product at HoMedics’ option. Warranty is
solely through HoMedics Service Center. Service of this product by
anyone other than HoMedics Service Center voids warranty.

This warranty provides you with specific legal rights. You may have
additional rights which may vary from state to state. Because of
individual state regulations, some of the above limitations and
exclusions may not apply to you.

FFoorr mmoorree iinnffoorrmmaattiioonn rreeggaarrddiinngg oouurr pprroodduucctt lliinnee iinn tthhee UUSSAA,
pplleeaassee vviissiitt:: wwwwww..hhoommeeddiiccss..ccoom

©1999-2003 HoMedics, Inc. and its affiliated companies, all rights reserved. HoMedics®is a registered

trademark of HoMedics, Inc. and its affiliated companies. Body Basics and Smart-Foam

are trademarks of HoMedics, Inc. and its affiliated companies, all rights reserved.

m

,

IB-SFP1-A

BREAKTHROUGH TECHNOLOGY

™

SMART.FOAM

Instruction Manual and

Warranty Information

SMART-FOAM PILLOW SF-P1
SMART-FOAM ROLL SF-ROL
SMART-FOAM REST SF-NR
SMART-FOAM CUSHION SF-CUSH

TO USE SMART-FOAM CUSHION

Simply place Smart-Foam Cushion flat against the back of any chair and sit back
against it. The cushion’s larger curve should rest comfortably inside the lower lumbar
region of your back. Smart-Foam Cushion will conform to fit your back, properly
supporting your muscles as you work, read or rest. When you move, Smart-Foam
Cushion will automatically adjust to accommodate your new position. And because it
will return to its original shape after use, you can take Smart-Foam Cushion anywhere
and use it with any chair.

WARNING –
NEVER IMMERSE
SMART-FOAM
PRODUCTS IN
WATER. AVOID
USING EXCESS
WATER WHEN
CLEANING.

CAUTION –
PLEASE NOTE:

Avoid excessive squeezing,
twisting or wringing of
your Smart-Foam product
to prevent placing undo
stress on the zipper.

Smart-Foam Care

By its nature, Smart-Foam is a temperature-sensitive material. Therefore, your
Smart-Foam product may seem softer in warmer temperatures and harder when
the temperature is colder. Smart-Foam will naturally soften as it is exposed to your
body heat.

NOTICE – When new, Smart-Foam material may have a slight smell. It is completely
harmless and will disappear once the product has aired out.

SMART-FOAM CLEANING INSTRUCTIONS

Use a slightly damp cloth and mild soap to spot clean the exterior of your Smart-Foam
pillow or cushion. Do not soak this product. Avoid using excess water when cleaning
Smart-Foam.

CLEANING INSTRUCTIONS FOR COVER

Remove Smart-Foam cover and hand or machine wash in cold water with mild soap.
Do not bleach. Lay flat to dry or machine dry on delicate cycle. Iron, if needed, on
cotton setting.

5