READ ALL INSTRUCTIONS BEFORE USE.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
IMPORTANT SAFEGUARDS:
WHEN USING ELECTRICAL PRODUCTS, ESPECIALLY WHEN CHILDREN ARE PRESENT, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:
• Not for use by children.
• Keep dry - DO NOT operate in wet or mosit conditions.
• Use this appliance for the intended use as described in this booklet. DO NOT use attachments
not recommended by HoMedics.
• NEVER operate the appliance if it has a damaged cord or plug, if it is not working properly, if it
has been dropped or damaged, or dropped into water. Return it to the HoMedics Service Center
for examination and repair.
• Keep cord away from heated surfaces.
• NEVER drop or insert any object into any opening.
• DO NOT operate under a blanket or pillow. Excessive heating may occur and may cause fire or
injury to persons.
• DO NOT carry this appliance by the cord or use cord as a handle.
• This appliance is for household and indoor use only.
• DO NOT attempt to repair the appliance. There are no user serviceable parts. For service, send
to a HoMedics Service Center. All servicing of this appliance must be performed by authorized
HoMedics service personnel.
• Do not place or store appliance where it can fall or be pulled into a bath or sink. Do not place in
or drop into water or other liquid.
• Recycle or dispose of battery properly in accordance with all local, state, province, and country
regulations.
SAFETY CAUTIONS:
PLEASE READ THIS SECTION CAREFULLY BEFORE USING THE APPLIANCE.
• Ensure that your hands are dry when operating the controls or removing the plug.
• Do not look directly into the LED light.
• Do not damage, destroy, modify, forcefully bend, pull or twist the cable. Do not place or clamp
heavy objects on the charging cable.
• Turn o the appliance and unplug it from the power source when it is fully charged.
• Avoid placing the mirror near sharp objects to prevent any damage and scratches to the surface.
• Before using the power bank function, check the rated current of the mobile device. If the rated
current is less than 45mA, it is not recommended to use the LED mirror to charge it (ie, Bluetooth
headset, smartwatches, fitness bands, etc).
23
UNIQUE FEATURES &
HOW TO USE
SPECIFICATIONS
PHONE CHARGING PORT
Phone charging cable not included
1X AND 5X MAGNIFICATION
Choose from Standard and Close-up views
8 LED LIGHTS
Surrounds Mirror for even illumination
RECHARGEABLE
Mirror charging cable Included
POWER ON/OFF
BUTTON
LED LIGHTS
1X MAGNIFICATION
PHONE CHARGING PORT
CHARGING
CABLE
5X MAGNIFICATION
MIRROR CHARGING PORT
BEFORE TURNING THE UNIT ON
• Make sure the unit is fully charged
CHARGING THE BATTERY
Before turning the unit on, connect the unit to a power source or AC adapter by connecting the
charging cable to the charging port located on the side of the unit. A Blue LED indicator will blink
intermittently, indicating that charging is taking place. When charging is complete, the LED indicator will stop blinking and remain steady. It takes approximately 5 hours for a full charge, which will
provide up to 10 hours of use, if only using the LED light. When the battery is getting low, the blue
LED indicator will blink and then turn o, indicating that the unit needs to be recharged.
USING THE MIRROR
• Open the compact to expose the mirror and LED light.
• Press and hold the Power ON/OFF
• Press and hold the Power ON/OFF
the LED lights OFF.
• Close the mirror by pressing shut until it locks into position with a click.
PHONE CHARGING PORT
button for 3-seconds to turn the LED lights on.
button again for 3-seconds, or quickly press twice to turn
USING THE POWER BANK
• Connect the device to the power bank using your phone’s charging cable to the USB Phone
Charging port located on the side of the mirror.
• When charging electronic devices, the blue LED charging indicator will illuminate and stay lit.
• When the power is getting low, the blue LED will blink and turn o, indicating that the unit needs
to be recharged.
NOTE: Always disconnect the charging cable after you finish using the power bank function.
45
CLEANING AND CARE
CAUTION: before cleaning the unit, turn power o and remove from the charging base.
TO CLEAN THE SURFACE
Clean the surfaces of the unit as needed with a dry, soft cloth.
NOTE: Never use water, alcohol or abrasive cleansers to clean the
surface of the unit. Doing so will result in malfunction or discoloration
of the unit.
TO STORE
Store in a safe, dry place, out of reach of children.
TROUBLESHOOTING
PROBLEMPOSSIBLE CAUSESOLUTION
Unit will not operate• Unit is not charged• Charge the unit by connecting it to
The LED light is not
bright enough
• Unit is not fully charged• Fully charge the unit by connecting
the charging cord and plugging it
into a USB power source.
• Press and hold the POWER ON/OFF
button for 3-seconds to turn the
power on.
• Check circuits, fuses, try a different
outlet or USB power source.
it to the charging cord and plugging
it into a USB power source.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user authority
to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the
receive is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This class B digital device complies with Canadian ICES-003.
67
Loading...
+ 9 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.