PRE-OPERATING INSTRUCTIONS
1. Carefully remove your heater from the box. (please save the
carton for off-season storage).
2. Attach carr y handle with provided thumb screws. Please be
sure to tighten firmly (See fig. #1).
3. Make sure the unit is in the OFF position before plugging the
heater into the outlet.
4. Place heater on firm level surface.
5. Avoid overloading your circuit by not using other high
wattage appliances in the same outlet. At 1500 Watts, this
unit draws 12.5 Amps.
NOTE: THISUNITIS FOR FLOOR USE ONLY
OPERATING INSTRUCTIONS
1. For heater operation, please set the Temperature all the way
to HI. (See fig. #2 and #3)
2. Turn the Selector Control to desired heat setting (LO for
1350W or HI for 1500W).
3. The Power Light will remain lit during operation.
SETTING THE TEMPERATURE
1. You need to set temperature on HI to start heater (See fig.
#2 & 3). Allow heater to operate and warm up the room.
2. When the desired temperature/comfort level is reached,
lower the temperature setting until the heater stops
operating.
3. The control will now automatically maintain the pre-set
temperature level by turning the heater ON and OFF.
NOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling,
you need to raise the temperature setting.
CLEANING/MAINTENANCE
DURING SEASON CARE:
1. Always unplug the heater before cleaning.
2. Clean the unit with a soft cloth moistened with a mild soap
solution.
3. NEVER use abrasive or flammable solvents to clean the unit.
4. After cleaning, be sure to completely dry the unit with a cloth
or towel.
AFTER SEASON CARE:
1. Store heater in a cool, dry location
2. Holmes recommends that you store the unit in its original
carton.
TROUBLESHOOTING
If your heater fails to operate:
• UNPLUG THE UNIT
• Make sure the electrical outlet or circuit breaker is working.
• Check for obstructions. If you find an obstruction turn
the heater OFF, and unplug the unit. Carefully remove
the obstruction and follow the reset instructions.
• The temperature may be set too low. Turn the temperature
knob clockwise until the heater restarts.
• Make sure selector is in LO or HI setting.
Please DO NOT attempt to open or repair the heater.
Please see the Warranty for Service Instructions.
PLEASE READ AND SAVE THESE
IMPORTANT SAFETY INSTRUCTIONS
FEATURES - OPERATIONS
Figure 2
Figure 3
CONTROL PANEL CLOSE-UP
Figure 1
A
B
C
D
E
A
BC
A.Caution Light
B.Temperature
C. Selector/Power
Light
D.Protective
Front Guards
E. Carry Handle
A.Caution Light
B.Temperature
C. Selector/Power
Light
When using electrical appliances, basic safety precautions should
always be followed to reduce the risk of fire, electric shock, and
injury to persons, including the following:
1. Read all instructions before using the appliance.
2. To avoid fire or shock hazard, plug the appliance directly into
a 120 V AC electrical outlet.
3. The heater is hot when in use. To avoid burns, DO NOT let
bare skin touch hot surfaces. If provided, use handles when
moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least
3 ft (0.9 m) from the front of the heater and keep them
away from the sides and rear.
4. DO NOT run cord under carpeting. DO NOT cover cord with
throw rugs, runners , or the like. Arrange cord away from
traffic area and where it will not be tripped over.
5. This heater is not intended for use in bathrooms, laundr y
areas and similar indoor locations. NEVER locate heater
where it may fall into a bathtub or other water container.
6. Extreme caution is necessar y when any heater is used by, or
near children or invalids, and whenever the heater is left
operating and unattended.
7. Always unplug the heater when not in use.
8. When unplugging, be sure to pull by the plug and not the
cord.
9. DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock
or fire, or damage the heater.
10. DO NOT operate heater with a damaged cord or plug, or
after the heater malfunctions, has been damaged in any
manner. Return appliance to manufacturer for examination,
electrical or mechanical adjustment, or repair.
11. A heater has hot and arcing or sparking parts inside. DO
NOT use it in areas where gasoline, paint, or flammable liquids are used or stored.
12. Use appliance only for intended household use as described
in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by
The Holmes Group may cause hazards.
13. DO NOT use outdoors.
14. To prevent a possible fire, DO NOT block air intakes or
exhaust in any manner. DO NOT use on soft surfaces, like a
bed, where openings may become blocked.
15. To disconnect heater, turn controls to OFF, then remove plug
from outlet.
16. Avoid the use of an extension cord because the extension
cord may overheat and cause a risk of fire. However, if you
have to use an extension cord, the cord shall be No. 14 AWG
minimum size and rated not less than 1875 watts.
17. If the heater will not operate, see specific instructions on
Auto Safety Shut-off.
18. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void your warranty.
The inside of the unit contains no user serviceable parts. All
servicing should be performed by qualified personnel only.
19. Discontinue use if plug or outlet is hot. Recommend outlet be
replaced if plug or outlet is hot to touch.
PLEASE READ AND SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS
AUTO SAFETY SHUT-OFF WITH
INSTANT TIP-OVER PROTECTION
This heater is equipped with a Total Safety System with tip-over
protection that will shut-off the heater in an overheat
situation.
TIP-OVER SHUT-OFF:
When the unit is accidentally knocked over, it will shut off.
To reset, simply place the heater in an upright position
on a level surface.
OVERHEAT SHUT-OFF:
When a potential overheat temperature is reached, the system
will automatically shut the heater off and the caution light will
illuminate. Make sure heater is clear of all obstructions.
RESET INSTRUCTIONS:
This unit is equipped with an automatic reset feature. If the unit
shuts off, wait for it to cool down (5-10 minutes). When cool,
the unit will automatically restart.
THIS PRODUCT IS EQUIPPED WITH A POLARIZED AC
(Alternating Current) PLUG (a plug having one blade
wider than the other). This plug will fit into the power
outlet only one way. If the plug does not fit fully into the
outlet, reverse the plug. If it still does not fit, contact
qualified personnel to install the proper outlet.
DO NOT DEFEAT THE SAFETY PURPOSE OF THIS
POLARIZED PLUG IN ANY WAY