Should you have any questions about this product or its operation
please telephone our customer service helpline on 1300 716 188.
HOLMAN offer a 1 year replacement warranty from the original date of purchase.
HOLMAN offer no guarantee or compensation for subsequent damage
or waste of water.
It is the responsibility of the user to check that the product is
always operating satisfactorily.
To claim warranty the product MUST be returned with a copy of the original receipt.
We will honour all statutory guarantees that this product is of acceptable quality
(including that it is fit for purpose). Product images may change without notice.
Head Office / Service
11 Walters Drive, Osborne Park WA 6017
Ph: +61 8 9416 9999 Fax: +61 8 9416 9920
service@holmanindustries.com.au
www.holmanindustries.com.au
Copyright 2018 Holman Industries Product Code: GH1001
Instruction Manual
Walk-in Greenhouse
with Misting System
Caution
Ensure the greenhouse is secured to the ground with pegs or weights (not supplied).
Ensure weight is placed evenly on shelves to avoid the possibility of the greenhouse tipping
over. Ensure all poles and fittings are securely assembled prior to use. The method of
securing will depend on the ground surface. The greenhouse should not be left out in
windy conditions if it has not been secured to the ground. During extreme weather
conditions or high winds, ensure the greenhouse is moved to a sheltered area and
ensure it is secured to the ground using appropriate methods. The greenhouse
should be disassembled when not in use.
Maximum loading: 10kg for each shelf.
Before you Start
Check the pack contents before
attempting to construct the greenhouse.
The seedlings in your greenhouse
will want an outdoor full-sun to part-sun
position all year round, depending on the
climate of your location. This greenhouse
is easy to move (when empty) due to its
light weight, so moving it seasonally as
the weather changes is easily done.
Assembly
Assemble as shown on opposite page start with the base and work upwards.
Tools are not required - hand assembly is
suitable. We suggest wearing protective
gloves when assembling the greenhouse.
When fitting the cover, ensure the frame is
tightly pushed together and the door is
unzipped prior to sliding over the frame.
Failure to do so may cause damage to the
cover. Secure the cover to the frame with
the ties attached to the inside of the cover.
Misting System Connection
Connect up the black poly pipe using
the elbow and joiners to fit around the
indicated area of the frame (dashed line
on opposite page).
Trim the last piece of poly pipe to the
height of the Greenhouse and place the
supplied end cap onto one end of the poly
pipe and the snap on connector to the
other end. Attach a hose to the snap-on
connector.
Attach the poly pipe along the width of the
top most horizontal pole and adjoining
vertical poles with supplied clips, which
slot into each other.
To insert the sprayers, punch 6 holes along
the poly pipe as indicated on the opposite
page. Twist in the drippers with the yellow
end inside the poly pipe.
Care and Maintenance
Avoid very windy positions and spots
where the frame may stand in water
for long periods. Wash off heavy dirt
or dust deposits and remove bird
droppings with soapy water. The
cover may be removed from the
whole structure, disassembled and
stored when not in use.
2x 13mm x 700mm poly pipe
4x 13mm x 600mm poly pipe
1x 13mm compression snap-on coupling
2x 13mm compression joiners
3x 13mm compression elbows
2x 13mm compression end caps
6x 4mm punch
6x 4mm barbed misting spray jets
12 x 15mm frame connection clips
A
I
C
E
B
D
F
G
H
Misting kit placement
G
F
C
H
I
E
D
A
B
Misting system fittings
Greenhouse parts and fittings
Loading...