HobbyZone UM T-28 Trojan S Instruction Manual

Instruction Manual • Bedienungsanleitung • Manuel d’utilisation • Manuale di Istruzioni
®
UM T-28 Trojan S
RE
S
CU
E
EN
2
®
T-28 Trojan S
WARNING: Read the ENTIRE instruction manual to become familiar with the features of the
product before operating. Failure to operate the product correctly can result in damage to the product, personal property and cause serious injury.
This is a sophisticated hobby product. It must be operated with caution and common sense and requires some basic mechanical ability. Failure to operate this product in a safe and responsible manner could result in injury or damage to the product or other property. This product is not intended for use by children without direct adult supervision. Do not use with incompatible components or alter this product in any way outside of the instructions provided by Horizon Hobby, LLC. This manual contains instructions for safety, operation and maintenance. It is essential to read and follow all the instructions and warnings in the manual, prior to assembly, setup or use, in order to operate correctly and avoid damage or serious injury.
NOTICE
All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit www.horizonhobby.com and click on the support tab for this product.
Meaning of Special Language:
The following terms are used throughout the product literature to indicate various levels of potential harm when operating this product:
NOTICE: Procedures, which if not properly followed, create a possibility of physical property damage AND little or no possibility of injury.
CAUTION: Procedures, which if not properly followed, create the probability of physical property damage AND a possibility of serious injury.
WARNING: Procedures, which if not properly followed, create the probability of property damage, collateral damage, and serious injury OR create a high probability of superfi cial injury.
Safety Precautions and Warnings
• Always keep a safe distance in all directions around your model to avoid collisions or injury. This model is controlled by a radio signal subject to interference from many sources outside your control. Interference can cause momentary loss of control.
• Always operate your model in open spaces away from full-size vehicles, traffi c and people.
• Always carefully follow the directions and warnings for this and any optional support equip­ment (chargers, rechargeable battery packs, etc.).
• Always keep all chemicals, small parts and anything electrical out of the reach of children.
• Always avoid water exposure to all equipment not specifi cally designed and protected for this purpose. Moisture causes damage to electronics.
• Never place any portion of the model in your mouth as it could cause serious injury or even death.
• Never operate your model with low transmitter batteries.
• Always keep aircraft in sight and under control.
• Always use fully charged batteries.
• Always keep the transmitter powered on while aircraft is powered.
• Always remove batteries before disassembly.
• Always keep moving parts clean.
• Always keep parts dry.
• Always let parts cool after use before touching.
• Always remove batteries after use.
• Always ensure failsafe is properly set before fl ying.
• Never operate aircraft with damaged wiring.
• Never touch moving parts.
Age Recommendation: Not for children under 14 years. This is not a toy.
EN
3
T-28 Trojan S
Weight:
1.65 oz (47.0g) with battery
16.58 in (426mm)
13.5 in (343mm)
RTF Transmitter ........................................................................................................................................................... 4
Transmitter Batteries Installation .................................................................................................................................. 4
Transmitter Setup ........................................................................................................................................................ 4
Transmitter Setup ........................................................................................................................................................ 5
SAFE® Technology Flight Modes ................................................................................................................................... 6
Installing Landing Gear ................................................................................................................................................7
Settings for Control Horns ............................................................................................................................................ 7
Charging Warnings....................................................................................................................................................... 8
Charging the Flight Battery .......................................................................................................................................... 8
Installing the Flight Battery .......................................................................................................................................... 9
Binding ........................................................................................................................................................................ 9
Control Direction Test ................................................................................................................................................. 10
SAFE® Control Direction Test ...................................................................................................................................... 11
Flying ........................................................................................................................................................................ 11
Prefl ight Checklist ...................................................................................................................................................... 12
Takeoff ...................................................................................................................................................................... 12
Low Voltage Cutoff (LVC) ............................................................................................................................................ 13
Landing ..................................................................................................................................................................... 13
After Flying ................................................................................................................................................................ 13
Adjusting Trim in Flight .............................................................................................................................................. 14
Motor Service ............................................................................................................................................................ 15
Flying Tips ................................................................................................................................................................. 16
Optional First Person View (FPV) ................................................................................................................................. 16
Troubleshooting Guide ............................................................................................................................................... 17
Re-Binding the RTF Transmitter ................................................................................................................................. 17
Limited Warranty ....................................................................................................................................................... 19
Warranty and Service Contact Information ................................................................................................................. 20
FCC Information ......................................................................................................................................................... 20
IC Information ............................................................................................................................................................ 20
Compliance Information for the European Union ......................................................................................................... 20
Replacement Parts ..................................................................................................................................................... 81
Optional Parts ........................................................................................................................................................... 82
Table Of Contents
Components
RTF BNF Basic
Motor:
8.5mm Brushed Motor in Gearbox (EFLRMLP6)
Installed Installed
Receiver:
SAFE Receiver and ESC with Integrated Linear Servos (SPMA3185)
Installed Installed
Aileron Servo: Spektrum 2.3g Linear Long Offset (SPMSA2030LO)
Installed Installed
Battery:
3.7V 1S 150mAh 25C Li-Po (EFLB1501S25)
Included
Sold
Separately
Battery Charger:
USB Li-Po Charger, 300mA (EFLC10081S)
Included
Sold
Separately
Transmitter:
6-Channel (or more) 2.4GHz with Spektrum™ DSM2®/DSMX® technology. (EFLRMLP6)
Included
Sold
Separately
EN
4
®
T-28 Trojan S
Remove the battery cover. Install the four included batteries (noting proper polarity) and reinstall the battery cover.
RTF Transmitter
Low Battery Alarm
When the battery voltage drops too low, an alarm sounds and the LED fl ashes. The batteries must be replaced immediately. If this happens while fl ying, land your aircraft as soon and as safely as possible.
Transmitter Batteries Installation
Throttle / Rudder
Power LED
Battery Door
Power Switch
Elevator Trim Down
Aileron / Elevator
Aileron Trim Right
Elevator Trim Up
Aileron Trim Left
Throttle Trim Down
Rudder Trim left
Throttle Trim Up
Rudder Trim Right
Flight Mode Switch
Bind / Panic Recovery Trigger
Bind Button
Dual Rate Button
Mode 2 shown
DXe
®
Transmitter Setup
To use a Spektrum™ DXe transmitter, download the Hobbyzone® T-28 Trojan S DXe model setup available at www.spektrumrc.com or use the appropriate programming cable and the PC or mobile app to program the transmitter.
EN
5
T-28 Trojan S
IMPORTANT: The installed receiver has been
programmed for operation specifi cally in this aircraft.
To operate the SAFE® system in this aircraft, set up your optional DSM2
®
/DSMX® transmitter using the chart below.
- SAFE Flight mode is selected using Channel 5 signal (high, middle, low)
- Panic Recovery mode is selected with Channel 6 signal (high, low)
IMPORTANT: A transmitter with a 2-position Channel 5 switch will only allow the use of position 0 or position 2 fl ight modes. If possible assign Channel 5 in your transmitter to a 3-position switch to operate all 3 fl ight modes (refer to your transmitter manual).
Refer to your transmitter’s manual for more information about transmitter setup.
Non Computerized Transmitter Setup
(DX4e and DX5e)
Transmitter
SAFE mode switch
Panic Recov­ery Switch
SAFE Flight Modes Supported
Throttle, Aileron, Elevator and Rudder in Normal Position
DX4e (2pos switch)
ACT/AUX switch
Trainer Button
2 Pos Flight Mode
DX4e (3pos switch)
CH 5 switch
Trainer Button
3 Pos Flight Mode
DX5e (2pos switch)
CH 5 switch
Trainer Switch
2 Pos Flight Mode
DX5e (3pos switch)
CH 5 switch
Trainer Switch
3 Pos Flight Mode
Computerized Transmitter Setup
(DX6e, DX6i, DX6, DX7S, DX8, DX7 G2, DX8 G2, DX9, DX18 and DX20)
Start all transmitter programming with a blank model (do a model reset), then name the model.
Set Dual Rates to:
HIGH 100% LOW 70%
DX6i
1. Go to the SETUP LIST MENU
2. Set MODELTYPE: ACRO
3. Set REVERSE: Gear Channel
4. Go to ADJUST LIST MENU
5. Set TRAVEL ADJ: Gear/Fmode (0)100%; Gear/Fmode (1) 40%
6. Set FLAPS: Norm 100; LAND 100
7. Set MIX 1: ACT; Gear Gear ACT, RATE D 0%; U + 100%, SW MIX, TRIM INH Resulting
in:
The Gear and Mix switches operate the 3 SAFE modes Gear 0; Mix 0 = Beginner Mode Gear 1; Mix 0 = Intermediate Mode Gear 1; Mix 1 = Experienced Mode The Flap switch operates Panic Recovery. Position 0, Panic Recovery off, Position 1 Panic Recovery on.
DX7S DX8
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set SWITCH SELECT: Change all to INH then TRAINER: AUX1, FLAP: GEAR
4. Go to the FUNCTION LIST
5. Set SERVO SETUP: Reverse AUX1 Resulting
in:
Flap/Gyro Switch operates the 3 SAFE modes (0 Beginner/1 Intermediate/2 Experienced) The Trainer/Bind button operates Panic Recovery
DX6e DX6 G2, G3 DX7 G2 DX8 G2 DX9 DX18 DX20
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Go to CHANNEL ASSIGN: click NEXT to go to Channel Input Confi g: Set GEAR: D Set AUX1: i
4. Go to the FUNCTION LIST
5. Set SERVO SETUP: Reverse AUX1 Resulting
in:
Switch D operates the 3 SAFE modes (0 beginner/1 intermediate/2 Experienced) The Bind/I button operates Panic Recovery
Transmitter Setup
®
EN
6
®
T-28 Trojan S
Beginner Mode (with Self leveling):
Pitch (nose up and down) and Roll (wing tips up and down) angles are limited to help you keep the aircraft airborne. Release both sticks for self-leveling.
Intermediate Mode:
The pilot is only prevented from entering extreme fl ight conditions.
Experienced Mode:
Unlimited Flight Envelope
Panic Recovery Mode:
If you feel you have lost control in any mode, hold the Panic Recovery trigger. The SAFE technology will return the aircraft to a stable attitude (wings level with a slight climb). Always fl y at a safe altitude, as Panic Recovery may cause the aircraft to lose some altitude when leveling the wings. Release the Panic Recovery trigger to turn off Panic mode and return to the current SAFE fi ght mode.
RollPitch
RollPitch
RollPitch
Beginner Mode
(Switch Position 0)
Intermediate Mode
(Switch Position 1)
Experienced Mode (Switch Position 2)
NOTICE: If the aircraft is upside down when the Panic
Recovery trigger is pressed, suffi cient altitude is required
for the aircraft to return to straight and level fl ight.
1
2
0
SAFE® Technology Flight Modes
EN
7
T-28 Trojan S
Settings for Control Horns
The illustration shows factory settings for linkages on the control horns.
Rudder Elevator
1. Insert the main landing gear assemblies into the plastic brackets on the bottom of the wing with the struts toward the front of the wing.
Installing Landing Gear
2. Ensure the landing gear wires are fully inserted into the clip so the end of the wire snaps into place.
3. Insert the nose gear into the plastic nose gear mount on the bottom of the fuselage.
Loading...
+ 16 hidden pages