HMC Electronics ES111 User Manual
TDS# 1611
PRODUCT DESCRIPTION
Electro-Wash NX New & Improved!
Cleaner Degreaser is an extra strength,
nonflammable electronics cleaner and
degreaser. This high pressure aerosol
cleaning agent quickly removes oxide
particles, dust, oil and grease – evaporating
quickly without leaving residue.
Noncorrosive safe for metals
NSF K2 registered
Nonflammable
Fast drying
Removes oil, grease, dirt, silicone, flux,
adhesive and other contaminants
Contains no CFCs; contains HCFCs
May be used on energized equipment
Available with All-Way Spray valve
TYPICAL APPLICATIONS
Electro-Wash
NX New & Improved!
Cleaner Degreaser is engineered for
cleaning:
Circuit Breakers
Motors and Generators
Plugs and Sockets
Potentiometers
Relays and Contacts
Selector Switches
Solenoids
Switching Devices
TYPICAL PRODUCT DATA AND
PHYSICAL PROPERTIES
CHEMTRONICS
Technical Data Sheet
Electro-Wash NX New & Improved!
Cleaner Degreaser
Boiling Point
>99F Initial
Evaporation Rate (butyl acetate=1) >1
Flash Point (TCC) None
Specific Gravity 1.47
Vapor Pressure @68F 209 mm Hg
Odor
Ethereal
Solubility in Water
Negligible
Kauri-Butanol (KB) Number 56
NSF-Registered K2 #135674 (aerosol)
VOC* Content: Aerosol Liquid
CARB 73% 100 %
SCAQMD 68 g/L 1108 g/L
Federal 4.6% 86
%
RoHS Compliant
Shelflife Aerosols 5 years
Liquids 2 years after opening
*Volatile Organic Compound (VOC) information is calculated on a
weight basis using the VOC definition of California Air Resources
Board (CARB) Consumer Product Regulations, South Coast Air
Quality Management District (SCAQMD) Rule 102 and the Federal
definition published in 40 CFR 51.100(s).
COMPATIBILITY
Electro-Wash
NX New & Improved!
Cleaner Degreaser is generally compatible
with most materials used in printed circuit
board fabrication, except acrylics, ABS
resins, polycarbonates and polystyrenes.
With any cleaning agent solvent/component
compatibility must be determined on a noncritical area prior to use
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
http://www.hmcelectronics.com
(800) 482-4440
Material Compatibility
Buna-N Not Recommended
Graphite Good
HDPE Good
Kynar
Poor
LDPE Good
Lexan
Not Recommended
Neoprene Poor
Noryl
Poor
Cross-Linked PE Good
Polyacrylate Not Recommended
Polystyrene Not Recommended
PVC Poor
Silicone Rubber Not Recommended
Teflon
Good
Viton
Poor
Performance
Grease Removal per gram solvent (mg)
Electro-Wash NX
New & Improved!
14.06
HFC-based Cleaner
0.50.5
Grease & Lubricating Oil Removal per gram
solvent (mg)
Electro-Wash NX
New & Improved!
22.123.
823.8
HFC-based Cleaner
0.50.5
USAGE INSTRUCTIONS
For commercial use only.
Read MSDS carefully prior to use.
Spray 4-6 inches from surface to clean. Wash
parts from top to bottom, allowing the liquid to
flush away dirt and dissolved grease. For
precise application use attached extension tube.
TECHNICAL & APPLICATION
ASSISTANCE
ITW Chemtronics
provides a technical
hotline to answer your technical and
application related questions. The toll free
number is: 1-800-TECH-401.
AVAILABILITY
ES1611 12 oz. Aerosol
ES2211 18 oz. Aerosol
ES111 1 gallon Liquid
ENVIRONMENTAL IMPACT DATA
HCFC-141b
HCFC-225
None
Yes
HFC
nPB
Yes
None
Hydrochlorofluorocarbons (HCFCs) are regulated under the Montreal Protocol
as Class II ozone depleting substances. HCFC-141b is no longer produced in
the US under this legislation. HCFC-225 is planned for production phase-out
in 2015. Hydrofluorocarbons (HFCs) are not currently regulated.
EPA has listed n-propyl bromide (nPB) as an acceptable alternative to ozone
depleting substances in metal, precision, and electronics cleaning under Section
612 of the Clean Air Act.
NOTE:
This information is believed to be accurate. It is
intended for professional end users having the skills
to evaluate and use the data properly. ITW
CHEMTRONICS does not guarantee the accuracy
of the data and assumes no liability in connection
with damages incurred while using it.
Chemtronics and Electro-Wash are registered trademarks
of ITW Chemtronics. All rights reserved.
All other trademarks herein are trademarks or registered
trademarks of their respective owners.
MANUFACTURED BY:
ITW CHEMTRONICS
8125 COBB CENTER DRIVE
KENNESAW, GA 30152
1-770-424-4888
REV. C (04/09)
DISTRIBUTED BY:
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
http://www.hmcelectronics.com
(800) 482-4440
Loading...