2
When repairing or replacement of parts is required, make sure the service technician has
used the parts/components specified by the manufacturer or parts/components that have
the same charac t eristics as the orig i nal parts/co m ponents. Una u thorized
substitutions may result in risk of fire, electric shock or other hazards.
POWER SOURCE
Before connecting this product with AC outlet, do check and make sure the electric supply
voltage is as same as it is marked on the rear panel of this product.
WARNING: It's very dangerous to insert a power plug that has bare wire into an AC
outlet.
DECLARATION
This product does not contain any parts or components that can be repaired by
users themselves. If there is any malfunction, refer to this instruction or ask for
repair by a qualified service technician. Do not try to repair by yourself, otherwise
the manufacturer will not be responsible for any consequences resulted there from.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE 1:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2:
Any changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
FCC Warning
Warning