Page 1
Quick Installation Guide
Hitachi 3K8 Microdrive
Embedded Type PATA
Models:
HMS361008M5CE00
HMS361006M5CE00
HMS361004M5CE00
Handling precautions
• Do not seal the breather hole! Sealing the
breather hole may result in loss of data.
• Do not press on the drive! Do not apply any
force to the drive during handling or installation.
• Always handle the drive with care to prevent
damage from shock, vibration, or electrostatic
discharge (ESD).
• Handle the drive carefully by the edges. Do not
touch any exposed printed circuit board.
• Do not write on the label or remove it. Do not
apply additional labels.
• Do not drop the drive.
• Do not expose the drive to wet conditions.
• Do not place the drive near a strong magnetic
field.
• Do not expose the drive to extreme temperatures.
Mounting Recommendations
There are no screw holes or guide rails in the Microdrive 3K8 hard disk drive. Hitachi
recommends you secure the drive by placing it in a frame with snubbers as shown in the
diagram below. Hitachi GST will assist customers with mounting design.
Page 2
• To permit airflow, a 0.5mm gap on top and bottom should exist after device holding
drive is assembled.
• Give FPC (Flexible Printed Circuit) cable enough length to avoid excessive tension
under shock condition.
• Snubbers are available from 3
not produce any outgassing such as siloxane found in organic silicone oil.
• Do not cover breather hole
rd
parties such as EAR (www.earsc.com). Material should
Mechanical Dimensions
Connector Information
• Connector is 35 pin ZIF (SMT horizontal mount, gold plate) Hirose FH26 - 35S - 0.3SHW(05)
(http://www.hirose-connectors.com/products/FH26_1.htm)
• FPC 10.8 +- 0.05mm width, 0.2+-0.03mm thickness
• Maximum Length is 75mm
• Single sided FPC is recommended
• Follow Connector vendor recommendations on FPC design.
• Connector Pinout
Page 3
Electrical Information
• Power Supply to be 3.3V +5% - 15%, 70mV max ripple, 400mA capable
• Interface Signal Levels
Input High Voltage 2.0 min
Input Low Voltage 0.8 max
Output High Voltage 2.4 max
Output Low Voltage 0.5 min
Page 4
© Copyright Hitachi Global Storage
Technologies
Hitachi Global Storage Technologies
5600 Cottle Road
San Jose, CA 95193
Produced in the United States
11/05
All rights reserved
Microdrive
TM
is a trademark
of Hitachi Global Storage Technologies.
Other product names are trademarks or
registered trademarks of their respective
companies.
References in this publication to Hitachi Global
Storage Technologies products, programs or
services do not imply that Hitachi Global
Storage Technologies intends to make these
available in all countries in which Hitachi Global
Storage Technologies operates.
Product information is provided for information
purposes only and does not constitute a warranty.
Information is true as of the date of publication
and is subject to change. Actual results may
vary.
This publication is for general guidance onl y .
Photographs may show design models.
04 November 2005
Loading...