Hitachi CL-8800BF Instructions Manual

HITACHI HAIR CLIPPER

AC/RECHARGEABLE

00151852 56789XYZ5(K)EDCBA

3

mm

6

mm

9

mm

12

mm

- 1 -

Lubricating oil

Cleaning brush

Please be sure to attach during recharging
and after use to protect the blade.
Hold the center section and remove.

Cap

Blade

Switch

Body

Charge indicator lamp

Head

Cropped hair attachment

Names of Parts

Features

Cordless 5 hour charging/AC type.

Cutting length can be adjusted to 3mm, 6mm, 9mm and 12mm by using the
cropped hair attachments.

Since two Ni-cd-batteries are built in, the device can be used for about 60
minutes with a full charge.

S

L

- 2 -

After charging the unit, unplug adaptor and
power feed plug.

Do not pull on cord when removing power plug.

Do not charge the unit if room temperature
exceeds 40

℃ or drops below 0℃. Extreme

temperatures will shorten battery life.

3.

Standard charging time is 5 hours.

The unit can be operated for about 60 minutes on a full charge.

Do not use continuously for more than 20 minutes. To use for longer periods, stop
and allow to rest about 10 minutes and lubricate oil to the cutting edge. Continuous
use of the unit for over 20 minutes may cause deterioration of cutting performance.

Unit socket

Power feed plug

Insert adaptor plug into outlet.

During charging, the charge indicator lamp lights.

2.

1.

Procedure for Charging

Before using, first charge the unit or connect to AC outlet.

Preparations Before Using

- 3 -

Preparations Before Using

Guide groove of unit

Tab

Allow the unit to operate without actually
cutting for about 10 seconds and wipe off
any excessive lubricating oil.

4.

Align tabs of cutting edges with the unit
guide grooves and apply cutting edges to
the unit in direction of arrow.

3.

Apply 1 drop of lubricating oil at each of the
parts of the blade marked with an arrow.

Always lubricate oil before and after use. Cutting
performance deteriorates if edge is not oiled
properly. When doing more than one haircut in
one session, clean and lubricate oil edge once
after finishing each cut.

2.

Remove cutting edge in direction of arrow.1.

Before Using

As in the case of charging, insert power feed plug into unit socket and adaptor
plug into outlet. Wait 2 minutes and turn on switch.

Direct AC Power Source

- 4 -

Protrusion

Mounting hole

To remove the cropped hair
attach-ment, hold the corner of the
comb part and remove in the direction
of the arrow.

3.

Fit the cropped hair attachment
pro-trusion into the mounting hole of
the head unit until the attachment is
snapped on.

2.

The cropped hair attachments are available for 3mm/6mm cut and 9mm/12mm
cut.

The cutting length is indicated on the inside as well as on the side of the cropped
hair attachment.Install proper cropped hair attachment for the desired cutting length.

1.

To install the cropped hair attachments.

Turn on the switch.

Cutting Operation