Your new HITACHI COLOR TV incorporates a host of features designed to give you
excellent performance if you follow the instructions in this manual. We recommend that
you read the following instructions and "IMPORTANT SAFEGUARDS" notice before
turning on your TV set for the first time.
This television receiver will display television closed captio ning ( or ) in
accordance with paragraph 15.119 of the FCC rules.
IMPORTANT SAFEGUARDS
TABLE OF CONTENTS
IMPORTANT SAFEGUARDS ..................................................................................................................3
BEFORE OPERATING YOUR TV SET.................................................................................................11
HITACHI SERVICE HOTLINE ..............................................................................................................47
IMPORTANT SAFEGUARDS
IMPORTANT SAFEGUARDS
Follow all warnings and instructions marked on TV set.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended
to alert the user to the presence of uninsulated "dangerous voltage" within the TV set
enclosure that may be of sufficient magnitude to constitute a risk of electric shock to
persons.
The exclamation point within an equilateral triangle is intended to alert the user to the
presence of important operating and maintenance (servicing) instructions in the literature
accompanying the TV set.
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS TV SET TO RAIN OR
MOISTURE.
• There are no user serviceable parts inside the TV set.
• Never remove the back cover of the TV set, as this can expose you to a very high
voltage and other hazards.
• If the TV set does not operate properly, unplug the set and call your dealer or service
shop.
IMPORTANT SAFEGUARDS
WARNING:
POWER SOURCE:
This TV set operates only on AC 120 volts 60 Hz.
To prevent fire or shock hazard, connect this TV set to 120V AC 60Hz (house current)
ONLY. Never connect the TV to 50 Hz or DIRECT CURRENT POWER SOURCES.
This TV set is equipped with a polarized alternating current line plug (a plug having one
blade wider than the other).
This plug will fit into the receptacle only one way.
If you are unable to insert the plug fully into the receptacle, try reversing the plug.
If the plug should still fail to fit, contact a local electrician.
To prevent shock hazard do not use this polarized plug with an extension cord,
receptacle or other outlet unless the blades can be fully inserted to prevent blade exposure.
If the power cord or plug is damaged or frayed, unplug the TV set from the receptacle
and refer servicing to qualified service personnel.
To prevent fire or shock hazard, do not overload receptacle and extension cords.
• POLARIZED PLUG
• NO GOOD
INSTALLATION
ANTENNA
Unless your TV set is connected to a cable TV system or to a centralized antenna system,
a good outdoor color TV antenna is recommended for the best performance. However, if
you are located in an exceptionally good signal area that is free from interference and
multiple image ghosts, the indoor antenna may be sufficient.
LOCATION
Select an area where sunlight or bright indoor illumination will not fall directly on the picture
screen. Also, be sure that the location selected allows a free flow of air to and from the
perforated back cover of the TV set.
To prevent damaging the TV, do not leave the set in a place where the temperature
becomes too hot. For example, exposed to direct sunlight or near a heating device, etc.
VIEWING
This TV set may be viewed from any desired distance. Most viewers prefer a distance of
three to six feet or more, depending on screen size, for maximum eye comfort.
IMPORTANT SAFEGUARDS
NOTE: Model number and serial number are indicated on the back cover of the TV set.
HITACHI
SAFETY POINTS YOU SHOULD KNOW ABOUT
YOUR HITACHI TELEVISION RECEIV ER
CAUTION:
* Read all of these instructions.
* Save these instructions for later use.
* Follow all warnings and instructions marked on the television receiver.
Our reputation has been built on the quality, performance, and ease of service of
HITACHI television receivers.
Safety is also foremost in our minds in the design of these units. To help you operate
these products properly, this folder illustrates safety tips which will be of benefit to you.
Please read it carefully and apply the knowledge you obtain from it to the proper
operation of your HITACHI television receiver.
Please fill out your warranty registration ca rd at once and mail it to HITACHI. This will
enable HITACHI to notify you promptly in the improbable event that a safety problem
should be discovered in your model of product.
FOR YOUR PERSONAL SAFETY
1 This television set is equipped with a polarized alternating-current line plug (a plug
having one blade wider than the other). This plug will fit into the power outlet only one
way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try
reversing the plug. If the plug should still fail to fit, contact your electrician to replace
your obsolete outlet. Do not defeat the safety purpose of the polarized plug.
2 When the power cord or plug is damaged or frayed, unplug this television set from the
wall outlet and refer servicing to qualified service personnel.
3 Do not overload wall outlets and extension cords as this can result in fire or electric
shock.
IMPORTANT SAFEGUARDS
4 Do not allow anything to rest on or roll over the power cord, and do not place the TV
where the
power cord is subject to traffic or abuse. This may result in a shock or fire hazard.
5 Do not attempt to service this television set yourself as opening or removing covers
may expose you to dangerous voltage or other hazards. Refer all servicing to qualified
service personnel.
6 Never push objects of any kind into this television set through cabinet slots as they
may touch dangerous voltage points or short out parts that could result in a fire or
electric shock. Never spill liquid of any kind on the television set.
7 If the television set has been dropped or the cabinet has been damaged, unplug this
television set from the wall outlet and refer servicing to qualified service personnel.
8 If liquid has been spilled into this television set, unplug it from the wall outlet and refer
service to qualified service personnel.
9 Do not subject your television set to impact of any kind. Be particularly careful not to
damage the picture tube surface.
10 Unplug this television set from the wall outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. Use a damp cloth for cleaning.
11-1 Do not place this television set on an unstable cart, stand, or table. The television
set may fall, causing serious injury to a child or an adult, and serious damage to the
appliance. Use only with a cart or stand recommended by the manufacturer, or sold with
the television set. Wall or shelf mounting should follow the manufacturer's instructions,
and should use a mounting kit approved by the manufacturer.
IMPORTANT SAFEGUARDS
11-2 An appliance and cart combination should be moved with care. Quick stops,
excessive force, and uneven surfaces may cause the appliance and cart combination to
overturn.
PROTECTION AND LOCATION OF YOUR SET
12 Do not use this television set near water... for example, near a bathtub, washbowl,
kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, etc.
• Never expose the set to rain or water. If the set has been exposed to rain or water,
unplug the set from the wall outlet and refer to servicing personnel.
13 Choose a place where light (artificial or sunlight) does not shine directly on the
screen.
14 Avoid dusty places, since accumulated dust inside the chassis may cause failure of
the set when high humidity persists.
15 The set has slots, or openings in the cabinet for ventilation purposes, to provide
reliable operation of the receiver, and to protect from overheating. These openings must
not be blocked or covered.
• Never cover the slots or openings with cloth or other material.
• Never block the bottom ventilation slots of the set by placing it on a bed, sofa, rug, etc.
• Never place the set near or over a radiator or heat register.
• Never place the set in a "built-in" enclosure, unless proper ventilation provided.
PROTECTION AND LOCATION OF YOUR SET
IMPORTANT SAFEGUARDS
16-1 If an outside antenna is connected to the television set, be sure the antenna
system is grounded so as to provide some protection against voltage surges and built
up static charges, Section 810 of the National Electrical Code, NFPA No. 70-1975,
provides information with respect to proper grounding of the mast and supporting
structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding
conductors, location of antenna discharge unit, connection to grounding electrode, and
requirements for the grounding electrode.
Click to see antenna grounding diagram.
16-2 Note to CATV system installer: (Only for the television set with CATV reception) This
reminder is provided to call the CATV system installer's attention to Article 820-40 of the
NEC that provides guidelines for proper grounding and, in particular, specifies that the
cable ground shall be connected to the grounding system of the building, as close to the
point of cable entry as practical.
IMPORTANT SAFEGUARDS
17 An outside antenna system should not be located in the vicinity of overhead power
lines or other electrical lights or power circuits, or where it can fall into such power lines
or circuits. When installing an outside antenna system, extreme care should be taken to
keep from touching such power lines or circuits as contact with them might be fatal.
18 For added protection for this television set during a lightning storm, or when it is left
unattended and unused for long periods of time, unplug it from the wall outlet and
disconnect the antenna. This will prevent damage due to lightning and power-line
surges.
OPERATION OF YOUR SET
19 This television set should be operated only from the type of power source indicated
on the marking label. If you are not sure of the type of power supply at your home,
consult your television dealer or local power company. For television sets designed to
operate from battery power, refer to the operating instructions.
20 If the television set does not operate normally by following the operating instructions,
unplug this set television set from the wall outlet and refer servicing to qualified service
personnel. Adjust only those controls that are covered in the operating instructions as
improper adjustment of other controls may result in damage and will often require
extensive work by a qualified technician to restor e the television set to normal operation.
21 When going on a holiday: If your television set is to remain unused for a period of
time, turn the television set "off" and unplug it from the wall outlet.
IMPORTANT SAFEGUARDS
IF THIS SET DOES NOT OPERATE PROPERLY
22 If you are unable to restore normal operation by following the detailed procedure in
your operating instructions, do not attempt any further adjustment. Unplug the set and
call your dealer or service technician.
23 Whenever the television set is damaged or fails, or a distinct change in performance
indicates a need for service, unplug the set and have it checked by a professional
service technician.
24 It is normal for some TV sets to make occasional snapping or popping sounds,
particularly when being turned on or off. If the snapping or popping is continuous or
frequent, unplug the set and consult your dealer or service technician.
FOR SERVICING AND MODIFICATION
25 Do not use attachments not recommended by the television set manufacturer as
they may cause hazards.
26 When replacement parts are required, be sure the service technician has used
replacement parts specified by the manufacturer that have the same characteristics as
the original part. Unauthorized substitutions may result in fire, electric shock, or other
hazards.
27 Upon completion of any service or repairs to the television set, ask the service
technician to perform routine safety checks to determine that the television is in safe
operating condition.
BEFORE OPERATING YOUR TV SET
BEFORE OPERATING YOUR TV SET
ANTENNA CONNECTIONS
These sets are equipped with one VHF/UHF terminal can be used for normal TV, cable
TV (CATV), a TV game, etc.
1. VHF (75 ohm) antenna/CATV
When using a 75 ohm coaxial cable system, disconnect the VHF adaptor from the VHF
75 ohm receptacle and connect the outdoor antenna or CATV cable to a VHF 75 ohm
receptacle
2. VHF (300-Ohm) antenna/UHF antenna
When using a 300-Ohm twin lead from an outdoor antenna, disconnect the (VHF or
UHF) indoor antenna leads from screws of the (VHF or UHF) adapter, and connect
outdoor (VHF or UHF) antenna leads to these screws of a (VHF or UHF) adapter.
3. When both VHF and UHF antennas are connected
Attach an optional ANT. MIXER to the TV antenna terminal, and connect the cables to
the ANT. MIXER.
Notes
BEFORE OPERATING YOUR TV SET
1. If an outdoor antenna/CATV is to be used, disconnect the indoor antenna. Do not leave
both the indoor and outdoor antennas/ CATV connected at the same time, since ghosting
and poor reception may result.
2. Consult your dealer or service store for the ANT. MIXER of VHF adaptor.
3. The special converter (decoder) will be supplied by the cable company.
LOCATION OF CONTROLS
LOCATION OF CONTROLS
Details are described on the page shown by the number attached to the part name
(example: ).
Front view illustration
Rear view illustration
NOTE: For 27AX0B (S-in Video not available.)
FRONT PANEL JACKS AND CONNECTIONS
FRONT PANEL JACKS AND CONNECTIONS
• The front panel jacks are provided as a convenience to allow you to easily connect a
camcorder or VCR as shown in the following examples.
Front panel connections illustration
NOTE:
• Completely insert the connection cord plugs when connecting to front panel jacks. If you
do not, the played back picture may be abnormal.
• If you have an S-VHS VCR, use the S INPUT cable in place of the standard video cable.
HOW TO SELECT CHANNELS
HOW TO SELECT CHANNELS
TURNING THE SET ON - POWER BUTT ON
Push the POWER BUTTON to turn the set ON. (To turn the set OFF, push the POWER
BUTTON again.)
VOLUME CONTROL - VOLUME CONT ROL
Push the right side (
: UP ) of the VOLUME BUTTON to make the sound louder, and
the left side ( : DOWN ) of the VOLUME BUTTON to make the sound softer.
Variation of the volume is displayed in the lower part of the screen by the color bar. (Fig.
1)
FUNCTION SELECTION - AVX BUTTON
Every time the AVX BUTTON is pressed, the set alternates between the TV mode and
and AVX mode. To watch the TV, set to the TV mode. At this time, the channel number
is displayed in the upper right of the screen. To enjoy a VCR, set to the VIDEO mode.
See page 14.
CHANNEL SELECTION - CHANNEL BUTTON
Channel selection may be performed by pressing either the CHANNEL BUTTON UP
) or DOWN (). When pressing the right side ( : UP ) of the CHANNEL BUTTON,
(
the next higher channel is selected. When pressing the left side (
: DOWN ) of the
CHANNEL BUTTON, the next lower channel is selected. The No. of the channel to
which the TV is tuned is displayed in the upper right of the screen. (Fig. 2)
The channel No. selected is displayed for approx. 8 seconds after changing channels
and disappears automatically.
(When the set is turned ON, the channel No. is displayed on the screen for approx. 15
seconds.)
Loading...
+ 32 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.