Hilti CI 060 INSTALLATION
7
.2.2 RM 700 EP Epoxy Repair Mortar
C
onstruction Chemicals
Construction Chemicals
7.2.1 Cl 060 Crack Injection System
7.2.1.4 Installation Instructions
1. Clean surface along the
crack. Blow out crack
with dry and oil-free
compressed air.
2. Bond injection ports
with CI 070 EP Crack
Sealing Compound.
Port spacing approximately 6" to 12" with
wider spacing for
thinner slabs.
3. Seal the crack with CI
070 EP surface sealing
compound in strips of
minimum 2" wide, 1/8"
deep. (Seal both sides if
crack goes completely
through concrete.)
4. A light tap with a hammer to the rear end of the
CI 060 EP cartridge
breaks the internal glass
cylinder, releasing the
hardener. Mix by seesaw motion for approximately 30 motions.
Do not shake.
5. Puncture the seal of the
cartridge tip. Then
screw
on connection hose.
6. Plug connection hose to
bottom port. Place air
relief stopper in next
port above.
7.2.1.5 Ordering Information*
Item No. Description
00220244 CI 060 EP Kit
Includes: 172 in3injection epoxy, 30 ports with non-return valves,
6 connection hoses with non-return valves, 4 air relief stoppers
00225491 CI 070 EP Surface Sealing Compound (1 quart)
00225493 CI 070 EP Surface Sealing Compound, Case of 4 quarts
00020132 Bag of 30 ports with non-return valves
00020133 Bag of 6 connection hoses with non-return valves
00020134 Bag of 4 air relief stoppers
00055205 CB 200 PI dispenser (fully enclosed)
00024825 Adhesive dispenser for 10.5 oz tubes
7. Inject CI 060 EP resin
until it appears visibly in
the next port above.
Remove air relief stopper (non-return valve is
now closed) and insert
into next port. Continue
injecting into original
port until the port
accepts no more resin
(when normal hand
pressure is used on the
dispenser).
8. Detach connection hose
from port and plug to
the next higher port.
Repeat operating steps
6 and 7 up to the end of
the crack.
9. After the injection resin
has set, generally over
night, the ports and the
sealing compound can
be removed with a flat
chisel. If required, the
surface can be ground
even.
*Not available in Canada
328 Hilti, Inc. (US) 1-800-879-8000 | www
.us.hilti.com
I en español 1-800-879-5000 I Hilti (Canada) Corp. 1-800-363-4458 I www
.ca.hilti.com
I Pr
echnical Guide 2006
oduct T
Loading...