HID EIM-M Installation Guide

EDGE EVO

15370 Barranca Parkway Irvine, CA 92618-2215 USA

Designed for interfacing to general purpose inputs typically not associated with standard access point control, the Input Module provides an interface

to four input analog/digital inputs. The module is always congured as

general purpose input.

Speciﬁcations

CONDITIONS VOLTAGE DC (VDC) CURRENT (Amp) POWER (W)

DC Input (NSC)

DC Input (MAX)

Inputs

Supervised Inputs (MAX) 0 to 5 VDC Reference 0.005 Amp (Sink) 0.025

+12VDC 0.03 Amp 0.36

+24VDC 0.03 Amp 0.72

+12VDC 0.04 Amp 0.48

+24VDC 0.04 Amp 0.96

OPERATING TEMPERTURE

32° - 122°F

(0° - 50° C)

Wiring

Hi-O Group Select Jumper

Short = Group 1, Open = Group 2

( )

Outside Door Inside Door

Input Module

InstallatIon GuIde

CABLE LENGTH

Input Circuits

500 ft (150 m) = 22 AWG ● 0.65mm ● 0.33mm

18 AWG ● 1.02mm ● 0.82mm

Hi-O CAN Bus Total Length 100 ft (30 m) -

22 AWG ● 0.65mm ● 0.33mm

Maximum between drops 30 ft (10 m)

22 AWG ● 0.65mm ● 0.33mm

NSC = Normal Standby Condition

EIM-M

82340-901, Rev C.2

March 2013

UL REFERENCE NUMBER

MEIMAxNN

X = K for Black G for Gray

Optional Supervised Inputs

10 P3 1

Input 1 Input 2

-+-+-+

* Internal Optical Tamper Disable Jumper

Internal Optical Tamper

To disable the internal optical tamper sensor, attach a jumper wire from P3 pin 1 to P3 pin 2.

Input 3 Input 4

4 P1 1

CAN V+ GND CAN H CAN L

CANbus

1-6K

N/O

N/C

1-6K N/O

Note: If desiring an external tamper, wire an unsupervised Normally Closed contact, and replace the jumper.

Regulatory

Connect only to a Listed Access Control / Burglary power-limited power supply, or Listed Access Control / Burglary PoE (Power-over-Ethernet) adapter. All National and local Electrical codes apply. Install in accordance with NFPA70 (NEC), Local Codes, and authorities having jurisdiction. Indoor use only. EDGE EVO Modules are UL Listed for installation within a protected area. Mount onto UL Listed Single-Gang electrical box. All panic and alarm hardware and equipment shall be UL Listed. All cabling and wire shall be UL Listed or Recognized and suitable for the application. All splices and connections shall be mechanically secure and bonded electrically. For operation, testing and maintenance, refer to the EDGE EVO Hi-O Networked Controller & Reader and Standard Networked Controller Installation Guide, 82000-920.

CAUTION: Any changes or modifcations to this devise not explicitly approved by the manufacturer could void your authority to operate this equipment.

FCC

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Canada Radio Certification

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

CE MARKING

HID Global hereby declares that these proximity readers are in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. The controller portion is in compliance with the essential requirements and other relevant provision of Directive 2004/108/EC.

JAPAN MIC

この装置は認証済みです。

TAIWAN NCC

經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。

According to «Administrative Regulations on Low Power Radio Waves Radiated Devices» without permission granted by the NCC, any company, enterprise, or user is not allowed to change frequency, enhance transmitting power or alter original characteristic as well as performance to an approved

low power radio-frequency devices. The low power radio-frequency devices shall not inuence aircraft security and interfere legal communications; If found,

the user shall cease operating immediately until no interference is achieved. The said legal communications means radio communications is operated in compliance with the Telecommunications Act.

The low power radio-frequency devices must be susceptible with the interference from legal communications or ISM radio wave radiated devices.

ACCESS experience.

HID Global

North America

15370 Barranca Parkway Irvine, CA 92618 USA Phone: 800 237 7769 Fax: 949 732 2120

HID GLOBAL, HID, the HID logo, EDGE EVO and Hi-O are the trademarks or registered trademarks of HID Global Corporation, or its licensors, in the U.S. and other countries.

Asia Paciﬁc

19/F 625 King’s Road NorthPoint, Island East Hong Kong Phone: 852 3160 9800 Fax: 852 3160 4809

support.hidglobal.com

hidglobal.com

82340-901 Rev C.2

Patent Pending

Check reader label for current regulatory approvals.

Europe, Middle East & Africa

Phoenix Road Haverhill, Suolk CB9 7AE England Phone: +44 1440 714 850 Fax: +44 1440 714 840