Hewlett Packard AZ872AR Quick Start Guide

HP TFT7600 Rackmount Keyboard and Monitor

Installation Instructions

Audience assumptions

This document is for the person who installs racks and rack products. This procedure is performed only by trained personnel. HP assumes you are qualified in performing installations and trained in recognizing hazards in rack products.

only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.

November 2005 (First Edition) Part Number 365379-001

Installing the HP TFT7600

About this device

The TFT7600 Rackmount Keyboard and Monitor (RKM) is a rack-mountable 1U integrated flat-panel monitor, with a

43.18-cm (17-in) color-active matrix Thin Film Transistor (TFT) Liquid Crystal Display (LCD), and keyboard with hotkeys and track pad.

NOTE: 1U = 1.75 inches or 4.45 cm

The TFT7600 RKM is mounted on rails with space available to add a 1U KVM switch box behind the unit.The TFT7600 RKM can be used with all HP 5000 and HP 10000 Series racks.

Kit contents

The kit contains:

• TFT7600 RKM (1)

• M6 screws (4)

• 6-32 screws (5)

•

HP 1U Adjustable Toolless Rails (2)

• Cable management arm, power adapter with brace

rail (1)

• Lock plates (2)

• USB cables (2)

• PS2 cables (2)

• Video cable

• Power cords (2)

• USB cable labels

• Documentation

RKM

1. Align the HP 1U Adjustable Toolless Rails with the

holes marked on the rack, and snap them into place.

a. Snap one end of the HP 1U Adjustable Toolless

Rails into the Retma rails.

b. Extend the other half of the HP 1U Adjustable

Toolless Rails to meet the appropriate rack depth, and snap them into place.

NOTE: If the HP 1U Adjustable Toolless Rails do not

snap into place, be sure that they align with the holes marked on the rack. The holes marked on the rack must be in the same location for the front and rear of the rack.

2. Extend the inner slides until they lock into place.

3. Align the unit with the extended inner slides, inserting

the unit into the rack.

This kit contains extra hardware for your convenience.

Rack warning

WARNING: To reduce the risk of personal

injury or damage to the equipment, be sure that:

• The leveling feet are extended to the floor.

• The full weight of the rack rests on the leveling feet.

• The stabilizing feet are attached to the rack if it is a single-rack installation.

• The racks are coupled together in multiple-rack installations.

• Only one component is extended at a time. A rack may become unstable if more than one component is extended for any reason.

• Only racks of the same series, height, and depth are bayed together.

+ 1 hidden pages