Henny Penny MP-941, MP-942, MP-943, MP-944 Installation Manual

Model MP-941/942/943/944

SECTION 2. INSTALLATION

2-1. INTRODUCTION This section provides the installation instructions for

the Henny Penny Multipurpose Holding Cabinet.

Installation of this unit should be performed by a
qualified service technician.

Do not puncture the skin of unit with drills or
screws as component damage or electrical shock
could result.

2-2. UNPACKING The Henny Penny Multipurpose Holding Cabinet has been

tested, inspected, and expertly packed to ensure arrival at
its destination in the best possible condition. The cabinet
rests on cardboard pads that sit on a wooden skid. The unit
is then packed inside a heavy cardboard carton with
sufficient padding to withstand normal shipping treatment.

Any shipping damages should be noted in the
presence of the delivery agent and signed prior to
his or her departure.

To remove the unit from the carton, you should:

1. Carefully cut banding straps.

2. Lift carton off the unit.

3. Lift the unit from the cardboard pads and skid.

Take care when lifting unit to prevent personal

injury. The units can weigh as much as 278 lbs.
(126 kg).

203

2-1

Model MP-941/942/943/944

2-2. UNPACKING (Continued) 4. Open drawers and remove the packing or literature

that is inside.

5. Pull off any protective covering from the exterior of
the cabinet.

6. Your multipurpose holding cabinet is now ready

for location and setup.

2-3. ELECTRICAL The multipurpose holding cabinets are available from
the factory as 120 VAC for domestic use, or 230 VAC
for international use. The units are single phase and
require a grounded (earthed) receptacle with a separate
electrical line protected by a fuse or circuit breaker of
the proper rating.

The electrical plugs for the 230 volt units must be
supplied by the distributor and have the proper
DATA TABLE: grounding (earthing).

Model

Number Volts Phase Watts Amps
MP-941 120 1 475 3
MP-942 120 1 950 6
MP-943 120 1 1425 9
MP-944 120 1 1900 12
MP-941 230 1 475 2
MP-942 230 1 950 4
MP-943 230 1 1425 6
MP-944 230 1 1900 8

To avoid electrical shock, the cabinet must be
adequately and safely grounded (earthed)
according to local electrical codes.

(FOR EQUIPMENT WITH CE MARK ONLY!)
To prevent electric shock hazard this appliance
must be bonded to other appliances or touchable
metal surfaces in close proximity to this
appliance with an equipotential bonding
conductor. This appliance is equipped with an
equipotential lug for this purpose. The
equipotential lug is marked with the following

symbol

After the multipurpose holding cabinet has been set into
position and leveled, run a bead of silicone rubber
(silicone or equivalent sealant must be a NSF listed
material) around the perimeter of the unit sealing it to
the surface. You are now ready to make the electrical
connections to the unit.

2-2 208