Henny Penny 941 Parts List

Model MP-941/942/943/944

SECTION 2. PARTS INFORMATION

2-1. INTRODUCTION This section identifies and lists the replaceable parts of the

Henny Penny Multipurpose Holding Cabinets.

2-2. GENUINE PARTS Use only genuine Henny Penny parts in your cabinet.
Using a part of lesser quality or substitute design may result
in cabinet damage or personal injury.

2-3. HOW TO ORDER Once the part you want to order has been found in the Parts
List, write down the following information:

1. From the Parts List:
(Sample)
Item Number 1
Part Number 51718
Description Gasket – Drawer

2. From the data plate:
(Sample)
Product Number 05882
Serial Number 0001
Voltage 120V

2-4. PRICES Your independent Henny Penny distributor has a price parts

list and will be glad to inform you of the cost of your parts
order.

2-5. DELIVERY Commonly replaced items are stocked by your independent

Henny Penny distributor and will be sent out when your
order is received. Other parts will be ordered by the
distributor from Henny Penny Corporation. Normally,
these will be sent to your distributor within three working
days.

2-6. WARRANTY All replacement parts (except lamps and fuses) are covered

under warranty for 90 days against manufacturing defects
and workmanship. If damage occurs during shipping,
notify the carrier at once so that a claim may be properly
filed. Refer to warranty on the front of this section for
other rights and limitations.

2.7. RECOMMENDED

SPARE PARTS FOR distributor, are indicated with √ in the parts lists. Please
DISTRIBUTORS use care when ordering recommended parts, because all
voltages and variations are marked. Distributors should
order parts based upon common voltages and equipment
sold in their territory.

106 2-1

Recommended replacement parts, stocked by your

Model MP-941/942/943/944

Figure 2-1. Shell and Drawer

2-2 204

Model MP-941/942/943/944

FIG. &
ITEM QTY QTY QTY QTY
NO. PART NO. DESCRIPTION 941 942 943 944

2-1 SHELL AND DRAWER
1 51514 SHELL ASSY. - 941 1 - - ­ 1 52626 SHELL ASSY. - 942 - RH - 1 - ­ 1 52649 SHELL ASSY. - 942 - LH - 1 - ­ 1 52650 SHELL ASSY. - 943 - RH - - 1 ­ 1 52651 SHELL ASSY. - 943 - LH - - 1 ­ 1 52652 SHELL ASSY. - 944 - RH - - - 1
1 52653 SHELL ASSY. - 944 - LH - - - 1
2 SC01-034 SCREWS 10 10 10 10
3 PL01-014 PLUG - 1 1/16” 2 3 3 1
4 51306 PANEL - ACCESS - RH 1 1 1 ­ 4 51912 PANEL - RH - SIDE ACCESS - 944 - - - 1

√ 5 51718 GASKET - DRAWER 1 2 3 4

6 49548 DRAWER ASSY. 1 2 3 4
7 49554 . DRAWER FRONT ASSY. 1 2 3 4
8 SC02-016 . SCREW, FRONT RETAINING 5 10 15 20
9 49550 . DRAWER WELD ASSY. 1 2 3 4
10 31395 . DRAWER HANDLE 1 2 3 4
11 SC01-144 . SCREW, HANDLE RETAINING 2 4 6 8
12 51497 . SLIDE VENT 1 2 3 4
13 27501 . MOLDED BLOCK - VENT 1 2 3 4
14 NS02-006 . NUT 3 6 9 12
15 26411 FOOT 4 4 5 ­ 16 51503 BASE ASSY. - 941 1 - - ­ 16 53639 BASE ASSY. - 942 - RH - 1 - ­ 16 52640 BASE ASSY. - 942 - LH - 1 - ­ 16 52641 BASE ASSY. - 943 - RH - - 1 ­ 16 52642 BASE ASSY. - 943 - LH - - 1 -

√ 17 14113 BEARING KIT 1 2 3 4

18 51505 LINER WELD ASSY. 1 2 3 4
19 NS02-002 NUT 4 8 12 16
20 52131 LINER - TOP STUD ASSY. 1 2 3 4
21 51097 PANEL - ACCESS - LH 1 1 1 ­ 21 51912 PANEL - ACCESS - LH - - - 1
22* 52701 DECAL - TEMP. CALIBRATION 1 1 1 1

recommended parts

√

*not shown

106 2-3

Model MP-941/942/943/944

Figure 2-2. Heater and Cover Plate

2-4 204