Henny Penny 680 Installation Manual

1. Cut and remove the metal bands from the carton.

2. Remove the carton lid and lift the main carton off the
fryer.

3. Remove corner packing supports (4).

4. Cut and remove the metal bands holding the fryer to the

-

Do not unlatch the lid before completion of steps 5,6,
and 7.

5. Remove the fryer from the pallet. See page 2-3.

The fryer weighs approximately 600 lbs. (270 Kg).

Extreme care should be taken when moving the fryer

to prevent personal injury.

6. Remove rear cover.

The weights for the counterweight are shipped in a
separate box under the unit.

7. Load the Counterweight Assembly. See page 2-4.

8. Replace rear cover.

9. Cut warning tags from the lid assembly. The lid may now
be unlatched.

10. Prepare the deadweight valve for operation.

The metal shipping support is placed inside the
deadweight valve housing to protect the orifice and
weight during shipment. This support must be removed
prior to installation and start-up.

A. Unthread the top cap.
B . Remove the round weight.

C. Remove and discard the shipping support.
D. Clean the orifice with a dry cloth.
E. Replace the weight and secure the top cap.

11. Open lid and remove packing and racks from inside of
cookpot.

12. Remove the protective paper from the fryer cabinet. It
is necessary to clean exterior surface with a damp cloth.

5 ROLL UNIT OFF

0

PALLET ONTO RAMP.

ORIENT CASTERS IN SIDEWAYS
POSITION.
8 KNOCK OUT RUBBER PADS (2). ­TYPICAL BOTH SIDES

RAISE SIDE SLIGHTLY

REMOVE REAR COVER ­WEIGHT SEGMENTS
MUST BE INSTALLED

PER INSTRUCTIONS
CONTAINED THEREIN
BEFORE ATTEMPTING
TO UNLATCH LID.

1 REMOVE ACCESSORY

f-0

BOXES FROM FRONT.

HH

BA5KET D TRAYS

PROP UP A RAMP FOR EACH
CASTER ON THE SELECTED SIDE.