Henny Penny 581 Installation Manual

1. Cut and remove the metal bands from the carton.

2. Remove the carton lid and lift the main carton off the
fryer.

3. Remove corner packing supports (4).

4. Cut and remove the metal bands holding the fryer to the
pallet.

Do not unlatch the lid before completion of steps 5, 6,
and 7.

5. Remove the fryer from the pallet. See page 2-2.

The fryer weighs approximately 600 lbs. (273 KG).
Extreme care should be taken when moving the fryer
to prevent personal injury.

6. Load the Counterweight Assembly. See page 2-3.

7. Replace rear cover.

8. Cut warning tags from the lid assembly. The lid may now
be unlatched.

9. Prepare the deadweight valve for operation.

The metal shipping support is placed inside the
deadweight valve housing to protect the orifice and
weight during shipment. This support must be removed
prior to installation and start-up.

A. Unthread the top cap.

m

B. Remove the round weight.
C. Remove and discard the shipping support.
D. Clean the orifice with a dry cloth.
E. Replace the weight and secure the top cap.

10. Unpacking is complete.

a:‘,‘:!:,!>j)

4S$~@b

11. Open lid and remove packing racks from inside of cookpot.

12. Remove the protective paper from the fryer cabinet. It
is necessary to clean exterior surface with a damp cloth.

WARN I NG

THE FRYER WEI+S APPROXlMATELY 600 L6S.

(273 KG).

WHEN MOVING THE FRYER TO PREVENT
PERSONAL INJURY.

EXTREME CARE MUST BE TAKEN

-@REMOVE REAR COVER ­UEIGHT SEGMENTS
MUST BE INSTALLED
PER INSTRUCTIONS
CONTAINED THEREIN
BEFORE ATTEMPTING
TO UNLATCH LID.

A%

;,,, ::&

‘{

”

@ ROLL UNIT OFF

PALLET ONTO RAMP

ORIENT CASTERS IN SlOEWAYS
POSITION.
SLIGHTLY 8 KNOCK OUT

JIUBSER PADS (2). -

TYPICAL BOTH SIDES

RAISE SIDE

EITHER SIOE

PROP UP 4 RAMP FOR EACH
CASTER ON THE SELECTEO SIDE.

1 REMOVE ACCESSORY

f-0

BOXES FRON FRONT.

5 REMOVE 2’BOLTS

0

MARKED “A” TO
RELEASE FRAME
AFTER INSTALLING

WEIGHT S

EGMENTS.

INSERT 6TH &

7TH SEGMENT

I

C3J INSERT 4Tti 8

\

\

\

Y

Y \ .

5TH SEGMENT

2 INSERT 2ND &

0

3RD SEGMENT

' 9

.,I

--(~)INsE

SEGMENT

WARNING!

m EACH

18 LBS.
m ALL SEGMENTS ARE
m ALL SEGMENTS MUST BE INSTALLED AND

SECURED
TO UNLATCH

WEIGHT SEGMENT WEIGHS

(8.1 KG> - HANDLE WITH CARE.

IDENTICAL.

IN

THE FRAME BEFORE ATTEMPTING

LID.

APPROXIMATELY

RT IST