Henny Penny 520 Operation Manual

.

UCTI This section provides procedures for the replacement of the

various parts used within the pressure fryer. Before replacing
parts, refer to the troubleshooting section of this manual. It
will aid you in determining the cause of the malfunction.

WARNING

I

Place power switch in the OFF position, shut off power
at the fuse or breaker box. Failure to do so could result
in electrical shock.

1. Remove two 318” nuts from bottom of side panel,

2. Using a straight blade screwdriver, gently pry side panel
straight up.

3. Slide side panel from unit.

I

Place power switch in the OFF position, shut off power
at the fuse or breaker box. Failure to do so could result
in electrical shock.

Step lb

1. Remove four screws securing control panel to unit and
also thermostat knob.

2. Unplug the nine pin connector.

3. Remove two wires from thermostat (wire number 13 &

16) and remove control panel.

Place power switch in the OFF position, shut off power
at the fuse or breaker box. Failure to do so could result
in electrical shock.

1. Follow steps 1, 2 and 3 in

emoval of Control Panel.

emove two screws from the buzzer coil bracket.

‘”

.,,,*i

move screw mounting buzzer coil to bracket.

4. Cut wires on old buzzer. (Note: Mark wires before
cutting.)

5. Install new buzzer and splice cut wires.

Place power switch in the OFF position, shut off power
at the fuse or breaker box. Failure to do so could result
in electrical shock.

1. Follow steps 1, 2 and 3 in Removal of Control Panel.

2. Unplug wires from old timer switch. (Note: Mark wires
before unplugging.)

3. Loosen the 9116” retainer nut behind timer switch.
Remove front retainer nut of timer switch and install new

4.

switch.

Place power switch in the OFF position, shut off power
at the fuse or breaker box. Failure to do so could result
in electrical shock.

2

1. Follow steps 1,

and 3 in Removal of Control Panel.

2. Remove the two screws securing motor to timer.

3. Cut wires on old motor. (Note: Mark wires before cutting.)

4. Install new motor and splice cut wires.

Place power switch in the OFF position, shut off power

at the fuse or breaker box. Failure to do so could result

in electrical shock.

1. Follow steps 1, 2 and 3 in Removal of Control Panel.

2. Unplug wires from old power switch. (Note:

ark wires

before removing.)

3. Depress retainers on rear of switch and push switch out
towards front of control panel.

. Install new power switch.

2a

Place power switch in the OFF position, shut off power
at the fuse or breaker box. Failme to do so could result

in electrical shock.

1. Follow steps 1, 2 and 3 in Removal of Control Panel.

2. Remove two 3/V nuts securing thermostat bracket to
control area.

3. Remove two screws holding thermostat to bracket.

4. On the inside of pot, loosen screws on bracket securing
thermostat bulb.

emove 11116” nut from pot wall and remove thermostat.

6. Install new thermostat in reverse order.