Please read this operating instruction
carefully before using your Retevis
RT30 two way radio, including the
part on Product Safety and RF Energy
CAUTION
Exposure Compliance
Product Inspection
Before initial use, please check if the product inside
the box is in good condition or not. If there are any
signs of damage or missing parts, please feel free
to contact the carrier or the seller.
Item Included
Walkie Talkie
Belt Clip
User’s Guide
Quantity(Pcs)
2
2
1
Radio Parts and Controls
Microphone
LED Indicator
On/Off Power
Button
Call Tone
TALK Button
Speaker
Specification
TECHNICAL PARAMETERS
Operating voltage
Operating temperature range
Overall dimensions
Weight
Rf power
Working Frequency
467.5625MHz
Frequency
3.6~4.5v
-20℃~50℃
119*48*35mm
96g
0.5W
DCS
Installation
How to assemble and remove the belt clip
Slide the clip into the slot on the back of the radio
until it is snapped into place.
-To remove
Gently pull the lock tab, and then push up the belt
clip to remove it from the radio.
How to install or replace batteries
Make sure the radio is turned off;
Remove the belt clip;
Slide and lift the battery compartment cover;
Insert 3 AAA batteries with correct polarity into per
radio;
Close the battery cover and attach the belt clip.
(Note: Please remove the batteries if the units are
not used for a long time)
1
D306N
Pic 1 Pic 2 Pic 3
Operation
How to turn on/off the radio
• Press and hold (On/Off power button) for three
seconds. A short audible beep and a flash of the
LED indicator shows that the radio is on;
• To turn off the radio, you need press and hold until
an audible beep is heard.
Receiving
The radio is ready to receive signals when it is turned
on and no transmitting is made. The LED indicator
glows green when signals are being received.
Transmitting
• To talk to another person, press and hold “TALK”
button. The LED indicator glows red when the radio
is transmitting.
• Please speak directly to the microphone and keep
it 2 inches from your mouth to get maximum clarity.
• Release the button when you finish talking.
Call Tone
• Allow you to transmit a tone to other radios in your
group to alert them that you want to talk or you’ve
finished talking.
• When the radio is on, press once to send a call
alert. Then all the other radios operating on the
same channel and within the communication range
will receive it. (Note: There is only one call tone
available on this unit)
TOT(Time-out Timer)
The radio will automatically stop transmitting when
the "TALK" button is held for 180 seconds.
Automatic Turn off
The radio will automatically power off after 30 minutes
of inactivity.
Guarantee
Remarks:
1.This guarantee card should be kept by the user,
no replacement if lost.
2.Most new products carry a two-year manufacturer’s
warranty from the date of purchase. Further details,
pls read http://www.retevis.com/after-sale/
3.The user can get warranty and after-sales service
as below:
• Contact the seller where you buy.
• Products Repaired by Our Local Repair Center.
4.For warranty service, you will need to provide a
receipt proof of purchase from the actual seller for
verification.
2