HEMCO 24015, 24910 Installation, Operation & Maintenance Manual

Phone [phone]
Fax. [phone]
Email [e-mail]

HEMCO Corporation
711 S. Powell Road
Independence MO, 64056
MM-24015-24910.04.17

Visit www.HEMCOcorp.com Call Toll Free: [phone]

Lab Planning Solutions

HEMCO

R

Other HEMCO Products

UniFlow LE

UniFlow SE AireStream

High Performance

Energy Effi cient

Laboratory Fume Hoods

UniFlow CE

UniFlow LE FM

Safety Equipment

NSPE

Scientifi c Equipment
and Furniture Association

SEFA

ASME

American Society of
Mechanical Engineers

National Fire
Protection Association

NFPA

AEE

Association of
Energy Engineers

Made
In The
U.S.A.

Installation, Operation, Maintenance Manual

Ductless Table Top Canopy Hoods

Model Numbers 24015, 24910

Phone [phone]
Fax. [phone]
Email [e-mail]

HEMCO Corporation
711 S. Powell Road
Independence MO, 64056

Visit www.HEMCOcorp.com Call Toll Free: [phone]

Lab Planning Solutions

HEMCO

R

The HEMCO Table Top Canopy Hoods are shipped palletized, fully cartoned, padded and wrapped for
maximum protection and ease of handling. If damaged call the adjuster for the delivering carrier
promptly and notify HEMCO at:1-816-796-2900.

• Upon receiving, inspect for crate damage and possible concealed damage that may have occurred in
transit. Save all delivery receipts and crating materials. If damaged call the adjuster for the delivering
carrier promptly and notify HEMCO at 1-816-796-2900.

• When ready to install Table Top Canopy Hood, carefully lift from pallet and set on work surface in
proper location.

Your Table Top Canopy Hood has been assembled, wired, and tested at the factory, and is ready for set
up and operation. Please read through these instructions before beginning setup.

1. Hood Location

A. Choose a work area away from heavy traffi c and cross drafts. As excessive air movement will ad­versely aff ect the hoods ability to contain fumes.
B. Place the hood on a level, stable surface appropriate for use with your experiments.

2. Operation

• Plug hood 8’ power cord into modular receptacle on rear of fume hood and into 115 Volt outlet of a 15
ampere or greater electrical service.

• Turn on power switch.

• Your hood is now ready for use.

Electrical socket (back of Hood) Cord inserted into Electrical Socket

2

HEMCO

Laboratory Planning Solutions

www.HEMCOcorp.com

[e-mail]

Fax [phone]

Tel [phone]

HEMCO Corporation
711 South Powell Road
Independence, MO 64056

R

Notes:

7