Heatmiser Boost Instruction Manual

Boost – LED/button indication Installing the Boost

RF Repeater LED’s

(RX TX Comms)

Power

status

LED

Pairing buttons

Mesh Repeater

LED’s

(Link )

• Using a small screwdriver,

slightly loosen the screw

located at the base of

the Boost. You can then

carefully separate the front

panel from the back plate.

• Position the Boost back

plate on the wall, fixing

into place using the

screws provided.

• Terminate the cables to the

Boost as shown in the

wiring diagram (section 6).

• Mount the front panel onto

the back plate, tighten the

retaining screw on the base.

• Switch on the power

supply, the power LED

will illuminate.

Rev 1.0

Model: Boost

Want More Information?

PDF FAQ VIDEO

Call our support team on: [phone]
Or view technical specifications directly on our website:

www.heatmiser.com

Twitter: @heatmiseruk Facebook: facebook.com/thermostats

1 2

Boost Wiring Diagram

6

To reset the Boost, follow these steps;

Press and hold the connect button for 10 seconds.

The red LED on the Boost will now flash.

Release the button, once the LED has stopped flashing, the reset
procedure is complete.

Factory Resetting the Boost

5

Using the Boost with the Wireless Series system Using the Boost with the Neo Mesh system

3 4

The Heatmiser Boost is a repeater designed to extend the
communication distance of the Wireless 868MHz thermostats/UH8-RF
wiring centre.

The Boost repeater requires 230v Live & Neutral supply.

The Boost does not need to be paired to any devices on the system,
the Boost only requires a 230v power supply.

The repeater will detect any signals that are being transmitted, and
boost this onto the receiver.

The Heatmiser Boost is an alternative repeater to the neoPlug, designed
to extend the communication distance between neoStats.

Any device that requires the Boost repeater to communicate with
the neoHub, must be paired after the Boost repeater is paired to
the system.

The Boost repeater needs to be paired to the neoHub, via the App.

To add the Boost repeater to your system, select Manage Zones > Add
Repeater from the global menu in the App.

230v SUPPLY
3AMP

LEN