HeathCo WRC6032TX Users Manual
Outdoor Wireless Motion
Sensor
This manual includes operating instructions for a variety of remote controlled products.
All products work on the same principle and use the same code setting information.
Please read all instructional information and note any specifi c information pertaining to
your particular product.
• Products are UL/cUL and/or FCC/IC tested and approved.
• Operational range of up to 100 feet.
®
Heath
/Zenith wireless lighting controls are designed to work together. Simply
determine which transmitter(s) you would like to have control which receiver(s)
and set the code setting to match.
FEATURES
ENGLISH
Note: Most single system installations will not require any
change to the code setting. Transmitter(s) and receiver(s)
must have the same code and group setting to work together.
Switches 1 through 3 set the code. Switch 4 sets the Group
(A or B). See page 2 for switch locations.
( – Indicates Position of Switch)
CODE SETTINGS
Example 1 - Code Settings, System 1
(Factory Setting)
Transmitter(s)/
Receiver(s) Code
Group “A”
Transmitter(s)/
Receiver(s) Code
Group “B”
Example 2 - Code Settings, System 2
Note: When operating more than one system independently of each
other, set each system to a different code. There are 8 codes available by changing the settings of switches 1 through 3.
Transmitter(s)/
Receiver(s) Code
Group “A”
DRAFT COPY
© 2007 DESA Specialty Products™ 598-1302-00
CODE SWITCH LOCATIONS
ON
Code
Switches
Outdoor Wireless Motion Sensor
DETECTCODES
DAY
1 2 3 4
NIGHT
NIGHT
ONLY
Note: The “X” has been placed on the
switches to help clarify the code settings
1 2 3 4
on the previous page.
Close-Up of Typical Code Switch
(Factory Default Setting is Off)
DRAFT COPY
2 598-1302-00
Loading...