HeathCo 61WDB97TX User Manual

Wireless Accessory
Doorbell Button

SL-6197

The Heath/Zenith Wireless Accessory Doorbell
Button works with existing U, V, W channel or
Heath/Zenith jumper or dip switch doorbells.

• Battery powered transmitter- No wires to run.

• Channels are selectable to allow more than one
doorbell set in the same house.

PRELIMINARY

598-1078-00 © 2000 Heath Co., a Div. of DESA International

1. Open the transmitter button case. Insert a

flat blade screw driver into notch on bottom,
push in on the tab, and twist the screwdriver.

2. Set the doorbell button jumpers to match

the chime receiver channel. This button

works with channel U, V or W or jumper and
dip switch receivers. The doorbell button is
ready to use for channel "U".

Heath/Zenith reserves the right to discontinue and
to change specifications at any time without notice
without incurring any obligation to incorporate new

features in previously sold products.

-2-

Set the jumpers 1 thru 7 to match the chime
receiver. For receivers with switches: jumper on

for switch up, jumper off for switch down. For
channels V or W insert the jumpers shown below.

For chimes with front and back-door sounds,
insert doorbell button jumper 8 for back door
sound, remove jumper 8 for front door sound.

This button does not work with channels X, Y or Z.

"U"

"V"
"W"

1 2 3 4 5 6 7 8

Front/Back Door

Channel Jumper Settings

-3-

Bottom of Open
Doorbell Button