HeathCo 61RWRC32TX User Manual

BATTERY

Wireless Indoor

Models SL/TT-6132

and Outdoor

Remote Control

Features

• Add switched outlets with the convenience of operation from a
single hand-held transmitter.

• Includes one indoor/outdoor module & one indoor module.

Transmitter Operational Instructions

Note: You will need to buy a 9-volt alkaline battery for the remote

control. In typical use, this battery will last about one year.
Remove the battery during extended periods of non-use.

1. Install the 9-volt battery. Remove the cover from the back of

the transmitter by pressing on it with your thumb and sliding it
off as shown. Plug in the battery and slide the cover back onto
the transmitter.

Cover

SL-6139

Transmitter

© 2001 DESA International 598-1004-03

Indoor/Outdoor

Module

SL-6136

Indoor Module

Page 2

Indoor/Outdoor Module Operation

1. Plug in Indoor/Outdoor Module. Remember, the Indoor/

Outdoor Module requires a grounded outlet. If you do not have
a grounded outlet, you may want to contact an electrician to
upgrade your electrical system. If you are using the Indoor/
Outdoor Module outdoors, see extra precautions below.

Precautions When Using the Indoor/Outdoor Module

• The Module must be oriented with the power outlet down to

prevent rain from entering the unit. See the illustration below.

Hole to

hang unit

• Hang the module on a nail or screw as shown.

There is a hole in the back for this purpose. DO
NOT allow it to hang by the cord.

• Note in the illustration that the module is lo-

cated below the wall outlet. This is to prevent
rain from running down the cord into the wall
outlet.

• Note: The National Electrical Code and Cana-

dian Electrical Code (and most local codes)
require that outside outlets be protected by a
Ground Fault Interrupter (GFI).

2. Plug in the devices you wish to control.

Caution: Do not exceed the maximum load specifications (see

page 3).

3. To check operation, press button on the left side of transmitter

(see icon). The light/appliance should turn on immediately.
Important: Wait at least 3 seconds after you press the button
before pressing it again to allow the transmission to be com­pleted.

Power

Outlet

598-1004-03