Heat & Glo WH-STAT Installation and Operation Instructions

WH-STAT WALL THERMOSTAT KIT

- Installation and Operation Instructions -

CHECK CONTENTS OF SHIPPING CARTON

Compare contents of carton in Figure 1 with the actual
parts received. If any parts are missing or damaged, con­tact your dealer before beginning installation. DO NOT in­stall a damaged Wall Thermostat Kit.

WARNING

Shock Hazard.
Explosion Risk.
Do NOT wire 110V-120V to valve.
Do NOT wire 110V-120V to wall switch.

NOTE:For installing and selecting the proper thermo­stat location, refer to instruction manual provided in
this kit.

INSTALLING ELECTRICAL WIRING FROM
WALL THERMOSTAT T O FIREPLACE:

1. Run low voltage 2- conductor wire from the wall ther­mostat into the base of the fireplace (behind grille). Find
the male and female connectors provided and attach
them to the ends of this wire.

Thermostat

Wire

Male
Connector

Female
Connector

Figure 1

2. Find the red and brown pigtail wires labeled "THER­MOSTAT", "REMOTE", or "WALL SWITCH", located
in the base pan of the fireplace.

OPERATING PROCEDURES

1. Follow the lighting instructions section in the fireplace
instruction manual. Be certain that the pilot light is on
and the gas control valve is in the "ON" position.

2. Set the wall thermostat to the desired setting.

Printed in U.S.A. Copyright 2005
Hearth & Home Technologies Inc.
20802 Kensington Boulevard, Lakeville, MN 55044

REPLACEMENT P ARTS AND
CUSTOMER SERVICE

Replacement parts and customer service may be obtained
through your dealer.

146-900C 5/05