Heat & Glo Studio 24 Doors Installation Instructions

Studio 24 Doors

- Installation Instructions -

Instructions:

1. Remove door from box.

2. Remove corner spacers from door .

3. Ensure that decorative caps are hand tight (see

Figure 1).

Figure 1

5. Use 3/8 inch nuts to attach hanging brackets (with shims

if necessary) to the door studs (see Figure 3).

Figure 3 Attach hanging bracket to door

6. Hang door assembly onto fireplace such that hang-

ing brackets engage J-hook slots of fireplace (see Figure 4).

TRIM TO HERE FOR NO ADDITIONAL FINISHING MATERIAL

Figure 2 Hanging Bracket

4. Hanging bracket may be trimmed for different finishing

materials. The brackets are set for 3/4 inch finishing material placed over the non-combustible header.

• Trim the support leg at the first notch for 1/2 inch finishing material.

• Trim at the third notch for no additional finishing materials. (There is no need to trim the hook portion of the bracket). See Figure 2.

• Use the included spacer shims to adjust the spacing to approximately 1/16

inch of space between the front

and the finishing material.

J-HOOK

SLOT

Figure 4

Service Parts List

DESCRIPTION SERVICE PART NO.

Glass 2077-147 Cap and Barrel Assembly 2077-013 J-Hook Bracket 2077-135 Spacer Shim 2077-175

2077-902B 3/06