Heat & Glo LUX60-TMPLT Installation Instructions
Installation
Instructions
Models:
LUX60-TMPLT
Rock Template for the LUX60
This rock template been tested for use with LUX60. Check with your local building code agency before you begin installation to ensure compliance with local codes, including the need for permits and follow-up inspections. If you encounter
any problems regarding code approvals, or if you need clarifi cation of any of the instructions contained here, contact your
Hearth & Home Technologies Inc. dealer. For the dealer nearest you, please visit www.heatnglo.com.
The LUX60-TMPLT must be used when the decorative fi nish to be used is greater than 1 in. (25 mm) thick (i.e. rock, brick,
etc.) to ensure proper air fl ow through the surround and to provide an attractive fi nished transition from the wall to the sur-
round.
CAUTION! Risk of Cuts, Abrasions or Flying Debris. Wear protective
gloves and safety glasses during installation. Sheet metal edges are sharp.
• Attach top template piece (8.44 in./214 mm wide)
- Use two screws from the fastener pack.
- Secure template piece to the front frame of appliance.
See Figure 1.
• Repeat for sides and bottom.
- Overlap pieces by 1/8 in./3 mm so no gaps are
visible.
• Use drywall screws (not provided) and the pre-drilled
holes to further secure the template to the wall.
Fasten to wall
x
x
Rock
Template
x
x
with 8
drywall screws
8.44 in.
x
x
• Decorative wall fi nishing material may now be applied to
wall down to the 1/2 in. lip on the template pieces.
WARNING! Risk of Fire! DO NOT restrict the 1 in. air
gap with any facing material!
After the decorative wall facing is set, the SSF-LUX-BX
Surround Kit may be installed. See the installation instructions included with the surround kit.
Sheetrock
Wood Framing
1/2 in. (13 mm)
Cement Board
Steel Stud Assy
Top Rock
Template
Air Flow
1 in. (25 mm)
air gap
Fasten template
to frame with
8 screws
Figure 1 Install Rock Template
Heat & Glo • LUX60-TMPLT Rock Template • 4062-135 • Rev A • 05/09
x
x
6.81 in.
SSF-LUX-BK
(shown for
reference only)
1/2 in. (13 mm)
Figure 2 Sheet Rock plus Wall Finishing over 1 in./25 mm Thick
1
Loading...