Heater Craft 700S User Manual

WASH DOWN SYSTEMSWASH DOWN SYSTEMS

Installation and

Owners manual

For the following wash down model number:

700S Series

Approximate Installation Time: 2 Hours

Tools Required:

#2 Phillips Screw Driver; Power Drill; 7/64" Drill Bit; Jig Saw; 1" Hole Saw;

Hose Cutter; Wire Crimper; Teflon Plumbers Tape; Marine Sealant; Pencil.

INSTALLATION AND OWNERS MANUAL

Improving life on the water since 1987

cover

Operation Warning:

Carbon Monoxide (CO) is emitted from the engines' exhaust. Do not run the engine without proper
ventilation. Don not run the engine in a confined space or where back drafting may occur. For more
information about carbon monoxide refer to ABYC standards: A-7, T-22(1), and TH-23; or contact one of
the following agencies.

American Boat and Yacht Council, Inc   410-956-1050

United States Coast Guard    754-441-3287
 www.uscgboating.org

National Marine Manufacturers Association  313-946-6200
 www.nmma-medialink.com

Boat U.S.      703-823-9550
 www.boatus.com

Heater Craft
6672 Boekel Road
Rathdrum, ID 83858
Attn: Technical Support
[phone]
Fax [phone]
www.heatercraft.com

1

Heater Craft 2 Year Limited Warranty

Heater Craft warrants your shower/wash down* system to be free from defects in
material and craftsmanship under normal use and ser vice by the original consumer
purchaser for a period of (2) two years from the date of purchase. This limited warranty
does not apply if the system has been damaged by accident, improper installation,
unreasonable use, lack of proper maintenance, unauthorized repairs or modifications, or
causes not arising from defects in materials and craftsmanship.

Heater Craft's obligation under this warranty are limited to repair of the product at
Heater Craft's production facility, or the replacement of the product at Heater Craft's
option and at Heater Craft's expense. Any expense involved in the removal,
reinstallation, or transportation of the product is not covered by this warranty. Prior to
return of any product to Heater Craft customer must first call Heater Craft customer
service [phone] and request a return authorization number. This number must
be marked on exterior of carton for easy identification. Warranty product received at

Heater Craft without a Return Authorization Number may be returned at expense of
sender.

Send defective product to:

Heater Craft
6672 Boekel Road
Rathdrum, ID 83858
Attn: Warranty Dept.
www.heatercraft.com

Postage must be prepaid, and the original dated proof-of-purchase must be included.
Heater Craft will not be liable for any damages sustained in transport due to improper
packaging or handling. The acceptance by Heater Craft of any product returned shall not
be deemed as an admission that the product is defective or in any violation of any
warranty.

This warranty is Heater Craft's only express warranty of this product. No implied warranty
shall extend beyond (2) two years from the date of the original consumer purchase.
Heater Craft will not be liable for any damages, for loss of use of this product, nor for
any consequential damages, costs or expenses.

Some states do not allow limitations on how long an implied warranty lasts or the
exclusion of incidental or consequential damages, so the above limitations and
exclusions may not apply to you. This warranty gives you specific legal rights and you
may also have other rights not mentioned here that vary from state to state.

*Any shower or wash down product subjected to direct saltwater use will have a (1)
one year warranty. Direct saltwater use is defined as having saltwater circulating
through the shower or wash down unit.

2