Heater Craft 450 User Manual

HEATER CRAFT

YAMAHA RHINO 450
INSTALLATION INSTRUCTIONS
& OWNER’S MANUAL

FOR 1102H SERIES CAB HEATERS

!!!CAUTION: AVOID INJURY!

SHUT OFF ENGINE AND ALLOW TO COOL.
THE RADIATOR WILL BE HOT AND CAN BURN SKIN.
BUILT UP PRESSURE MAY CAUSE AN EXPLOSIVE RELEASE
OF COOLANT WHEN REDIATOR CAP IS REMOVED.
DO NOT REMOVE CAP UNLESS THE ENGINE IS COOL TO THE
TOUCH WITH BARE HANDS, THEN SLOWLY LOOSEN CAP
AND RELEASE PRESSURE. THEN REMOVE CAP.

KIT CONTENTS:

QTY. 1 HEATER UNIT
QTY. 2 MOUNTING BRACKETS
QTY. 1 OVAL VENT

QTY. 4.00” OF TRIM RUBBER
QTY. 8’ OF 2.00” VENT HOSE
QTY. 2 VENTS (2.00” Round)
QTY. 6’ OF 3/4” HEATER HOSE
QTY. 1 3/4” COUPLER
QTY. 1 3/4” FILL TEE

QTY. 1 SPRING HOSE GUARD
QTY. 7 #10 HOSE CLAMPS

QTY. 10 8.00” WIRE TIES
QTY. 6 4.00” WIRE TIES

QTY. 1 FAN SWITCH
QTY. 4 FEMALE SPADE CONNECTORS
QTY. 2 5/16” RING TERMINALS
QTY. 1 TAP CONNECTOR
QTY. 2 BARREL/BUTT CONNECTORS
QTY. 1 FUSE HOLDER AND 10A FUSE
QTY. 8’ SPLIT LOOM
QTY. 8 #8-32 X 1/2” BRACKET SCREWS
QTY. 3 #12 X 1.00” SELF TAPPING SCREWS
QTY. 1 OVAL DEFROSTER GRILL

QTY. 1 INSTALLATION INSTRUCTIONS/OWNER’S

MANUAL.

READ INSTRUCTIONS BEFORE STARTING

MOUNT HEATER UNIT:
Install brackets as shown using provided #8-32 screws
provided.

Remove the battery box cover and loosen the four (4) retaining
bolts.
Slide open ended heater mounting bracket (passenger side)
under battery box and secure by tightening the battery box
retaining bolts. (vent outlets will face cab)

Secure the opposite (driver’s side) bracket using the #12 x

1.00” self tapping screws through the existing holes in the top

of the square tube rail.