Heartland 1903, 9200, 6210, 2603, 7200 User Manual

HEARTLAND

1050 Fountain St N. Cambridge, Ontario, Canada N3H-4R7 Phone: [phone]

Cabinet Installation Instructions
For Gas, Electric, Combination and Wood
Stoves

For 48" Models: 7200, 6200, 6210, 5200, 5210,

30" Models: 9200, 8200, 8210, 4200, 4210

Wood Stove Models: 1903, 1902, 2603, 2602

Please Read These Instructions Thoroughly
Before Installing Your Cabinet.

English Edition

Note: If you plan to vent your exhaust hood to the outside, please refer to your range's Owner

Installation and Operating Instructions under Exhaust Hood section before completing this
installation. Note: maximum run of ducting is 25 linear feet (subtract 5' per 90 deg

elbow added to the exhaust line and 2.5' per 45 deg elbow)

Before proceeding, check for damage that may have occurred during shipping. If the
contents are damaged, inform the freight company or your dealer immediately!

Please refer to the "Installation and Operating Instructions" manual to complete your range installation

101507
#1719

© 2007 AGA-HEARTLAND

T ABLE OF CONTENTS

1. Removing Cabinet from Box........................................................... 2

2. Assembly of Cresting panel............................................................ 3

3. Installing Cabinets for Electric and Combination Stoves ............... 4

4.Installing Cabinets for Gas Stoves ................................................ 5

5. Installing Cabinet for Wood Stoves................................................ 6

6. Venting .......................................................................................... 7

7. Connecting Power to the Cabinet for

Electric and Combination Stoves ....................................................... 8

8.Connecting Power to the Cabinet for Gas Stoves .......................... 9

1

Please read through these instuctions before installing the cabinet on the stove base.

TWO PEOPLE ARE REQUIRED TO DO THE INSTALLATION

Cardboard
corners

Lift here

Cardboard
Cross brace

Small boxcontains:

- hardware package

- deflector ( not included with woodstove
cabinets.)

- 3 1/2"x10 exhaust adapter ( not included with
woodstove cabinets.)

The cabinet comes assembled , except cresting panel (see next page for assembly
instructions) and only requires attachment (installation) to the base of the stove. Further
assembly of optional venting of the exhaust fan may be required.

Before removing the cabinet assembly from the box, make sure you :

- Remove the 4 cardboard corners.

- Remove small box and its contents.

- Remove the cardboard cross brace.

- Remove the plastic wrapped cresting panel.

Cresting panel
packed in plastic
bubble wrap

Fig. 1

2