Hearth and Home Technologies ODVGF-36, DM1031, DM1039, DM1242, DM1036 User Manual
...
Installation
tm
Instructions
Models:
DM1031, DM1036, DM1039, DM1042, DM1242
DM1736, DM1742, ODVGF-36, ODVGF-42
Bi-fold Glass Doors
These bi-fold glass doors have been tested for use with specic Hearth & Home Technologies replaces and are listed as
replace parts. Refer to the replace installation instructions/owner’s manual for the correct accessories to be used. Check
with your local building code agency before you begin installation to ensure compliance with local codes, including the need
for permits and follow-up inspections. If you encounter any problems regarding code approvals, or if you need clarication
of any of the instructions contained here, contact your local Hearth & Home Technologies dealer or visit www.hearthnhome.
com
Note: An arrow () found in the text signies change in content.
CAUTION
Sharp Edges
• Wear protective gloves and safety
glasses during installation.
1
2
WARNING
Fire Risk
• Close rescreen when burning replace.
• Do not use rescreen or glass doors to
hold burning material in replace.
Firescreen controls sparks.
Glass may break or burning material may
roll out.
Item # Description Qty.
1 Bi-fold Door Assy., LH 1
2 Bi-fold Door Assy., RH 1
Note: Before burning the replace for the
rst time, wipe the trim with a clean, dry rag to
remove all smudges and ngerprints. Failure
to do so will cause smudges and ngerprints
to be burned into the nish of the trim.
Note: An ar row ( ) found in the text
signies change in content.
WARNING
Fire Risk
Smoke Risk
• Doors must be fully opened or fully closed
when operating replace.
Partially opened doors may draw ame, smoke
or heat from replace.
Hearth & Home Technologies Inc. • DM Doors • 31178 Rev J • 11/10
1
Note: Glass doors aid in the prevention of loss of
room heat through an open chimney.
A. For Use on Reveal Series Appliances
• Door installation on the RBV4236 or RBV4842 requires
longer pins. The longer pins and screws to attach them
are located on the valve bracket of the appliance. See
Figure 1.
Screws for DM Door Installation
Figure 1 Pins & Screws for DM Door Installation - Reveal
• Remove the shorter door pins using a phillips screwdriver
and replace them with the longer pins. See Figure 2.
B. For Use on Odvilla-36, Odvilla-42
Outdoor Woodburning Fireplace
• Remove the screws from the door track area before
placing the door tracks on the replace. Once in place
reinsert screws.
C. For All Installations
• Fold one pair of doors. Insert the pin into the large hole
located at the bottom outside corner of the replace
opening. Tilt it toward the center of the replace such that
the pins clear the top door track edge. Slide the pin into
the top door track until the pin snaps into the hole in the
spring clip.
• Doors may be adjusted by repositioning the spring clips
in the screw slots, by loosening the screws and then
retightening. Do not overtighten the screws!
• If removal becomes necessary, depress the spring clips
located in the upper corners of the replace and tilt the
doors towards the center of the replace opening.
Figure 2 Install Pins
2
FULLY OPEN
CORRECT
FULLY CLOSED
CORRECT
Figure 3 Proper Operation of Bi-fold Glass Doors
PARTLY OPEN
INCORRECT
PARTLY CLOSED
INCORRECT
Hearth & Home Technologies Inc. • DM Doors • 31178 Rev J • 11/10
Loading...