The warning decal shown here has
been applied in the location shown. If a
decal is missing or illegible, see the
front cover of this manual and
request a free replacement decal.
Apply the decal in the location shown.
Note: The decal may not be shown at
actual size.
HEALTHRIDER is a registered trademark of ICON IP, Inc.
2
IMPORTANT PRECAUTIONS
WARNING: To reduce the risk of serious injury, read all important precautions and
instructions in this manual and all warnings on your elliptical exerciser before using your elliptical
exerciser. ICON assumes no responsibility for personal injury or property damage sustained by or
through the use of this product.
1. Before beginning any exercise program,
consult your physician. This is especially
important for persons over age 35 or persons with pre-existing health problems.
2. Use the elliptical exerciser only as described
in this manual.
3. It is the responsibility of the owner to ensure
that all users of the elliptical exerciser are
adequately informed of all precautions.
4. The elliptical exerciser is intended for
home use only. Do not use the elliptical exerciser in a commercial, rental, or institutional
setting.
5. Keep the elliptical exerciser indoors, away
from moisture and dust. Place the elliptical
exerciser on a level surface, with a mat
beneath it to protect the floor or carpet.
Make sure that there is at least 3 ft. (0.9 m) of
clearance in the front and rear of your elliptical exerciser and 2 ft. (0.6 m) on each side.
6. Inspect and properly tighten all parts regu-
larly. Replace any worn parts immediately.
8. The elliptical exerciser should not be used
by persons weighing more than 250 lbs.
(113 kg).
9. Wear appropriate clothes while exercising;
do not wear loose clothes that could become
caught on the elliptical exerciser. Always
wear athletic shoes for foot protection while
exercising.
10. Hold the handlebars or the upper body arms
when mounting, dismounting, or using the
elliptical exerciser.
11. The pulse sensor is not a medical device.
Various factors may affect the accuracy of
heart rate readings. The pulse sensor is
intended only as an exercise aid in determining heart rate trends in general.
12. Keep your back straight while using the
elliptical exerciser; do not arch your back.
13. Over exercising may result in serious injury
or death. If you feel faint or if you experience
pain while exercising, stop immediately and
cool down.
7. Keep children under age 12 and pets away
from the elliptical exerciser at all times.
14. When you stop exercising, allow the pedals
to slowly come to a stop.
3
BEFORE YOU BEGIN
Thank you for selecting the new HEALTHRIDER®15.5
S elliptical exerciser. The 15.5 S provides a selection
of features designed to make your workouts at home
ore effective and enjoyable.
m
or your benefit, read this manual carefully before
F
using the elliptical exerciser. If you have questions
after reading this manual, please see the front cover
Upper Body Arm
Pulse Sensor
of this manual. To help us assist you, note the product
model number and serial number before contacting
us. The model number and the location of the serial
umber decal are shown on the front cover of this
n
manual.
Before reading further, please familiarize yourself with
the parts that are labeled in the drawing below.
Fan
Console
Water Bottle Holder*
Pedal
Pedal Disc
*Water bottle is not included
4
ASSEMBLY
M10 Split
Washer (45)–2
M10 Locknut
(33)–6
M10
Washer (35)–2
M8 Locknut
(38)–4
M8 x 45mm Button Bolt (50)–4
M10 x 27mm
Patch Screw (40)–2
M10 x 75mm Carriage Bolt (34)–4M10 x 74mm Button Bolt (7)–2
Wave
Washer (69)–2
M8 Split
Washer (28)–4
Upper Body Arm
Washer (55)–2
M8 x 25mm Patch
Screw (56)–2
M8
Washer (71)–4
Console Screw
(59)–4
M8 x 52mm Button
Screw (27)–4
M10 Bolt Set (25)–2
Large Wave
Washer (76)–2
M4 x 22mm
Screw (63)–2
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove all
packing materials; do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires an adjustable wrench, a Phillips
screwdriver, and a rubber mallet.
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware
kit, check to see if it has been preassembled.
5
1.
To make assembly easier, read the
nformation on page 5 before you begin.
i
Identify the Stabilizer (9) which has round Caps
21) on the ends.
(
1
1
2
34
9
1
While another person lifts the front of the Frame
(1), attach the Stabilizer (9) to the Frame with
two M10 x 75mm Carriage Bolts (34) and two
M10 Locknuts (33).
2. While another person lifts the back of the Frame
(1), attach the other Stabilizer (9) to the Frame
with two M10 x 75mm Carriage Bolts (34) and
two M10 Locknuts (33).
21
33
2
33
9
33
1
34
3. The Console (23) requires four 1.5V D batteries
(not included); alkaline batteries are recommended. IMPORTANT: If the elliptical
exerciser has been exposed to cold temperatures, allow it to warm to room temperature
before inserting batteries into the Console. If
you do not do this, the console displays or
other electronic components may become
damaged. Remove the battery cover from the
Console, and insert four batteries into the
Console. Make sure that the batteries are ori-
ented as shown by the diagrams on the
battery cover. Then, reattach the battery cover.
3
23
Batteries
Battery
Cover
Batteries
6
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.