Haws 9037 User Manual

INSTALLATION, OPERATION

&

MAINTENANCE INSTRUCTIONS

1455 Kleppe Lane Sparks, NV 89431-6467 [phone] Fax [phone]

HAWS AG Bachweg 3 CH-3401 Burgdorf  Switzerland

Haws Mfg. Pte Lt. 2A Sungei Kadet Drive Singapore 729554

Avlis-Avenido Senador, Testonio Vilela 505 Jardim Aeroporto  Itu, S.P. 13304-550 Brasil

E-mail: [e-mail]

NOTE TO INSTALLER: Please leave this information with the Maintenance Department.

HAWS® warrants that all of its products are guaranteed against defective material or poor
workmanship for a period of one year from date of shipment. HAWS liability under this
warranty shall be discharged by furnishing without charge F.O.B. HAWS Factory any
goods, or part thereof, which shall appear to the Company upon inspection to be of
defective material or not of first class workmanship, provided that claim is made in writing
to company within a reasonable period after receipt of the product. Where claims for
defects are made, the defective part or parts shall be delivered to the Company, prepaid,
for inspection. HAWS will not be liable for the cost of repairs, alterations or replacements,
or for any expense connected therewith made by the owner or his agents, except upon
written authority from HAWS, Sparks, Nevada. HAWS will not be liable for any damages
caused by defective materials or poor workmanship, except for replacements, as provided
above. Buyer agrees that Haws has made no other warranties either expressed or implied
in addition to those above stated, except that of title with respect to any of the products or
equipment sold hereunder and that HAWS shall not be liable for general, special, or
consequential damages claimed to arise under the contract of sale.

The emergency equipment manufactured by HAWS is warranted to function if installation
and maintenance instructions provided are adhered to. The units also must be used for
the purpose, which they were intended. This product is intended to supplement first-aid
treatment. Due to widely varying conditions HAWS cannot guarantee that the use of this
emergency equipment will prevent serious injury or the aggravation of existing or prior
injuries.

NO OTHER WARRANTIES EXPRESSED OR IMPLIED ARE AUTHORIZED,
PROVIDED OR GIVEN BY HAWS.

SHOULD YOU EXPERIENCE DIFFICULTY WITH THE INSTALLATION OF THIS
MODEL, PLEASE CALL:

FOR PARTS CALL:

Model 9037 Modesty Curtain

LIMITED WARRANTY

1-800-766-5612

 website: www.hawsco.com

No. 2080217(6)

1-800-758-9378

(U.S.A. AND CANADA ONLY) MONDAY-THURSDAY: 6:00 A.M. – 4:00 P.M. PST

01/07 Model 9037 1 of 4

RECOMMENDED TOOL: 6” crescent wrench

LOCATION OF UNIT: The Model 9037 Modesty Curtain is designed to be used with all makes

of free standing and wall mounted emergency showers.

INSTALLATION PROCEDURE: Refer to installation drawing to clarify installation. Steps 1-3
refer to the Installation Drawing. Check parts lists to insure all required parts are included.

FOR FREE STANDING AND WALL MOUNTED EMERGENCY SHOWERS:

STEP ONE: Place V block (items 3) on the above overhead 1”. Then put on U bolt (item 1) over

the pipe. Place the two center pieces together into the V-block notch (as shown on drawing on
page two). Use the clamp (item 2), washers (item 5) and nuts (item 4) to hold the loop. Do not
tighten the nuts.

STEP TWO: Assemble the second U bolt/V block assembly according to the instructions in step
one. Check the drawing on page one for proper position of the curtain and tighten securely.

STEP THREE: Insert clips (item 11) into the loops (item 6) and attach the curtain (item 9) by
making sure that the pockets are in the inside. Insert one modesty gown in each pocket. Test
the closing and opening of the curtain to insure that it functions properly.

© 2006 Haws

®

HAWS

and other trademarks used in these materials are the exclusive property of Haws Corporation.

®

Corporation – All Rights Reserved

01/07 Model 9037 Page 2 of 4